查询词典 regression coefficient

Wavelet multi-resolution analysis is applied to decompose the signal into multiple-level and the wavelet coefficient modules of its high-frequency components are obtained. The wavelet coefficient modules of a broken signal can be extracted by software demising. The threshold of demising is decided by the difference between the wavelet coefficient modules of a broken signal and those of a noise. The wavelet coefficient modules of the broken signal were shown in different levels, then the faults can be detected and distinguished by the integrated features of the variant levels' wavelet coefficient modules.

利用小波多尺度分解技术，将信号进行多尺度的小波分解，得到不同尺度下的信号高频分量的小波系数模值，并根据奇变信号和噪声信号小波系数模值的差异，采用软阈值去噪法，对其高频分量小波系数进行去噪处理，获取不同尺度上突变信号的小波系数模值，实现对故障的检测，并可根据不同尺度上小波系数模值的对应关系，实现对多重并发故障的区分。

Furthermore, transfer coefficient between total content and variable speciation including acid-soluble/exchangeable, reducible, oxidisable fraction of heavy metals are different. Transfer coefficient of total Cr is 0.65 in tailings area, but that of variable speciation is 0.26. In contrast with Cr,transfer coefficient of total Ni is 0.26, but that of variable speciation is 0.67. The similar characteristics on Pb and Zn in cultivated soil, namely, transfer coefficient of total Zn is high, but low for variable speciation, which is reversed for Pb. Transfer coefficient of total content and variable speciation in abandoned soil are low compared with above two fields soil, especially, variable speciation of Cu and Ni are not transported almost down soil profile.

重金属总量和活性态（包括弱酸提取态、可还原态、可氧化态）迁移率也表现出很大差异，尾矿区土壤Cr总量迁移率较高为0.65，而其活性态迁移率较低为0.26，Ni与Cr迁移特征完全相反，总量迁移率为0.26，而活性态迁移率为0.67；农田土壤中Pb总量迁移率低而活性态迁移率高，Ni与Zn特征相似，总量迁移率高而活性态迁移率相对较低；大棚地土壤中重金属迁移率均较低，Cu和Ni活性态几乎未发生向下迁移。

Single factor experiments were done with the factors including the width of protrusion and the trolley's velocity, which showed that the surface frictional coefficient decreases with the width of protrusion increasing, and doesn't change with the trolley's velocity changing, which was consistent with the results of the orthogonal experiment. A theoretical model of the horizontal projection of a corrugated bionic surface's contact area was built, which showed that the contact area's horizontal projection decreases with width and interval increasing respectively and that the ratio of the contact area's horizontal projection and the vertical load decreases with the vertical load increasing. It indicated that the surface frictional coefficient decreases with the above three factors increasing respectively. Finite element modeling and analysis of interactions of a plate and soils was done using ANSYS, which showed that the plate frictional coefficient is little relative to soil elastic modulus and decreases with vertical surface pressure and that trolley's pull and vertical displacement of bionic surface's control pilot keep constant almost during the plate being pulled. Finite element modeling and analysis of interactions of a corrugated bionic surface and soils was done using ANSYS, which showed that surface frictional coefficient is little relative to soil elastic modulus and decreases with bionic surface's structural parameters and vertical pressure increasing. However, the three factors all didn't affect the surface frictional coefficient remarkably on the condition of 90% dependability. For the first time, bionic surfaces were applied to screw piles, which formed bionic screw piles, and the contrast experiments showed the bionic screw pile had certain resistance-decreasing effects.

建立了波纹型仿生曲面与土壤的接触面积的水平投影的理论模型，表明接触面积的水平投影A随着波纹型仿生曲面突起宽度、两相邻突起间距的增大而减小，接触面积的水平投影与波纹型仿生曲面表面垂直载荷之比随着波纹型仿生曲面表面垂直载荷的增大而减小，进而得出仿生曲面摩擦系数随着波纹型仿生曲面突起宽度、两相邻突起间距以及表面垂直载荷的增大而减小；利用ANSYS软件对平板与土壤的相互作用进行了有限元建模与分析，表明平板摩擦系数与土壤弹性模量关系不大，而随着表面垂直载荷的增大而减小；平板牵引过程中台车牵引力和仿生曲面控制节点垂直方向位移基本保持不变；利用ANSYS软件对波纹型仿生曲面与土壤的相互作用进行了有限元建模与分析，表明波纹型仿生曲面系数在一定范围内基本不受土壤弹性模量的影响，随着波纹型仿生曲面突起宽度、两相邻突起间距以及表面垂直载荷的增大而减小，但在可信度为90％的前提下，三个因素影响都不显著；首次将波纹型仿生曲面应用于与土壤作用方式以挤压为主的螺旋桩，形成仿生螺旋桩，并与普通螺旋桩进行了沉桩对比试验，表明波纹型仿生曲面应用于螺旋桩桩体表面具有明显的降阻作用。

This course provides:Simple linear regression and correlation,Measures of model adequacy,Multiple regression,Polynomial regression models,Variable selection and model building,Multicollinearity and Topics in the use of regression analysis.

