查询词典 partial correlation coefficient

In this paper, a total of 56 relatively nonpoint source pollution sediment samples were collected from the tidal flats of the Jiuduansha shoal and the Chongming island of the Yangtze river estuary. The main properties i. e., grain size distribution, contents of DCB (dithionite citrate bicarbonate extracted iron Fe(subscript d, AAO extracted iron Fe(subscript o, total Fe, DCB extracted Mn Mn(subscript d, total Mn, organic matter, magnetic susceptibility of the samples, as well as the concentrations of Cu, Zn, Pb, Cr, Cd and Ni in the samples, were determined. Basing on the data, the relation of the sediment properties to heavy metal concentrations was evaluated with pearson's rank and partial rank correlation analysis.

采集长江口无明显点源污染的崇明东滩和九段沙潮滩56个沉积物样品，测定沉积物原样和粘粒中Cu，Zn，Pb，Cr，Cd和Ni的含量以及沉积物的主要性状（粒径分布、游离铁、活性铁、总铁、游离锰、总锰、有机碳和磁化率等），以相关分析和偏相关分析研究沉积物中重金属含量与沉积物主要性质之间的关系。

The partial correlation between the aril and the peel reached significant level .The growth curves of longan fruit and its tissues,demonstrated by eithe...

龙眼果实及各组织的水分进入均早于溶质的进入，假种皮的生长落后于果皮和种子的生长，溶质进入果皮和种子先于假种皮，花后70d开始，溶质主要进入假种皮。

With the dose of 7.04 mC/cm2, ODT/Au will become a more strengthened structure and then form a negative resist in the correlation with cross-linking from alkyl matrix, partial breakdown of S-Au bonding and surface adsorption by air-borne species. Thus, it can obtain a gold pattern via gold-etching process. Besides, as a result of massive breakdown of alkyl matrix and S-Au bonding from ODT/Au under irradiation with doses of 64.06 and 128.13 mC/cm2, ODT SAMs would form a loose-packed structure on the gold substrate. The ODT/Au becomes less resistive for gold-etching and a positive gold pattern would form after gold-etching.

结果发现：以50 eV 低能量电子在照射剂量7.04 mC/cm2微影并曝露於大气后，受到来自於ODT/Au碳链间的交联、部分的S-Au键结破坏以及照射后立即曝露大气所吸附於表面的碳氧化物种的共同影响下，ODT SAMa於Au膜基材上将形成更紧密复杂的结构而作为负型阻剂，经后续湿式蚀刻15分钟后将显影出来Au的负型图案；当提升照射剂量至64.06及128.13 mC/cm2后，由於ODT/Au上碳链及S-Au键结的大量破坏，将使ODT/Au结构不能稳固且紧密地排列於Au膜基材上，显影时Au蚀刻液将容易穿过ODT SAMs抵达S/Au界面而移除Au，而形成正型图案。

To research on quantitative relations between neutral aroma constituents and concentration and quality of aroma of flue-cured tobacco in Panxi tobacco-growing areas, and to offer a new and impersonality method of flue-cured tobacco quality assessment, the authors carried out partial correlation analysis, path analysis and stepwise regression analysis, and established mathematics model and studied the factors of neutral aroma constituents affecting concentration and quality of aroma of flue-cured tobacco in this paper.

为了探究攀西烤烟烟叶中性致香成分与香气质和香气量的定量关系，并为客观准确评价烟叶质量提供新方法，该文采用偏相关分析、通径分析和逐步回归的分析方法，建立数学模型，研究了影响烤烟香气质量的中性致香成分。

The method of the research in the paper is impellent,and the basal research course is the following.Firstly,the author uses the Theil coefficient and Gini coefficient to analyze the regional economic gap,and decomposes the structure in China.At the same time,the author tests theσconvergence,the absoluteβconvergence,the conditionalβconvergence and the club convergence.Secondly, the author analyzes the forming reason and mechanism of the regional economic gap in China.

本文研究过程中采取逐步深入的推进方法，其基本研究思路是：首先，使用基尼系数和泰勒指数对中国地区经济发展差距的历史演变轨迹进行了分析，并对其形成结构进行了分解，同时对中国经济增长的σ收敛、绝对β收敛、条件β收敛和"俱乐部"收敛进行了检验，以此为基础形成了对中国地区经济发展差距的全面了解；其次，以新古典增长理论和新增长理论为基础对中国地区经济发展差距的形成机制进行了分析；再次，以FDI非均衡分布为视角对中国地区经济发展差距的形成机制进行了解释；最后，提出了本文的政策建议。

Experimental results indicate that the variance coefficient was not bigger than 4.98% in the range of 50×10^(-6)~10000×10^(-6); the coefficient was not bigger than 0.44% and the absolute error was less than 0.35×10^(-6) in the range of 2.5×10^(-6)~10×10^(-6).

该分析方法在50×10^(-6)~10000×10^(-6)范围内，变异系数不大于0.44%；在2.5×10^(-6)~10×10^(-6)范围内，变异系数不大于4.98%，绝对误差小于0.35×10^(-6)。

It is based on the analysis of reflectometric interference spectrum and by this means, optical constants, such as extinction coefficient, refractive index, absorption coefficient and thickness, can be calculated with a high precision.

