查询词典 maximum deviation

Given a graph G representing a network topology, and a collection T ={(s1 , t1 )...} of pairs of vertices in G representing connection request, the maximum edge-disjoint paths problem is an NP-hard problem that consists in determining the maximum number of pairs in

给出图表G代表网络拓扑结构的和收藏品T ={(s1， t1)…}对端点在代表连接请求的G，最大值边缘弄乱问题是一个NP坚硬问题在确定包括对的最大数字的道路

Given a graph G representing a network topology, and a collection T ={(s1 , t1 )...} of pairs of vertices in G representing connection request, the maximum edge-disjoint paths problem is an NP-hard problem that consists in determining the maximum number of pairs inT that can be routed in G by mutually edge-disjoint si ti paths.

由于图G代表的网络拓扑，并且收藏笔=( S1及T1期……的顶点G大代表连接请求，最大边不相交的路径问题是一个NP-hard问题，它包括确定最多偶笔可以改为G大相互边相交硅钛路径。

Taking into account the mainly reason of dike's damage due to typhoon in Taiwan, the analytic objective will be restrictedly focused on the maximum wave and the maximum water levels during the typhoon attacked period.

波浪与水位为造成海岸溢淹之重要因子，海堤为台湾目前最主要的海岸防御措施。

It attained its maximum depth in the Rue Saint-Pierre, where it rose to the height of three feet above the flag-stones of the water-spout, and its maximum length in the Rue Saint-Sabin, where it spread out over a stretch two hundred and thirty-eight metres in length.

它在圣皮埃尔街水位最高，比排水管高出三尺，在圣沙班街，它的面积最宽处扩展到二百三十八米长。

Effects of dry temperature and dry time on properties of heat cured sand and the relationship with binder composition are as follows:sands bonded by binders that are not modified have high strength when dry temperature is high and dry time is long,but their anti-wettability power is poor . Sands bonded by binders that are modified by B but not modified by M can be dried quickly and sand strength is high but anti-wettability power is also poor. Sands bonded by binders that are modified by M but not modified by B can also be dried quickly to obtain maximum strength,then the strength becomes lower when they are dried continually for more time. and sand strength is high but anti-wettability power is also poor. Sands bonded by binders that are modified by M as well as by B at the same time can be dried quickly to obtain maximum strength at low temperature and short time. But the anti-wettability of sand mold is best when they are dried at high temperature and long time.

烘干温度和烘干时间对热硬砂性能的影响及其与粘结剂改性的关系是：未经改性剂B和改性剂M改性的粘结剂砂，脱水速度较慢，烘干温度越高，时间越长，则硬化强度也越高，但未经改性的粘结剂热硬砂的抗吸湿性较差；经改性剂B而不经改性剂M改性的粘结剂热硬砂，烘干硬化速度较快，强度也高，但在高湿度下的抗吸湿性不好；经改性剂M改性而不经改性剂B改性的粘结剂热硬砂，烘干时强度先随烘干时间升高至最大值后，继续烘干时强度又出现下降；经改性剂B和经改性剂M共同改性的粘结剂热硬砂能在短时间和较低的烘干温度下就可烘干到最高强度，即烘干脱水的速度较快，但试样的抗吸湿性差，若在更高温度和更长时间下烘干，试样的抗吸湿性得到改善，综合考虑烘干强度和抗吸湿性要求，对于φ30×30mm试样，理想的烘干温度是200℃，烘干时间20分钟。

Fruit yields, weight of single fruit, per fruit pulp weight, fruit edible ratio, water content of sarcocarp were all increased with the increase of SWC and reached the maximum at SWC75. Soluble brix, soluble suger and titratable acid of fruit had notable or significantly notable negative-linear relations with SWC (R~2 = 0.880 7*; R~2 = 0.717 7* and R~2=0.965 1**) while pH of fruit was increased as SWC did. Brix-acid ratio of fruit was increased linearly with the increase of SWC (R~2=0.908 6*, n=50) and reached the maximum at SWC75. Suger-acid ratio also increased with SWC.

在SWC≤75%时，柑橘产量，单果重，单果果肉重、果实可食率、果肉含水量等随SWC增加而显著增加，在75%时各指标值最高；果实可溶性固形物、可溶性糖和可滴定酸含量分别与SWC呈显著或极显著线性负相关，相关系数分别为R~2=0.880 7~*(n：50)、R~2=0.717 7~*(n=50)和R~2=0.965 1~n=50果实pH值则呈相反趋势，柑橘果实固酸比和糖酸比随SWC的增加而显著增加，果实固酸比与SWC呈显著线性相关(R~2=0.908 6~*，n=50，糖酸比在SWC=75%时达到最大值。

Increase of 47% in the unconned compression strength compared to increase of 26% in the secant modulus at the maximum stress level, 25% in the secant modulus at half of the maximum stress level, and 23% in initial tangent modulus.

