查询词典 moving direction

First, the phenomenon of the projectile-retarded mechanism of moving plates is introduced, the conditions of the projectile-retarded mechanism of moving plates is analyzed. By a number of numerical simulations, the residual length and residual velocity of the rod which penetrate the fixed plate is contrasted with those of the moving plate. Under the different velocity of moving plate, the relationship between the effect of the projectile-retarded moving plates with thickness and intersection angle of the projectile-retarded moving plates is achieved, and the most optimal thickness and intersection angle is gotten.

首先介绍了运动板抗弹作用的现象，分析了产生运动板抗弹作用的条件，利用数值计算的方法，对比了长杆侵彻固定靶板和运动靶板后长杆的剩余长度和剩余速度，分析了不同的运动板速度条件下产生运动板作用的条件，得出了运动板抗弹效果与靶板厚度和夹角的关系，得到了产生运动板抗弹作用的最优靶板厚度和夹角。

Firstly, a signalized point is stuck on a moving object to be tested, a microphone array and two video cameras are arranged, and the video cameras are demarcated to obtain a projection matrix; sound pressure signals of a sound source in the moving object to be tested are obtained by the microphone in an array mode, the dynamic video of the moving object to be tested is obtained and disassembled into an image by the video cameras; the signalized point on the moving object to be tested is identified in the video image and the matched signalized point is treated with three-dimension reconstruction to obtain the spatial location of the moving object to be tested; the sound pressure signals are treated with beam forming treatment to obtain a sound field characteristic function scattergram of the moving object to be tested, the video image is treated with spatial coordinate superposition frame by frame and restored into a dynamic video image.

首先在被测运动物体粘贴标志点，布置传声器阵列和两台摄像机，对摄像机进行标定，得到投影矩阵；传声器阵列获取被测运动物体中声源的声压信号，摄像机获取被测运动物体的动态视频，将动态视频拆解成图像；在视频图像中识别出被测运动物体上的标志点，对匹配后的标志点进行三维重构，获取被测运动物体的空间位置；对声压信号进行波束成型处理，得到被测运动物体的声场特征函数分布图，将其视频图像进行逐帧空间坐标叠加，并还原成动态视频图像。

Thence in a southeasterly direction to Corner Point No. CP14 (X = 484 330, Y = 683 415); thence in a. northeasterly direction to Corner Point No. CP15 (X = 484 390, Y = 683 490); thence in a southeasterly direction to Corner Point No. CP16 (X = 484 415, Y = 683 470); thence in a southwesterly direction to Corner Point No. CP17 (X = 484 355, Y = 683 395); thence in a southeasterly direction to Corner Point No. CP18 (X = 484 430, Y = 683 335); thence in a southeasterly direction to Corner Point No. CP1, the point of beginning.

从该点起向东南延伸至隅角点CP14（X = 484 330，Y = 683 415）；从该点起向东北延伸至隅角点CP15（X = 484 390，Y = 683 490）；从该点起向东南延伸至隅角点CP16（X = 484 415，Y = 683 470）；从该点起向西南延伸至隅角点CP17（X = 484 355，Y = 683 395）；从该点起向东南延伸至隅角点CP18（X = 484 430，Y = 683 335）；从该点起向东南延伸至隅角点CP1。

The device comprises: a conveyer belt; a let-off roller (16) on which the conveyer belt runs and from which the rubber tape is let off; a traverser (21) to move the let-off roller (16) in an X-axis direction parallel to the rotational axis of the object; a radial shifter to move the let-off roller in a Y-axis direction perpendicular to the X-axis direction; a tilter (23) to turn the rotational axis of the let-off roller (16) around a reference axis which is parallel to a Z-axis direction perpendicular to the X-axis direction and Y-axis direction.