该方法是一种高精度的测量方法，与透射光谱分析法相比，反射干涉测量方法对于薄膜系统的载体要求较小，可以是透明载体，也可以是非透明基底，可以是金属载体，也可以是光纤端面。

Pitch circle diameter: d = mz = 3X12 = 36 Tooth crown heights: ha = m (f0 + x)= 3X (l +0.5)= 4.5 Tooth High: hf = m (f0 + cx)= 3X (l +0.25-0.5)= 2.25 Tooth full height: h = ha + hf = 4.5 +2.25 = 6.75 Addendum circle Chemical pumps diameter: Da = d +2 ha = 36 +2 X4.5 = 45 Fixed string tooth thickness: Sxn = m (π/ 2 * cos2a + xsin2a)= 3X (1.387 +0.6428 X0.5)= 5.125 Fixed string of high gear tooth thickness measurement: hxn = m (π/ 8 * sin2a + xsin2a)= 3X (0.7476X0.117X0.5)= 2.42 Modulus coefficient x0.5 m3 O20 ° pressure angle tooth thickness Sxn5.12 fixed string Addendum Coefficient string f1 fixed gear tooth thickness measurement most high hxn2.42 Teeth z12 2, shaft wear and tear maintenance: Axis gear pump wear is mainly because with the support roller shaft at both ends between the friction and wear, so that smaller shaft diameter.

分度圆直径：d=mz=3X12=36 齿顶高：ha=m（f0+x）=3X（l+0.5）=4.5 齿根高：hf=m（f0+c-x）=3X（l+0.25-0.5）=2.25 齿全高：h=ha+hf=4.5+2.25=6.75 齿顶圆直径：Da=d+2ha=36+2X4.5=45 固定弦齿厚：Sxn=m（π/2*cos2a+xsin2a）=3X（1.387+0.6428X0.5）=5.125 固定弦齿厚测量用齿高：hxn=m（π/8*sin2a+xsin2a）=3X（0.7476X0.117X0.5）=2.42 模数m3变位系数x0.5 齿形角o20°固定弦齿厚Sxn5.12 齿顶高系数f1固定弦齿厚测最齿高hxn2.42 齿数z12 2、轴的磨损维修：齿轮泵中轴的磨损主要是因为轴两端与支撑滚针间的摩擦磨损，使轴径变小。

The static model of torsion joint is based on that of bending joint. The effects of structure parameters inside air pressure, initial angle, rube average radius, rube shell thickness on the turning angle are analyzed and the following conclusions are drawn: the relationship between the angle of torsion joint and the inside air pressure is basically linear, the angle of torsion joint increases with the initial angle and rube average radius, the angle of torsion joint decreases while the rube shell thickness increases. The kinetic equation is built for torsion joint. Simulating experiment implies that the time of inflating and deflating process is extremely shorter than that of kinetic process. So the pneumatic process can be ignored in actual system design and control. The factors that affect the dynamic features of torsion joint, such as shell thickness of rubber tube, average radius, initial angle, connector's outlet area, moment of inertia and viscous damping coefficient, are analyzed and the following conclusions are drawn: the change of rube shell thickness has no effects on the dynamic process of FPA inside air pressure while greatly affects the turning angle of torsion joint; when the rube shell thickness is small, the torsion joint has a bigger turning angle, no overshoot and long risetime, when the shell thickness is big, the turning angle of torsion joint is small, but has high response speed, overshoot and low shock; when the rube average radius increases, the turning angle of torsion joint increases and the overshoot increases too; when the initial angle of torsion joint is big, the turning joint is big, the overshoot is small and shock is low, but the risetime is big; the connector's outlet area affects the dynamic process of FPA inside air pressure greatly, but has no effects on the dynamic process of turning angle; moment of inertia and viscous damping coefficient have no effects on the dynamic process of FPA inside air pressure, but affect the dynamic process of turning angle greatly.

在弯曲关节模型推导的基础上，建立扭转关节的静态模型，并分析了扭转关节内腔压力，初始转角，橡胶管平均半径，橡胶管壁厚等参数对关节转角的影响，得出扭转关节的转动角度与充入FPA内腔的压缩气体压力之间基本呈线性关系，扭转关节的转角随初始角度和橡胶管平均半径的增大而增大，扭转关节的转角随橡胶管壁厚的增大而减小的结论；建立了扭转关节的动力学方程，仿真实验表明FPA的充放气过程与扭转关节的动力学过程相比时间极短，在实际系统设计和控制过程中可以忽略不计；分析讨论橡胶管壁厚，平均半径，初始角度，气体节流口面积，转动惯量，粘性阻尼系数等因素对扭转关节动态特性的影响，得出橡胶管初始壁厚的变化对扭转关节FPA内腔压力的动态响应几乎没有影响而对关节转角的响应曲线影响比较明显，壁厚较小时，关节可以得到较大的转角，并且转角的响应曲线没有超调，但上升时间长，壁厚较大时，关节转角变小，响应加快，但是有超调和轻微振荡现象，橡胶管平均半径越大，得到的关节转角越大，但是转角响应的超调量也随之增大，FPA的初始角度越大，关节的转角越大，并且超调量减小，振荡减弱，但是上升时间增大，管接头出口面积的大小对关节FPA内腔压力的建立过程影响较大，但对关节转角的动态响应几乎没有影响，转动惯量和粘性阻尼系数对FPA内腔压力的动态过程几乎没有影响而对扭转关节转角有较大影响等结论。

The angular distribution of the transmission coefficient of HH polarization are obtained by numerical implementation, the influence of the permittivity and the mean layer thickness of intermediate medium, friction velocity and the frequency of the incident wave on the transmission coefficient is discussed.

通过数值计算得到了HH极化透射系数随散射角的变化曲线，讨论了中间介质介电常数和厚度、摩擦风速和入射波频率对透射系数的影响，得到改进的一维分形分层海面透射系数的基本特征、分区特征和随频率变化的特征，结果表明透射系数近似具有"量子化"特征。

Chimborazo and Cotopaxi, took me by the hand.

越过琴博腊索山和科托帕克西山。

This car is in a good condition.

这辆车的状况很好。