查询词典 increasing function

Nowadays, fault current is increasing with the increasing of capacity in power system, and it is one of the serious problems, which must be solved.

近年来，随着电力系统容量的不断增加，电网的短路电流也随之增大，目前已成为制约电网运行和发展的一个重要因素。

CO production rate increased with increasing sprinkler pressure, and decreased with increasing extraction rate of the fan under controlling fire.

控火时，CO生成量随着水喷淋压力的增加而增加，随着风机风量的增加而降低。

The effect of the tool composition on the friction and wear behavior was investigated,and the morphologies of the rake face and rear face of the tool cutting the steel in air and nitrogen were observed on a scanning electron microscope. It was found that the Al_2O_3/TiB_2 tool was dominated by adhesive and abrasive wear in low speed dry cutting; while in high speed dry cutting,the tool was characterized by oxidation wear. An oxide layer of TiO_2 was formed by way of the oxidation of the reinforcing agent TiB_2 at a very much high cutting temperature, which contributed to greatly reducing the friction coefficient and increasing the antiwear life of the tool.Such a friction-reducing and antiwear behavior of the oxide layer was enhanced with increasing content of TiB_2 in the tool composite. However,the tool showed a relatively poorer wear resistance in N_2 than in air, because N_2 acted to retard the oxidation of the TiB_2 and the formation of the oxide layer on the tool rake face.

结果表明：低速干切削时，Al2O3/TiB2陶瓷刀具的磨损机制主要表现为粘着磨损和磨料磨损；而在高速干切削时，刀具的磨损机制主要表现为氧化磨损，刀具表面经由氧化反应生成具有润滑作用的反应膜而起到固体润滑作用，从而使刀具的耐磨性能提高，随着TiB2含量和切削速度的增加，反应膜的减摩抗磨作用增强；而在切削区通入氮气时，由于刀具表面氧化膜形成受阻，刀具的抗磨能力有所降低。

The experimental results indicate that, over a ranger of tube side Reynolds number and Prandtl number (Re=4000~20000, Pr=6~7.5), the internal Nusselt number and friction factor of spiral-flat tube increased by 30%-150% and 20%-50% respectively compared with smooth tube at the same Re and Pr. The value of friction factor decreases with increasing the value of B/A as well as increasing that of S/de, and the same phenomena can also be observed for Nusselt number.

实验结果表明：管内Nu和f值均随均随B/A值和S/de值的增大而减小，但随B/A值的增加而减小得更快，B/A值对螺旋扁管管内传热与流阻性能影响更大；在相同Re和Pr下，螺旋扁管管内Nu数为光滑管的1.3～2.5倍；阻力系数f是光滑管的1.2～1.5倍。

The age class structure of Salix oritrepha population in alpine, cloudy and wet area of east Qilian Mountian is studied ,on two levels of genets and their ramets and sprouting branches .The results show that genets population is very short of the first and second class seedlings,and most of seedlings belong to the third and forth classes, and the development trend of population on this level is stable;on the other hand,the age structure of remets and sprouting branches population is more complete,and its age class distribution chart likes triangle, belonging to increasing type.In general,Salix oritrepha population in this area is increasing, but its reproduct way have changed in community succession process in order to accommodate varying circumstances.

从无性基株个体种群和无性克隆分株及萌生枝种群两个层次上对东祁连山高寒阴湿地区山生柳种群年龄结构进行分析，结果表明：无性基株个体种群 0~10 龄级幼苗贮备严重不足，11~20 龄级苗木所占比重最大，种群动态呈稳定型；无性克隆分株和萌生枝种群年龄结构比较完整，结构分布图呈正三角形，种群动态表现为增长型；总体上来讲山生柳种群呈增长趋势，只是在演替过程中为适应环境其繁殖方式有所改变，导致现阶段山生柳种群两个层次结构状态。

The copolymer derived from the copolymerization in high capacity kettle were testified that copolymerization between AN and MMA occurred. The microcapsules in the films are distributed in the copolymer film matrix. The heat-absorbing temperatures and heat-evolving temperatures of the films are almost the same as that of the MOCT, respectively. In addition, the enthalpy efficiency of MOCT, the melting enthalpy and the crystallizing enthalpy rises with the contents of MOCT increasing.The decomposition temperature of copolymers in the films containing various contents of MOCT decreases with the contents of MOCT increasing.

采用30升聚合釜合成了丙烯腈—甲基丙烯酸甲酯共聚物，证实了丙烯腈和甲基丙烯酸甲酯发生了共聚反应；正十八烷微胶囊分散和镶嵌到了共聚物膜基体中；正十八烷微胶囊含量不同的共聚物膜的吸热温度放热温度与纯正十八烷微胶囊的吸放热温度基本相同；随着正十八烷微胶囊含量的增加，共聚物膜的热焓和热效率逐渐增加；共聚物膜中的共聚物的热稳定性温度随着正十八烷微胶囊含量的增加逐渐减小，共聚物膜的结晶度则有所增大。

Hysteresis coefficient decreased both with increasing Al and Mn and decreasing Y at a given temperature and with increasing temperature at a given sample.

在相同的温度下，滞后系数随着Al、Mn浓度的增加而减小，随着Y浓度的增加而增加；对于同一组分合金，滞后系数随着温度的升高而增加。

Hysteresis coefficient decreased both with increasing Al and Mn and decreasing Y at a given temperature and with increasing temperature at a given sample.

在相同的温度下，滞后系数随著Al、Mn浓度的增加而减小，随著Y浓度的增加而增加；对于同一组分合金，滞后系数随著温度的升高而增加。

The application of cold flow improvers is important for increasing the production of diesel fuel and improving the diesel fuel/gasoline ratio and increasing the economic benefit of finery.

其中，在T1804基础上复配的柴油蜡晶分散剂的降低冷滤点效果优于T1804，合成的物质对石家庄柴油具有很好的降滤效果，并对它们的作用机理进行了讨论。

The calculating results indicate that surrounding rock initial stress has an obvious influence on interior force of invert center, interior force increases with the vertical force increasing in both side of invert center, and decrease with horizontal force increasing in interior side , unchangeable in outer ...

计算结果表明，围岩初始应力场对仰拱受力有明显影响，随着竖向压力的增大，仰拱中心的内、外侧应力均增大；随着水平压力的增大，仰拱中心内侧应力减小、外侧应力基本不变；减小复合衬砌结构中初期支护厚度以及变刚性接头为柔性接头均会改善仰拱受力。

Many will continue to choose to live in duality and in conflict.

许多人将继续选择活在二元对立性和冲突中。

I find that students of the University of Physical Education all wear sportswear at first sight.

我发现：体育大学的学生乍一看，都是穿运动衣，大家都一样