这一变化的数额膨润土10日至15 ％，导致平均增加了47 ％的无侧限抗压强度相比增加了26 ％的割线模量的最高应力水平， 25 ％的割线模量的一半的最大应力水平， 23 ％的初始切线模量。

Angular spectral is spectral value map formed by estimating semblable coefficients of fast and slow shear wave or the variation of amplitude ratio of fast and slow shear wave with times and angles at a specified space point based on semblable theory of fast and slow shear wave, the angle value of this space point at a given time can be got by picking the maximum of angular spectral; the study reveals that fast and slow shear wave with different polarization direction should be separated using different rotation formula, eight formulas of separating fast and slow shear wave using clockwise rotation and counterclockwise rotation have been derived, and gained energy assignment rule and phase coincidence rule, in real data estimation, the rotation formula used for separating fast and slow shear wave can be uniquely determined on the two discriminating rules. On the basis of semblable theory of fast and slow shear wave, the delay time corresponding to the maximum of semblable coefficients at a specified point in a given time window is the delay time of fast and slow shear wave, delay time section of fast and slow shear wave can be got by moving space point and smoothing time window. The vertical variation values of delay time of fast and slow shear wave reflect the effect degree of vertical fractured reservoir on fast and slow shear wave which is defined as anisotropic coefficient, and section map of anisotropic coefficient can be obtained.

角度谱就是利用快慢横波的相似性原理，在某一空间点求出快慢横波的相似系数或快慢横波的振幅比值随着时间和角度的变化而形成的谱值图，拾取其极大值就得到该空间点某一时间的角度值；在研究中发现分离不同偏振方向的快慢横波应该采用不同的旋转公式，推导出了利用顺时针旋转和逆时针旋转分离快慢横波的八个公式，并给出了能量分配准则和相位一致性准则两个判别准则，在实际计算中利用这两个判别准则能唯一地确定分离快慢横波的旋转公式；根据快慢横波的相似性原理，在某一给定点和给定时窗内最大相似系数对应的延迟时间就是快慢横波的延迟时间，随着空间点的移动和时窗的滑动就可以得到快慢横波延迟时间的剖面图；快慢横波延迟时间与慢横波传播时间的比值定义为裂缝密度，并求出了裂缝密度剖面图；快慢横波延迟时间纵向上的变化值的大小反映了纵向上裂隙层对快慢横波影响的大小，定义为各向异性系数，并求出了各向异性系数的剖面图。

Results show that amplitude of displacement excited by vertical incidence wave is larger than that excited by inclined incidence wave and not influenced greatly by the incidence angle. In vertical incidence, amplitudes of displacement of two points at the same altitude along each cavern are basically identical and maximum relative displacement occurs between top and bottom point of the cavern. While in the case of inclined incidence, displacement amplitude on sides meeting the wave is larger than that on leed sides, and maximum relative displacement occurs on left skewback and bottom of the cavern.

结果表明，位移幅值受入射角度的影响不敏感，竖直入射比斜入射情况要大；竖直入射时，各洞室两侧同一高程处的位移幅值基本相同，相对位移差最大部位为洞顶与洞底，而斜入射时迎波面比背波面一侧位移大，且相对位移差最大部位为洞室迎波面的左拱座与洞底。

An inductive learning method for classification based on information theory is proposed, which is a maximum contribution classification method according to the theory of channel transmission in information theory, the definition contribution is developed based on probability distribution of classified space, probability transfer matrices of classified space and feature space and mutual information, then entities is classified by the maximum contribution method.

提出了一种基于信息论的归纳分类学习算法－最大贡献分类算法。该算法根据信息论中信道传输的理论，把类别空间和各特征空间的概率转移矩阵以及互信息结合起来，定义了贡献的概念，从而得出了对给定的观测值，用它的最大贡献作为对实体进行分类的规则。

Many will continue to choose to live in duality and in conflict.

许多人将继续选择活在二元对立性和冲突中。

I find that students of the University of Physical Education all wear sportswear at first sight.

我发现：体育大学的学生乍一看，都是穿运动衣，大家都一样