其内容包括：简单直线回归与相关，模式正确性的衡量，复回归分析，多项式回归模式，变量的选择及模式建立，共线，回归分析应用上的注意事项等。

On the other hand, partial Least Square Regression which is called the second generation regression method has got good result in handling the multicollinearity in multilinear regression;But under some circumstances the result of such a regression is not satisfactory.

另一方面，偏最小二乘回归方法，被称为第二代回归方法，在处理线性回归中的多重共线问题时，有着较好的效果；但在有些情况下的回归结果却并不理想。

In the regression add variables and delete the variables of each step, the regression equation of the series solution of regression coefficients, and calculation of regression coefficients significant test statistic.

在逐步回归添加变量和删除变量的每一个步骤，都要解一系列的回归方程，求回归系数，计算回归系数显著性检验的统计量。

Based on cloud seeding data on April 5,2002 in Henan province,cloud seeding effects were evaluated by six methods,i.e.double contrast method of regional rainfall tendency control,regression analysis method of regional tendency correlation,multiple regression analysis method of regional tendency covariant,floating control historical regression method,cluster-analysis-based floating control historical regression method using rainfall as a covariant and CA-FCM using rainfall and atmospheric perceivable water as covariants.

根据2002年4月5日河南省人工催化增雨作业数据，分别采用作业区域趋势对比双比分析评估方案、区域趋势相关回归评估方案、区域趋势协变量多元回归评估方案、FCM评估方案、以降水量为协变量的CA-FCM评估方案和以降水量与整层大气可降水量为协变量的CA-FCM评估方案进行效果评估。

The article present the conception of regression testing and the step of executing this testing. Introduce how to maintenance the test case library which used in regression testing ,and provide the method of ensure regression testing's validity. Finally, it gives some problem must be careful in the period of regression

本文描述了软件回归测试的概念和进行回归测试的基本步骤，介绍了可用于回归测试的测试用例库的维护方法，给出了几种可以可保证回归测试效率和有效性的回归测试策略，总结了回归测试时应该注意的一些实际问题。

The correlation analysis and stepwise regression between physiological characteristics of three species and environmental factors showed that the regression equation of Platycladus orientalis between photosynthetic rate, transpiration rate and the environment factor was P(subscript n=0.006PAR+1.176RH, E=1.120T; the regression equation of Pinus tabulae formis was P(subscript n=0.010PAR, E=1.004T+0.482RH; the regression equation of Tamarix chinensis was P(subscript n=0.015PAR, E=0.757T+0.566RH-8.397G.

对3种树的光合速率和蒸腾速率与影响因子进行相关分析及逐步回归分析表明，各树种光合速率和蒸腾速率的回归方程分别为，侧柏：P=0.006PAR+1.176RH，E=1.120T；油松：P=0.010PAR，E=1.004T+0.482RH；柽柳：P=0.015PAR，E=0.757T+0.566RH-8.397G。

The main content of the study includes: the policy variables are classified into two types, which are continuous policy variable and discrete policy variable, and the two variable is analyzed respectively; as to the continuous policy variable, use reasonable weighting to synthesize comprehensive policy indicator to reflect the comprehensiveness of each main policy indicator; undertake regression analysis for the comprehensive policy indicator, economic and stock market variable and get the effect of all kinds of comprehensive policy indictor variables on the economy and stock market; undertake regression analysis for data on the economic indicator and the data on the stock market and get the relationship between the economy and the stock market; use event research method to analyze its effect on the stock market and get some corresponding conclusions; structure the differential or difference equation groups on the interactive relationship among the variable economy, stock market and policy and do the difference operation and constitute simultaneous equation with the original main variables one after another; use quantitative regression method and solve the coefficient of the simultaneous equation to predict the operating tendency.

本研究主要内容包括：将政策变量划分为连续性政策变量和离散政策变量两个类型，并分别进行分析；对于连续性政策变量，采取合理的权重来合成政策综合指标，反映各主要政策指标的综合力度大小；将各政策综合指标与经济、股市变量进行回归分析，获得各类政策综合指标变量对经济、股市影响程度的大小；将经济指标数据与股市数据进行回归分析，获得经济与股市之间关系的大小；采取事件研究方法来分析其对股市的影响程度；构建关于经济、股市与政策各主要变量之间互动关系的微分或差分方程组，进行差分运算，并以此与原来各主要变量组成联立方程；运用计量回归方法，求出联立方程系数用于预测。

Continuously improve the production mechanism, to provide customers with better quality products and services.

不断的完善生产机制，给客户提供更优质的产品及服务。

B:Yes, he was the very prize-winner in the court tennis ten years ago?

是的，他是十年前的世界网球冠军。