查询词典 permanent load

The paper studies UFLS with severaltimes accelerating shedding load function, analyzes dynamic frequencycharacteristic of power system during UFLS, derivesthe formula which is served as setting rate of frequency change for criterionof accelerating shedding load, and designs the logical diagram expressing UFLSoperation.

研究了同时依据频率和频率变化率两个变量，在每个频率定值处设置加速减载功能的低频减载方案。文中详细分析了低频减载过程中频率的动态特性，推导了作为加速减载判据的频率变化率整定值的计算公式。

Next, the following points are emphasized:(1) The design of photoelectric conversion preamplifier circuit. In order to improve the measurement accuracy of luminometer and ensure linear relationship of the photoelectric, operational amplifiers is designed as current-voltage converter form, on the one hand, it is available to zero-load effect; on the other hand, short-circuit current can be transformed into a voltage volume through the feedback resistor, it is equivalent to voltage drop flowed through a load resistor on the actual effect.

其次，本文重点做了以下工作：(1)光电转换前置放大电路的设计：为了提高照度计的测量准确度，确保光电间的线性关系，本设计把运算放大器接成电流电压变换器的形式，一方面可得到零负载效应；另一方面，短路电流通过反馈电阻变成电压量，实际效果相当于流过一个负载电阻形成的压降。

The main dimensions are calculated by magnetic track, then the fields of load and without load are computed by 2-d FEM and references of the motor are obtained, so the structure of the motor can be adjusted.

用磁路设计法确定电机的主要尺寸，然后用二维有限元法计算电机的空载和负载磁场分布，得到电机的参数和性能，根据性能要求对电机结构尺寸调整。

2TheMax GPX750 PSU for the desktop computer features total output of 750W, rated supply voltage of 115V to 230V auto range, rated mains frequency of 47 to 63 Hz, rated input of 115V at 10A or 230V at 5A, efficiency of 85% minimum at typical load, holdup time of 16.6ms at nominal line under full load condition, power good signal between 100ms to 500ms, over current protection at 110% to 150% individual output power, over voltage protection for +5V is between 5.8V to 6.3V,+12V from 14V to 17V, 3.3V from 3.6V to 4.2V, air flow by DC fan, operating temperature of 0°C to 50°C and operating humidity of 20% to 90% non-condensing.

2themax gpx750电源为桌上型电脑的功能总产量750瓦特，额定电源电压115v到230v汽车范围，额定工频47至63赫兹，额定输入的115v在10 A条或230v在5 ，效率85 ％，最低在典型负载，持的时间16.6ms的名义在网上下，满负荷条件下，电源良好信号之间的100 ms到500ms ，过电流保护在110 ％至150 ％个别的输出功率，过电压保护，为5 V是之间的5.8 V至6.3v ，+12 V的从14v至17v ，电压为3.3 V从V到3.6 V至4.2 V ，空气流量由直流风扇，操作温度0° C到50 ° C和运作中的湿度为20 ％至90 ％，非冷凝。

Integrate the load transfer principle and shearing displacement method to set up the load transfer equation between the pile of soil, using the discrete and fitting methods to solve the equation so as to educe the pile displacement of arbitrary section as well as the analytical solution. Comparing the results with the soil settlement solved by the Mair equation, the relative displacement can be gained.

1结合荷载传递原理和剪切位移法的思想建立隧道开挖作用下的桩土荷载传递方程，采用离散和拟合两种方法来对该一元二次非齐次微分方程进行求解，可分别得到桩身任意截面处的桩体位移以及桩身位移的解析解，并与基于Mair公式求得的地面下任意深度处的土体沉降进行比较，即可求出桩与桩侧土之间的相对位移。

Traditionally, autoloaders can only handle one duplication job at a time and additional manpower is needed to load a new duplication job ex. Load new master disc, insert more blank discs, etc.

传统的自动加载器一次仅能完成一个拷贝任务，然后需要人力加载新的拷贝任务（例如，加载新的主要光盘，插入更多的空白光盘等）。

Simulation result shows that, our peer-to-peer network architecture has less maximum load of single node and load mean square deviation of overall nodes than Chord.

仿真实验结果表明，单个节点的最大注册用户负载量和节点负载量均方差均小于Chord对等网络。

The procedure is based on the concept that the critical load of a frame without sidesway is the same as the smallest value among these critical loads of the compression members of the frame with partially restrained ends, and the critical load of every compression member may be determined by the method of successive approximation.

将组成刚架的各桿件视为两端受不同约束的桿件，用静力学的方法求出此等桿件相应的临界荷重，其中最小值即为刚架的临界荷重，举有实例以示演算程序。

Another example is hydraulic motor-driven conveyor, in a direction of the load, no load in another direction, its need to have two different kinds of brake pressure.

又如液压马达驱动输送机，在一方向有负载，另一方向无负载时，其需要有两种不同的刹车压力。

In this paper eighteen examples, which are designed strictly owning to currently Codefor seismic design of buildings of my country, are used to analyze the structure earthquakeresponse under the horizontal seismic load (nabla load distribution pattern) by Push-overanalytical method. The corresponding structural influencing coefficient, the displacementamplification factor, the overstength and ductility factors are analyzed taking into accountthe factors changing, such as level number, span length, span number.

本文严格按我国《建筑抗震设计规范》设计了18个多层钢框架，并以此为例，采用Push-over方法分析了结构在水平荷载作用下的地震反应，得出了多层钢框架的结构影响系数、结构延性和超强系数以及位移放大系数，并讨论了这些系数随着结构层数、跨度及跨数的变化规律。

He became prime minister in 1997 and won international acclaim for his role in the Northern Ireland peace process.

他在1997年成为总理，并且因为在北爱尔兰的和平进程中发挥的作用受到国际社会的赞许。

Mixed Page Sorting Method Using the cuttable user model, this thesis proposes a mixed page sorting method by using cutted user model in server-side and complete user model in client-side.

隐私分级利用的混合式页面排序方法针对个性化搜索中搜索结果排序的问题，本文利用隐私可控开放的用户偏好模型，提出一个在客户端和服务器端分步进行的隐私分级利用的混合式页面排序方法。