查询词典 minimum deviation

This paper attempts to recommend, explain and refine Montesquieu's enlightenment thoughts from two aspects of reason and its deviation.

本文试图从两个层面——理性与理性的偏离——对孟德斯鸠的启蒙思想加以介绍、阐释和提炼，并重点考察了这两个层面在孟德斯鸠的政治、法学、宗教、历史等思想领域里的贯穿。

In order to eliminate the prediction deviation caused by small data set,proposed a stream prediction algorithm based on weighted moving average method.

该模型仅存储当前滑动窗口中的数据并对其进行分析，提高了计算效率；同时，为了削减在较小数据集上回归预测所产生的偏差，提出一种基于加权移动平均的数据流预测算法WMA_LRA。

If there was deviation on this, can produce muddleheaded understanding on the thought, can produce bad consequence on practice.

如果在这一点上有了偏差，在思想上就会产生糊涂的认识，在实践上就会产生不好的后果。

Precision fire of AA gun must accurately confirm and correct muzzle velocity deviation and adjustment.

高炮要准确射击必须准确确定和修正初速偏差量。

Because the formation of "overall human" must be based on reality, Marx viewed the final solution to the contradiction between human and nature, human and society and human and human as the necessary condition of its formation, In addition, He brought out and interpreted profoundly the problem on overcoming the deviation between human and nature, solving the alienation and finding out an ideal way to be an overall man, Thus it finishes uniting the nature humanism with human naturism in the theory.

完整的人"的生成必须具有现实基础，为此，马克思把人与自然、人与社会、人与人之间的矛盾的最终解决作为"完整的人"生成的必要条件，提出并深刻阐释了克服人与自然的相背离和异化问题、实现"完整的人理想途径，从而在理论上完成了自然的人道主义和人的自然主义的统一，为总体性现代化和建设小康社会奠定了理论基础。

Finally, the gravity anomaly of the nearside is obtained, and is compared with the latest lunar gravitational model LP165. It showsthat the standard deviation in the domain -75°~ 75° is ±27.354 mgal, and75°~ 85°,-85°—75° is ±61.965 mgal, which verifies the feasibility and reliability of this method.

最后将计算结果和现今最高阶次的月球重力场模型LP165进行了比较和分析，得出标准差在纬度-75°～75°范围内为±27.354mGal，75°～85°，-85°～-75°范围内为±61.965mGal的精度，从而验证了该解算方法的可行性和可靠性。

The topographical parameters have been analyzed by taking into account the thermal effect during the friction process. As the results, three kinds of typical topographical features have been observed for the worn surfaces of C G iron with various P content. Namely, C G iron with 0.05% P, 1.30% P, and 0.70% P show worn surfaces characterized by groove ridge, peak pits and their combined topography. The C G iron specimen with peak pits type worn surface topography showes the lowest wear rate and highest friction coefficient, while that with groove ridge type worn surface topography shows the highest wear rate and lowest friction coefficient. The groove ridge type worn surface has a relatively large value of surface height deviation and void volume ratio and negative large value of skewness, which is contrary to the peak pits topography.

结果表明：度销磨损表面主要呈现犁沟型、孤岛型及二者的混合型3种形貌特征，其中具有孤岛型磨损表面形貌特征的试样的摩擦系数较高，磨损率较低；而具有犁沟型磨损表面形貌特征的试样的摩擦系数最低，磨损率最高，分析表面形貌参数发现：犁沟型表面形貌具有最大的表面高度偏差和表面空隙率及高负值的表面高度分布参数；而孤岛型表面形貌的表面高度偏差和表面空隙率最小，表面高度分布参数为高正值。

The whole impedance deviation at the positive or negative limit terminal is rather smaller than at the rated terminal and it is neglectable.

通 过基本定义和有关名牌值进行了计算和分析，认为在正负极限档，外加串联调压变的阻抗值相对额定档的偏差很小，所以可不必在意这种变压器整体阻抗的偏差值。

Following the introduction of the basic principle of OFDM, some nonideal effects on the performance of OFDM systems are discussed, such as carrier frequency offset, symbol timing offset and sampling clock deviation.

本文在简要介绍了OFDM的基本原理、关键技术的基础上，针对同步问题进行了深入研究。首先分析了同步偏差中的频率偏差、符号定时偏差及采样时钟偏差对系统性能的影响。

Secondly, we consider the stability problem of a more widespread class of feedback interconnected system, which can allow the nonlinear operator to have a deviation. And some stability criteria are presented too.

并将其应用于绝对稳定性问题，得到了时变的圆判据，也给出了多输入多输出情况下的一些判据，这些结果对非线性环节是否解耦不作要求。

Chimborazo and Cotopaxi, took me by the hand.

越过琴博腊索山和科托帕克西山。

This car is in a good condition.

这辆车的状况很好。