查询词典 maximum condition

The mean, maximum and minimum value of the area of transverse section and the major axis length of ellipse and the maximum centroid displacement can be used to discriminate width of pulse tracing.

长轴长度周期平均值、最大值、最小值，面积周期平均值、最大值、最小值，以及轴心在平行于皮肤表面的最大位移等参数可以作为初步判别脉宽的参数。

Experimental spectra and calculated spectra agree well. The absorption maximum at around 520 nm is corresponding to the transverse surface plasmon resonance, while the absorption maximum at longer wavelength is corresponding to the longitudinal surface plasmon resonance.

计算谱和实验谱基本符合，520 nm左右处的吸收峰对应于金纳米棒的横向表面等离体子共振，长波长处的吸收峰对应于金纳米棒的纵向表面等离体子共振。

In this paper, the maximum likelihood algorithm with process and measurement noise for nonlinear continuous-discrete system given by Jategaonkar and Plaetschke is improved in two aspects: 1 to avoid the disadvantages of sensitivities computation by common finite-difference method, in which the perturbation sizes should be selected optionally, an improved finite-difference method with best perturbations, is presented. 2 to improve the numerical stability of Jategaonkar's algorithm, maximum likelihood algorithm with fast triangular square-root decomposition filter is given.

摘要对Jategaonkar等人给出的同时计及过程及观测噪声的非线性连续-离散系统的极大似然算法从两个方面进行了改进：1给出了计算灵敏度的最佳摄动有限差分算法，避免了普通有限差分法计算灵敏度矩阵时需人为选择参数摄动量大小而带来的缺点；2给出了具有快速三角化平方根滤波的极大似然算法，提高了原算法的数值稳定性。

The fatigue test of CFRP bars was carried out at the different cyclic stress, choose the 70% ultimate tensile stress of CFRP bar as the maximum cyclic stress, under the cyclic ratios of R=0.5 （the minimum-to-maximum stress ratio） and R=0 and the fatigue behavior of CFRP bars was investigated.

进行了不同循环应力下CFRP筋的常温疲劳试验，选取CFRP筋70％的极限拉伸应力作为最大循环应力，在R=0.5（最小循环应力与最大循环应力的比）和R=0的应力率下，测量了CFRP筋的疲劳寿命曲线，研究了CFRP筋的疲劳性能。

The results showed the maximum cyclic stress of CFRP bar should be under 70 percent of ultimate tensile stress; when the maximum cyclic stress decrease 5 percent of ultimate tensile stress, the fatigue life of CFRP bars increase generally 10 times; with the decrease of cyclic ratios, the fatigue life of CFRP bars decrease heavily; for the brittleness, CFRP bar should possess a higher reserve of strength, the margin of safety against failure is a necessity; according to experimental cyclic stress-fatigue life curve, the fatigue behavior of CFRP bar is much better than the fatigue behavior of Q235 steel.

将纤维复合材料用于土木工程结构的研究成果，已应用于实际工程【2j_国外对CFRP筋的一些短期性能以及CFRP筋构件的粘结性能、CFRP加筋混凝土结构的抗弯性能等都做了大量的研究，但对其长国家自然科学基金50278029，50538020和交通部西部交通科技200l431882021资助项目。2OO6年2月13日收到初稿；2006年9月4日收到修改稿。本文联系人：欧进萍，院士期性能如疲劳性能的研究还不够

D1.1 of the AISI Specification limits the maximum longitudinal spacing of connections to ... where smax = maximum permissible longitudinal spacing of connectors L= unbraced length of compression member rI = radius of gyration of I-section about the axis perpendicular to the direction in which buckling would occur for the given conditions of end support and intermediate bracing rcy = radius of gyration of one C-section about its centroidal axis parallel to the web.....

因此，AISI规范第D1.1节限定连接的最大纵向间隙为：，式中 smax =连接体允许的最大纵向间隙 L=抗压构件的自由长度 rI =工字钢对垂直于给定端承和中间肋条件下可能产生纵向弯曲方向的轴的回转半径 rcy =一段U型钢对其平行于筋的质心轴的回转半径。。。。。。。

The maximum number of parts that can be loaded onto a conveyor to ensure maximum powder utilisation.

能够确保粉末最大利用时的装载在输送机上的工件的最大的数量。

1 The output was connected to a variable resistor or electronic load to draw the maximum available output current with all other outputs loaded to maximum normal rating.

6.1 将测试样品所有输出端接至最大额定负载，并将测试的输出端接至可变电阻或电子负载上，拉出最大有效电流。

Ogust (three clubs = minimum, weak suit; three diamonds = minimum, strong suit; three hearts = maximum, weak suit; three spades = maximum, strong suit).

Ogust(3 =低限，弱花色；3 =低限，好花色；3 =高限，弱花色；3 =高限，好花色)。

During your wrap-up step, if you have more cards in hand than the maximum hand size, you must discard until you have only the maximum hand size.

所有人都确认结束以后，最后一件事情就是要保证你手上的牌不多于8张，否则就要放弃掉多余的部分。

The role of the environment is very important.

的作用，环境是非常重要的。

At that time, the High Court of England and Wales Court of Queen's Bench president of William Murray, Lord Mansfield in June 22, 1772 ruling:"No matter then there is the inconvenience, but there must be a decision, I can not say that this case under the law in England are permitted or authorized; are so black should be released."

当时的英格兰及威尔士高等法院王座法庭院长William Murray， Lord Mansfield于1772年6月22日宣判：「无论有那麽不便，但总要有个决定，我不能说这件案在英格兰法律之下是准许或认可；所以黑人是应该被释放。