查询词典 leaf beet

The main results were showed as follows:Through screen and identification of morphology in M_2 and M_3, respectively, the mutants with mutative traits of plant were found. In which, 11 mutations were leaf variations, including light-green leaf, deep-green leaf, durative yellowish leaf, temporary yellowish leaf, inlaid yellowish leaf, wrinkly leaf, smooth-edged curly leaf, splitting-shaped curly leaf, peduncular-shaped leaf, round leaf and larger leaf, 12 were mutations on plant type, including excessive branches, lacking branches, highness, dwarf-like, erect posture, reclinate posture, strong stalk, slender stalk, tufty branches, wrinkled plant, purple stalk and hair-covered plant, 14 were flower variations, including dense flowers, light-yellow petals, white petals, white-mosaic petals, wrinkled petales, back-rolled petals, narrow petals, larger petals, smaller petals, apetalous flowers, variable-numbered petals, fertile pistil protraction, sterile pistil protraction and multi-anther, and 5 were physiologic mutants, including genic male sterile, cytoplasmic male sterile, bud-dead, and early and later bloom.

主要结果如下：通过田间M_2筛选和M_3重复鉴定，在田间农艺性状方面共获得浅绿叶色、深绿叶色、转绿黄化叶、持续黄化叶、边缘黄化叶、皱缩叶、光叶型卷叶、裂叶型卷叶、薹叶形叶、宽圆叶和大叶等11种不同的叶部性状突变体；同时还筛选到多分枝、少分枝、高杆、矮杆、株型紧凑、株型松散、粗茎、细茎、丛生分枝、整株皱缩、紫茎、整株被毛等12种植株性状突变体，密花、浅色花瓣、白色花瓣、白斑花瓣、皱瓣、卷瓣、窄瓣、大瓣、小瓣、无瓣、花瓣数目不定、可育型柱头外露、不育型柱头外露和多雄蕊等14种花器性状突变体，以及细胞核雄性不育、细胞质雄性不育、死蕾、早花和迟花等5种生理性状突变体。

The canopy structure and leaf morphological characters of 4 sugarcane genotypes at different leaf layers on seedling were studied by using CI-100 plant canopy instrument and CI-203 area meter instrument. The results showed the leaf morphological parameters, canopy structure and radiation transmission at different leaf layers were notably different among different genotypes. The variation of Ila, Amfi, Dl at different leaf layers were mainly caused by the leaf width at relevant position. The variation of K at different leaf layers was related to Amfi and Dl. The variation of Td（transm. coef. for diffuse penetration）had significant correlations with Ila, Amfi and Dl. The variation of Tr（transm. coef. for radiation penetration）had significant correlations with Dl, leaf width and the ratio of leaf length to width. The variation of Par had significant correlations with Ila, leaf area, leaf width and the ratio of leaf length to width.

摘要利用CI-100数字植物冠层分析仪和CI-203叶面积分析仪测定了4个甘蔗品种不同叶位层的冠层参数和相应叶位叶片的形态特征，结果表明：不同基因型不同叶位层间叶片形态、冠层空间结构和冠层辐射特征存在显著差异，不同叶位层叶面积指数、叶簇倾角和叶分布的变化主要由冠层内不同叶位叶片叶宽的变化引起，而不同叶位层消光系数的变化主要与叶簇倾角和叶分布有关；散射光透过系数的变化主要与叶面积指数、叶簇倾角和叶分布有关，直射光透过系数的变化主要与叶分布、叶宽、长宽比有关，光合有效辐射的变化与叶面积指数、叶面积、叶宽、长宽比有关。

Treatments were as follows: fertilization during leaf-expansion period, fertilization during green-leaf period, and no fertilizer. Results showed that individual leaf area, thousand-leaf weight, and leaf distribution were relatively stable with little influence from fertilization. Fertilization during leaf-expansion compared to the green leaf period significantly increased leaf number, leaf weight per plant, and leaf area index. Fertilization during led-expansion also significantly increased the total weight of leaves corresponding to each branch. The 14th to the 17th branches had the largest number of leaves in the canopy with fertilization increasing the weight of each branch but not changing the center of the canopy.

结果表明：毛竹单叶面积、千叶质量和叶片分布受施肥的影响较小，是较为稳定的指标；展叶期施肥处理（处理1）能显著增加单株立竹的叶片数量，到7月底，其单株立竹叶片总质量和叶面积指数分别比绿叶期施肥（处理2）提高14.8%和13.7%，比不施肥提高27.6%和24.5%；冠层14~17档是单枝叶片数量最多的区域，施肥能增加各枝盘叶片的质量，但对林冠重心的分布无影响；单叶叶面积稳定后（6月），处理1的叶绿素测定值和光合速率显著高于处理2和对照，而处理2与对照间无显著差异。

Compared diploid fodder beet with tetraploid fodder beet, tetraploid plants put up characteristics of bigger and thicker dark green leaf, more folds on leaf, stronger footstalk and so on .we can take those characters as the advancing index in testing tetraploid fodder beet.

饲用甜菜四倍体植株与二倍体植株相比，表现出叶片增大变厚，叶色浓绿，叶面多皱褶，叶柄粗壮等特点，可以将这些特点作为饲用甜菜四倍体田间初步筛选的指标。

Growing character of sugar beet leaf in dry land one influence of cutting different leaf groups on beet root yield,sugar content,microstructure of beet root were studied.

