查询词典 man machine interface

On the base of studying application methods and relative information of the relative chips, the paper designed the system hardware ,including LCD interface designing、video gathering chip and its peripheral circuit designing、FPGA chip and other module interface designing; 3、The LCD controller module、video in controller module、configuration initialized module of the video image decode chip、FPGA and program of module interface were all compiled and debugged in the paper. 4、The whole system debugging was carried through, and the video image data storage and displaying on LCD screen was carried out in the paper. The paper first designed the system frame, then designed hardware platform according to the system frame and then analyzed it、debugged it, finally,compiled the module code and debugged the whole system to achieve system requirements.

本文具体研究工作主要体现在以下几个方面： 1分析了的嵌入式视频图像采集、处理与LCD显示系统的总体需求，设计了基于NIOSⅡ的嵌入式系统总体架构； 2在学习相关芯片的具体应用方法和相关知识的基础上，设计了系统的硬件，包括LCD接口设计、视频采集芯片及外围电路设计、FPGA芯片和其他模块接口主板设计； 3编写并调试了LCD控制器模块、视频输入控制器模块、视频解码芯片初始化配置模块、FPGA和各个模块接口程序； 4进行了整个系统的联调，完成了视频图像数据存储并通过LCD显示；本文首先建立了系统架构，然后根据系统架构进行硬件平台的设计并对硬件平台进行分析和调试，最后编写个模块代码并完成系统联合调试实现系统要求。

All these problems still need to be solved. So, towards the IP Core interface compatibility of SoC Bus standard, this thesis, based on analyzing the interconnection of IP Cores, researches the software capsulation of IP Core Bus interface layer, and implements the IP Core interface layer of embedded system developing platform which is based on layers. In this thesis; the design method, flow, and environment of SoC based on IP demultiplexing is explained. While in order to improve the integration of IP Core on SoC, interconnection rules of IP Core and its standardization are researched.

鉴于此，本文在对IP核互连进行分析的基础上，针对SoC总线标准的IP核接口的兼容问题，研究和设计了IP核总线接口层的软件封装，并将其作为课题组提出的基于层次的嵌入式系统开发平台的IP核接口层予以实现，使上层开发人员可以根据此规范快速开发出基于该开发平台的IP核，也使得遵循该接口规范的IP核在无需了解具体SoC互连信息的前提下即可实现核内传输机制，从而提高了SoC设计的可复用性。

Moreover, different viscoelasticity characteristics at different interfaces for PHPAM solution were also found. Among those three interfaces were experimented, and the order of the numerical value of viscoelasticity from large to small is PHPAM/air interface, PHPAM/dodecane interface and PHPAM/crude oil interface.

聚合物溶液与不同物质所形成的界面具有不同的粘弹性特征，与空气、正十二烷、原油所形成界面的界面扩张粘弹模量E的大小次序为E空气＞E正十二烷＞E原油，即E随着两相密度差的减小而减小。

After detailed expatiation about digital output characteristic, the paper puts forward a set of digital interface scheme. Followingly, the digital interface based on IEC61850 standard is developed.At the bottom of this paper, a calibration experiment is carried out toward the designed digital interface.

在对电子式互感器数字输出特性做了详细阐述之后，提出了一套符合IEC 标准的数字接口实现方案，并研制了基于IEC61850 标准的数字接口。

The interfacial viscosity of HPAM-CTAB system at hexadecane-water interface was much higher than that of HPAM solution alone at hexadecane-water interface, indicating that there exists significant interaction between CTAB and HPAM; perhaps they could form complex which was adsorbed at the hexadecane/water interface, so the interfacial viscosity was increased.

HPAM和CTAB复配体系与正十六烷所成界面的界面粘度要比单一HPAM溶液与正十六烷所成界面的界面粘度要大一个数量级，这表明复配体系中CTAB和HPAM之间存在着明显的相互作用，这可能是因为两者之间形成复合物在油/水界面富集而使界面粘度升高。

Included are Broadband InterCarrier Interface, Interim Local Management Interface, LAN Emulation, network management, Private Network Node Interface, signaling, SMDS (Switched Multimegabit Data Service) and IP over ATM, traffic management, and a number of physical interfaces.

这些技术规范包括宽带载波间接口、临时的本地管理接口、局域网仿真、网络管理、专用网络节点接口、信令、可交换的多兆位数据服务SMDS以及ATM、业务量管理和大量物理接口中的因特网协议IP。

After some time, from the initial thalli places to the oil-water interface, the distribution law of microbial concentration was that the concentration increased monotonicly from the minimum to the maximum, that was to say, the nearer to the oil-water interface, the bigger the microbial concentration, and the concentration was the biggest at the interface.

经过一段时间后，从菌体初始位置至油水界面之间的菌浓分布规律为从最小值单调地上升为最高值，亦即离油水界面越近则菌浓越大，油水界面处菌浓最大。

The results show that mechanical heterogeneity has great influence on the J-integral of welded joint containing transverse crack. The J-integral on the path cross the interface between welded joint and base metal is higher than the J-integral on the paths in the weld metal for undermatched joint,while the J-integral on the path cross the interface between weld metal and base metal is lower than the J-integral on the paths in the weld metal for overmatched joint. Moreover,the difference of J-integral values increases with the increasing of the load and strength mismatching difference and the path-enclosed length of interface between weld metal and base metal.

计算结果表明：力学不均匀性对含横向裂纹焊接接头的J积分有重要影响，低匹配焊接接头中积分路径穿越焊缝与母材界面的J积分值高于积分路径在焊缝内的J积分值，高匹配焊接接头中积分路径穿越焊缝与母材界面的J积分值低于积分路径在焊缝内的J积分值；载荷越大，焊缝与母材的强度差别越大；积分路径中包含的焊缝与母材界面长度越大，J积分的差值越大。

In order to obtain Chinese interface systems optimum efficiency, to make Chinese interface must handle part and whole, orderly and unorderly, structure and function, behavior and purpose relations of interface well.

基于以上理论基础，本文论述了制作语文界面必须遵循的科学性与实用性相结合、统一性与变化性相结合、层次性与交互性相结合、情境性与趣味性、艺术性与个性化等五项原则。

RESULTS: Bone-implant interface in the experimental side showed marked matrix calcifying, indicating new bone formation at 2 weeks and the bony interface formation completed at 6-8 weeks. At 12 weeks, a mature implant-bone interface could be observed.

结果：实验组种植体-骨界面在术后2周即可见明显的新骨形成，术后6～8周，已基本形成骨性结合；术后12周时，可见较为成熟的骨融合。

"Second Life is remarkably easy to work with, and is very popular,"

"第二次生命是显着容易的工作，并且很受欢迎，"

For example, we usually assume that materials are homogeneous and isotropic and free of internal defects or flaws.

为了得到适合有限元分析的模型，我们必须经过如图2所示的简化步骤。