查询词典 iteration loop

The quantum amplitude amplification is the generalization of quantum Grover search algorithm. In this strategy, the Grover iteration has been replaced by two different quantum amplitude amplification operations. This makes it possible to collapse the system with probability 1, in other words, with certainty. The measurement operation in this scheme is only used to cancel the phase factor. Finally, one can use the admissible control to drive the system from the eigenstate to the target state and the control task is accomplished.

量子幅值放大是Grover迭代思想的一般化，该控制方案中采用两种不同的量子幅值放大操作替换了Grover迭代，使得期望本征态的概率幅的模在经过一定次数的迭代之后精确的等于1，然后借助于测量来消除相位因子，使系统的波函数确定性的塌缩到期望的本征态，最后再借助幺正演化，将系统从本征态控制到目标态，实现期望的控制任务。

First, one. analyzes the eigenstates-from reachable sets and seeks the one which the target state belongs to. Then using the Grover iteration to amplify the probability amplitude of the desired eigenstate (the modul square of which is the probability of the corresponding eigenstate that the system will collapse to when it is measured). By measuring, the system will then collapse to the desired eigenstate with a probability of almost unity. Finally, one can use the admissible control to drive the system from the eigenstate to the target state.

该策略的核心思想是对本征态能控的系统，通过分析控制目标态与本征态的关系，寻找给定目标态所属的本征态可达集，然后利用量子非结构化搜索的Grover算法，将任意给定的系统初始态经过一定次数的Grover迭代，放大该本征态所对应的概率幅(概率幅的模方对应测量时波函数塌缩到对应本征态的概率)，然后对迭代后的态进行一次测量操作，使系统以接近1的概率塌缩到所需的本征态(前面分析得到的本征态可达集所对应的本征态)，最后用容许的控制将系统从该本征态控制到期望的目标态。

3D reconstruction is one of the most challenging problems in computer vision. This project uses CAD model to increase the accuracy,robustness and speed of 3D reconstruction and five different works are conducted: 1 research on space curve 3D reconstruction method based on high curvature point nad turning point; 2 free-form curve 3D reconstruction based on B-spline and BURBS; 3 Active surface affine reconstruction based on single frame; 4 Matching and reconstruction of 3D sparse points; Data fitting method based on the iteration of nearest point.

三维重建是计算机视觉中公认的难题，本项目使用CAD模型来提高三维重建的精度、稳健性和速度的思路，围绕着空间曲线和曲面的三维重建和匹配开展了以下五个方面的研究：1）基于高曲率点和拐点分割的空间曲线三维重建方法研究；2）基于B样条和NURBS表示的空间自由曲线三维重建方法研究；3）基于单帧图像的有源曲面仿射重建；4）三维离散数据的匹配与重建；5）基于迭代最近点的数据拟合方法。

In solving system of linear algebraic equation with iteration method,the error checking is discussed.

讨论使用迭代法解线性代数方程组的误差检验问题。

The alternating direction implicit method is used to solve discretization equation and supplement block iteration method to quickening convergence.

本文选择交替方向隐式迭代法，并补以块修正技术以促进收敛。

To one kind of variational inequalities, some researchers give an alternating direction method, which solve a linear variational inequality and a system of nonlinear equations in each iteration.

针对一类变分不等式，有研究者给出了一种交替方向法，在每一步迭代中分别要求解一个线性变分不等式和一个非线性方程。

The numerical ex-periment has shown that the number of iterations depends significantly on the positiveparameterα,β. But, in general, it is di?cult to choose a proper parameterα,β. Thuswe propose new self-adaptive alternating direction method which adjusts the scale pa-rameter automatically per iteration based on the message of the iterates. We have provedthe convergence of the method under mild assumptions.Finally, we present some numerical results.

对于我们提出的新交替方向法，数值实验表明，迭代的步数与时间与所取的参数α，β有关，然而我们很难去选择一个合适的参数α，β，因此我们提出新自适应交替方向法，对其中的参数α，β进行自适应调整，这种自适应算法根据每步迭代信息自动地调整参数α，β，并证明了算法的收敛性。

The output current of the alternator at different speed is computed by an iteration method.

用迭代的方法计算出发电机负载不同转速时的输出电流。

"On Integral Equations, their Solution by Iteration and Analytic Continuation".

在 1971 年，Alan 加入耶鲁大学计算机科学系，并在 1976 年到 1980 年出任计算机系系主任。

As well as in previous work, we reduce this problem with the Schr\oder transformation to finding analytic solutions of a functional equation without iteration of the unknown function $f$.

通过Schr\{o}der变换把方程转化为不含未知函数迭代的函数方程，进而求出方程的解析解。

The statistical analysis of this large set of mutations has led us to propose a diagnostic strategy that should help with the molecular work-up of optic neuropathies.

这一大系列基因突变的统计学分析引导我们提出一个诊断策略，可以帮助我们对视神经病变进行分子学的诊断检查。

The results show that the pipe grouting changes the mechanical parameters of surrounding rocks to achieve the security of engineering objectives by reinforcing surrounding rocks and bolcking the water.

研究表明：小导管注浆一方面改变了围岩的力学参数，另一方面利用浆液的固结特性可以实现堵水和加固围岩的工程目标，使隧道在开挖过程中的安全得到保障。