西北甜菜基地是我国的重点制糖基地，甜菜已成为西北地区的骨干经济作物。

"Three distinct types are cultivated: the garden beet, as a garden vegetable; the sugar beet, a major source of sugar and commercially the most important type; the mangel-wurzel, a succulent feed for livestock; and the leaf beet"

所种植的有三种类型︰一、作蔬菜的菜园甜菜；二、制糖的糖用甜菜，是商业上最重要的类型；三、作为牲畜多汁饲料的饲料甜菜

The contents of N, P, K in leaves were examined by regular leaf analysis. The results showed that the N content was higher in leaf blade than in leafstalk. N content in leaf was gradually reduced along with the vine growth. N, F, K fertilized at 20 to 40 cm soil layers significantly increased N content in leaf. But N content in leafstalk was less affected by N fertilization depth and growing season. P content was higher in leafstalk than in leaf blade. Less change of P content was noticed in leaf along with vine growth. However, N, P, K fertilized at 40 to 60 cm soil layers significantly promoted P in both leaf blade and leafstalk. K content in leafstalk was much higher than in leaf Wade. No obvious influence was noticed by fertilizing depth. But K content in leafstalk was significantly increased due to applied K fertilizer in late growing season.

结果表明，酿酒葡萄叶片中氮含量远高于叶柄，叶片中氮素含量随着生育期的延长逐渐降低，而叶柄中氮含量随施肥深度增加和生育期延长而产生的变化很小，40cm的施肥深度能显著增加叶片中氮素含量；叶柄磷素平均含量高于叶片，全生育期叶片磷含量变化很小，而施肥60cm深度显著促进了叶片和叶柄中磷含量的提高；叶柄中钾含量远高于叶片，施肥深度对叶柄和叶片中钾含量未产生明显影响，但生育后期追施钾肥显著提高叶片钾含量；施肥深度达到40cm时酿酒葡萄的产量最高，而60cm的施肥深度产量显著下降。

With the increasing of soil moisture,the individual leaf area,the leaf dried mass per seedling,the leaf fresh mass per seedling and leaf area per leaf dried massincreased,but the leaf thickness and succulence degree decreared;The content of leaf chlorophyll was sensitive to soil moisture,under 5 kinds of different soil moisture status and the content of leaf chlorophyll was ...

结果表明：随着土壤含水率的增加，单叶面积、单叶鲜重、单叶干重、比叶面积逐渐增大，但叶片厚度、肉质度减小；叶片的叶绿素含量对土壤水分状况较为敏感，5种水分处理下苗木叶片的叶绿素含量有较大的差异。

The trials were carried out in field experiment and artificial climate incubator. The sugar beet growth buds were treated at 1～3pairs of true leaves with gibberellin , autix , naphthaleneacetic acid and kinetin , and the plant growth regulating substances enhancing bolting of sugar beet in the first year and its doses were selected out. The sugar beet seedling induced by temperature and light were treated by abscisic acid , maleic hydrazide , uniconazole (S-3307) and paclobutrazol (PP333), and the plant growth regulating substances which make bolting reverse and their doses were screen out. The mechanisms of bolting and bolting reversing were discussed by examining the changes of endogenous hormones, activities of correlative enzyme to bolting, soluble protein, components of amino acid in the protein, components of fatty acid. The results were as follow

本研究通过田间试验和人工气候箱培养相结合的方法，在甜菜幼苗1~3对真叶时利用赤霉素、生长素、奈乙酸和激动素等生长调节物质处理茎生长点，筛选促进甜菜当年抽苔的植物生长物质及剂量；同时利用脱落酸、马来酰肼、烯效唑（S-3307）和多效唑（PP333）等处理经温光诱导当年抽苔的甜菜幼苗，筛选对当年抽苔逆转有效的种类和剂量，并通过测定内源激素含量、相关酶活性、可溶性蛋白质含量和氨基酸组分及脂肪酸含量及其组分的变化，探讨甜菜当年抽苔和抽苔逆转的机理，得到如下结论

In our study,two important lepidopteron pests,beet armyworm and cotton bollworm were surveyed for their endogenous piggyBac.As a result,endogenous piggyBac elements were found in these two insects,and one of the piggyBac elements isolated from the genome of cotton bollworm was intact and thought to be potentially active.1 Clonging and sequence analysis of piggyBac from beet armywormUsing PCR technique,with degenerate primers,a DNA fragment of piggyBac-like element was cloned from the genome of beet armyworm,spodoptera exigua hubner.The DNA fragment was 456bp in length,and the deduced amino acid sequence shares 50%- 78% similarity with other piggyBac elements from insects.But one stop code was found in this DNA fragment.

由于转座子很难用常规的RT-PCR和RACE技术进行克隆鉴定，故本研究在兼并引物PCR的基础上，利用inverse PCR和vectorret PCR技术，不仅调查了鳞翅目两种重要的农业害虫甜菜夜蛾和棉铃虫的內源piggyBac存在情况，同时克隆到了內源性的piggyBac转座子，并且从棉铃虫中获得了一个结构完整、具有潜在活性的piggyBac转座子HaPLE1.1甜菜夜蛾piggyBac转座子基因的克隆与序列分析采用PCR技术，利用兼并引物，从甜菜夜蛾基因组中克隆出一个內源性piggyBac类似因子的DNA片段，并命名为SePLE。

"Second Life is remarkably easy to work with, and is very popular,"

"第二次生命是显着容易的工作，并且很受欢迎，"

For example, we usually assume that materials are homogeneous and isotropic and free of internal defects or flaws.

为了得到适合有限元分析的模型，我们必须经过如图2所示的简化步骤。