所述装置包括：输送带；送出辊，所述输送带在送出辊上行进并且所述橡胶带从送出辊送出；移动台，其沿平行于物体的旋转轴线的X轴方向移动送出辊；径向移位装置，其沿垂直于X轴方向的Y轴方向移动送出辊；倾转装置，用于绕平行于Z轴方向的基准轴线转动送出辊的旋转轴线，所述Z轴方向垂直于X轴方向和Y轴方向。

Crack propagation problems under the influence of the edges of the crack subjected to homogenous loads, the origin of the coordinates subjected to concentrated increasing loads, the central zone of the edges of the crack subjected to homogenous loads, the certain point of the edges of the crack subjected to moving unit step loads, the origin of the coordinates subjected to moving increasing loads Px m, the edges of the crack subjected to instantaneous impulse loads, the edges of the crack subjected to moving concentrated variable loads, the origin of the coordinates subjected to point loads, the edges of the crack subjected to a constant moving concentrated loads and the origin of the coordinates subjected to instantaneously moving impulse loads are studied respectively, and the analytical solutions of dislocation distribution function have been obtained.

同时对裂纹面受均布载荷、坐标原点受集中增加载荷、裂纹面中心区受均布载荷、裂纹面上某点受运动阶跃载荷、坐标原点受运动增加载荷Px m、坐标原点受瞬时冲击载荷、裂纹面受运动集中变载荷、坐标原点受集中载荷、裂纹面受常数运动集中载荷、坐标原点受瞬时运动冲击载荷作用下的裂纹扩展问题分别进行了研究，获得了位错分布函数的解析解。

Moving cast shadows generally exist in video sequence. To prevent moving shadows being misclassified as moving objects or parts of moving objects, and improve the accuracy of shadows detection algorithm, an algorithm of moving cast shadows was proposed based on spatial information.

运动阴影在视频图像序列中普遍存在，为了防止被错误地检测为目标，提高阴影检测算法的准确性和普适性，提出了一种基于空间变换技术的运动阴影检测算法。

After take analyzed deeply for the opened magnet circuit with FEMM (Finite Element Method Magnetics) we find out the field distributing that is separated into three sections . One is the main area what we called as positive field section. Beside the main field there are tow areas that are called the inverted field sections. Loudspeaker arise a very serious distortion when the voice coil moving into inverted field areas. The direction of induced current in the coil part of entered inverted field area is same with the current driving into loudspeaker so that total currents increas largely and heat increase rapidly. With more coils moving into inverted area the voice coil will take on negative inductance properties. It is the main reason that voice coil is burned by heating with increasing current due to arise negative inductance. So opened magnetic circuit is not suitable for the woofers in which the voice coil have wider displacement range. When using this kind magnetic circuit design, the voice coil moving range should be less than the range of positive field to avoid loudspeaker arise serious distortion and heating. Even though voice coil moving range is in the positive area, loudspeaker will still arise more distortion because the field distribution is very cliffy at tow sides of the positive area and full range of magnetic field distribution is not parallel that will arise distortion. Base on above reasons, opened magnetic circuit is not an ideal magnetic circuit for low-frequency loudspeakers. But it can be used in mid-range or high-frequency productions.

开式磁路是由2片钕铁硼磁铁和主导磁板和导磁垫片组成，我们在实践过程中发现这种磁路结构不适合于低频扬声器的使用，我们通过使用FEMM（Finite Element Method Magnetics）软件包对该磁路进行了分析，该磁路的磁场范围被分成3个区域，其中在主导磁板附近形成一个正向磁场，在正向磁场的两边存在反向的磁场，音圈在工作时有很大一部分进入了反向磁场中，在反向磁场内线圈的感应电流方向与驱动电流方向相同，使得音圈呈现出负感抗特性，由于音圈的负感抗特性引起电流的增加导致音圈发热甚至烧毁，因此在扬声器中使用开式磁路时，音圈的运动范围应控制在正向磁场范围之内，否则音圈运动到反向磁场区域时将会产生很大的失真和发热，即使在设计时已经将音圈的运动范围控制在正向磁场范围之内，由于正向磁场的2个边缘磁场强度衰减太快，同时开式磁路中磁场的分布不是平行的，而是自由发散的分布，这样肯定会导致扬声器的非线性失真，因此我们得到的结论是：开式磁路并不是一个理想的磁路，它不适合于低频扬声器的使用，但它还可以应用于中高频扬声器。

