查询词典 shield arm

With the air arm will plug into the console of the air interface, will be imported arm with his left arm, the arm of one end zone to pull the lateral, while fixed-arm with the location, with a cloth deduction to be fixed, connected to the power of the state , Press button to stop automatically measured, the measurement results show that after the end of measurement.

将臂带的空气插头插入主机的空气管接口，将左臂传入臂带，将臂带的一端向外侧拉，同时固定臂带的位置，用布扣加以固定，在接通电源的状态下，按下按钮自动开始进行测量，显示测量结果后测量结束。

Use: Disassembly carriage wheel fore-end control arm ball section and knuckle, the upper arm ball section and knuckle, undertake the pressing down on of arm ball section and knuckle, transverse direction lower arm ball section and knuckle, get lost horizontal stroke pull rod end ball section and knuckle, carriage wheel fore-end control arm ball section and knuckle come off come untied.

用途：拆卸车轮前端控制臂球节与转向节、上臂球节与转向节、承压下臂球节与转向节、横向下臂球节与转向节、转向横拉杆端球节与转向节、车轮前端控制臂球节与转向节的脱开。

Since there were 10 more unscreened cancer patients and 5 more cervical cancer deaths in the cytology arm than in the HPV arm and since these unscreened cancer patients predictably had higher rates of cervical cancer, more advanced stages, and less favorable outcomes, the net effect of the inclusion of the larger number of unscreened cervical cancer patients in the cytology arm was to make the cytology arm appear more like the unscreened control arm of the study.

由于在细胞学组中有10个未筛查的宫颈癌病人和5个宫颈癌死亡者，高于 HPV 组，同时因这些未筛查的宫颈癌病人预期有较高的宫颈癌发生率，更加进展的临床分期和较差的预后，因而大量未筛查的宫颈癌病人在细胞学组中，这样结果的净效应是细胞学组更像本研究中未筛查对照组。

When the large rotating arm rotates, the transmission gear is driven to rotate around the fixed gear to rotate the planetary gear, which drives in turn the small rotating arm to rotate in the direction opposite to the large rotating arm, so that the shaft of the small rotating arm reciprocates across the rotation center of the large rotating arm.

当大旋臂旋转时，传动齿轮受到驱动沿固定齿轮周转并带动卫星齿轮转动，卫星齿轮带动小旋臂作与大旋臂反向的旋转，从而使小旋臂上的固定轴随着大、小旋臂的旋转不断往复越过大旋臂的旋心作直线运动。

It is shown that the friction force and bulkhead thrust are the main factors of shield thrust setting, while the friction between the cutterhead and soil is the main factors of cutterhead torque setting. Friction force between shield and soil would make front soil of shield upheave, and subsidence of surface soil is induced by ground loss when the friction force between the cutterhead and soil results in the surface settlement asymmetrical distribution.

通过计算发现，盾构施工中盾壳摩擦和正面推力是盾构推力设置的主要因素，而刀盘与土体摩擦是刀盘扭矩设置的主要因素，盾构前方土体隆起主要由盾壳摩擦引起，刀盘摩擦作用主要引起地表沉降的非对称分布，地表沉降主要由盾尾空隙产生。

Based on a series of signal process and noise source identification techniques, especially the major noise source identification methods, such as expurgation method, sound intensity analysis, spectrum analysis vibro-acoustic correlation analysis and so on, the pass-by noise control of SC7080A and SC6360B are studied in detail. By the roadway and dais experiments, the major noise and radiating parts are identified and some economical controlling methods are made. For the SC7080A, to control the emissing noise from the intake and shell vibration of air cleaner, a intake muffler is installed between the air cleaner and intake valve. Based on the theory of Helmholtz resonator, One three-parallel-connected resonant silencer is designed and trial-manufactured. For the SC6360B, the attenuation performance of exhaust muffler in high frequency region is improved. To reduce the vibration noise of shell part, the structure of oil sump tank, exhaust manifold shield and exhaust manifold shield are analyzed and improved. At the same time, some measures, such as sound absorption, sound insulation, are taken to reduce the noise of engine surface emissivity and a sound shield is designed.

本文首先综述了目前国内外汽车加速噪声控制的现状、主要方法和技术措施，在此基础上，结合SC7080A和SC6350B汽车的车外加速噪声水平及现状，综合运用分别运行法、声强法、频谱分析法、声振相干函数法等现代噪声源识别方法，对SC7080A和SC6360B汽车进行了准确详细的车外加速噪声源识别并提出了经济可行的控制方案，针对SC7080A，主要在空气滤清器和进气阀门之间的进气管道上加装进气消声器，抑制空气滤清器壳体表面和进气口两处的噪声辐射，根据Helmholtz共振腔原理设计了三腔并联旁支型共振消声器，并进行了工程化设计和试制；针对SC6360B，主要改善了排气消声器在高频段的消声性能，对罩壳类零件进行了结构改进，降低了其表面噪声的辐射，并对发动机舱进行了吸声、隔声处理，设计了发动机隔声罩。

From describing the controlling anchor amount and shield thickness of the Kao-Tang Railway Tunnel Ⅳ class rock wall segment initial protecting shield, the article analyses the function theory of New Austria Tunneling Method initial protecting shield and its use in the flabbiness wall rock protecting.

结合铁路考塘隧道中的Ⅳ级围岩地段初期支护中的锚杆数量与喷层厚度控制，分析了新奥法初期支护的作用原理以及此类支护在软弱围岩中的应用。

Based on the sectional shield tunnels of metro in China, mechanical behavior of segment structure of shield tunnel under the different erection methods has been studied with geometric proportion of 1:12 through the simulated model tests of 3D 'ground-shield tunnel' in which joint effects of segments and mutual action effects between segments and ground are considered.

以我国城市地铁区间盾构隧道为对象，采用几何比 1/12、同时考虑盾构隧道管片接头效应和管片与土体相互作用效应，用三维土-盾构隧道相似模型试验对盾构隧道管片结构在不同拼装方式下的力学行为进行了研究，并将研究结果与梁-弹簧模型的理论分析结果进行了比较，得出的结论可为盾构隧道的设计提供参考。

This article introduced the antijamming in the NC system design,from the shield (including electric field shield ,magnetic screen and electromagnetic field shield ) designs mentions,added the absorbing circuit to the perceptual load to suppress the transient state noise to give the specify,might avoid the NC system which disturbed creates softly breakdown.

本文介绍了抗干扰在数控系统中的设计，从屏蔽(包括电场屏蔽、磁场屏蔽和电磁场屏蔽)设计谈起，对感性负载加吸收电路来抑制瞬态噪声做了详细说明，可避免干扰造成的数控系统的"软"故障。

This paper brings the method of the internal magnetic shield mainly from the principal of magnetic shield, the choice of shield material and the determination of its thickness.

主要从磁屏蔽原理、磁屏蔽材料的选择以及屏蔽层厚度确定等方面进行阐述。

World War II: Battle of Saipan - Americans take Saipan.

1944年的今天，美国在塞班战役中拿下塞班岛。

When the scorner, the rejecter of truth, has become presumptuous; when the routine of work in the various money-making lines is carried on without regard to principle; when the student is eagerly seeking knowledge of everything but his Bible, Christ comes as a thief.{DA 635.3

当讥诮和拒绝真理的人，到了任意妄为时，当追求财利者罔顾按道义经营谋利时，当学人正在兢兢业业地研究各种知识，而单把圣经丢在一边时，基督要像贼一样来临。