The opened magnetic circuit is composed as tow NdFeB permanent magnets and a top plate without U-yoke. After take analyzed deeply for the opened magnet circuit with FEMM (Finite Element Method Magnetics) we find out the field distributing that is separated into three sections . One is the main area what we called as positive field section. Beside the main field there are tow areas that are called the inverted field sections. Loudspeaker arise a very serious distortion when the voice coil moving into inverted field areas. The direction of induced current in the coil part of entered inverted field area is same with the current driving into loudspeaker so that total currents increas largely and heat increase rapidly. With more coils moving into inverted area the voice coil will take on negative inductance properties. It is the main reason that voice coil is burned by heating with increasing current due to arise negative inductance. So opened magnetic circuit is not suitable for the woofers in which the voice coil have wider displacement range. When using this kind magnetic circuit design, the voice coil moving range should be less than the range of positive field to avoid loudspeaker arise serious distortion and heating. Even though voice coil moving range is in the positive area, loudspeaker will still arise more distortion because the field distribution is very cliffy at tow sides of the positive area and full range of magnetic field distribution is not parallel that will arise distortion. Base on above reasons, opened magnetic circuit is not an ideal magnetic circuit for low-frequency loudspeakers. But it can be used in mid-range or high-frequency productions.

开式磁路是由2片钕铁硼磁铁和主导磁板和导磁垫片组成，我们在实践过程中发现这种磁路结构不适合于低频扬声器的使用，我们通过使用FEMM（Finite Element Method Magnetics）软件包对该磁路进行了分析，该磁路的磁场范围被分成3个区域，其中在主导磁板附近形成一个正向磁场，在正向磁场的两边存在反向的磁场，音圈在工作时有很大一部分进入了反向磁场中，在反向磁场内线圈的感应电流方向与驱动电流方向相同，使得音圈呈现出负感抗特性，由于音圈的负感抗特性引起电流的增加导致音圈发热甚至烧毁，因此在扬声器中使用开式磁路时，音圈的运动范围应控制在正向磁场范围之内，否则音圈运动到反向磁场区域时将会产生很大的失真和发热，即使在设计时已经将音圈的运动范围控制在正向磁场范围之内，由于正向磁场的2个边缘磁场强度衰减太快，同时开式磁路中磁场的分布不是平行的，而是自由发散的分布，这样肯定会导致扬声器的非线性失真，因此我们得到的结论是：开式磁路并不是一个理想的磁路，它不适合于低频扬声器的使用，但它还可以应用于中高频扬声器。

Based on the distribution of sand-moving wind direction, the dominant wind direction of Yangqing station is WSW due to the regional terrain, the others are all WN, WNW, NNW, the results indicate that the main sand moving direction in Beijing plain is from northwest to southeast.

从起沙风动力方向分布来看，除延庆站受区域地形影响是西南西为主导风向，其余站点的主导风向都是西北、西北西、北北西三个方向，说明北京平原地区的沙尘运移方向主要是自西北向东南搬运。

Traditionally we continue moving forward with the paper in line with the direction of most of the fibers'packing is called straight grain direction; and a direction perpendicular to the horizontal paper called the grain direction.

习惯上我们把与造纸前进方向一致的大部分纤维排列的方向叫做直丝绺方向；与其垂直的一方向叫做纸张的横丝绺方向。

I had a lovely dog named PiPi, he was one of my best friends.

我曾经有过一只小狗，它的名字叫皮皮，它很善良，它是我最忠实的朋友。

Newly ovulated mouse oocytes were cultured in the CZB medium supplemented with different concentrations of pyruvate before treated for activation or assayed for MPF activity.

我们猜测卵母细胞在不含丙酮酸的条件下老化的更快，并且卵丘细胞可能通过消耗不含葡萄糖的CZB中的丙酮酸从而促进卵母细胞老化。