查询词典 holder-on

There are series of papers studying the solvability of an incompressible, viscous, instationary fluid contained in a domian bounded entirely by a free surface. In 1977, Solonnikov proved its local solvability in a Holder space for any initial date but without surface tension. In 1984, he considered the same problem in a Sobolev space with surface tension being taken into account. In I992, Mogilevskii and Solonnikov treated the same problem in a Holder space, where the coefficient of surface tension is not a constant. There are also short-time existence results for the solvability of an incompressible, vicous, unsteady fluid bounded above by a free surface and below by a fixed bottom which approach horizontal planes at infinity. In 1981, Beale proved its local solvability in a Sobolev space for any initial date but without surface tension. In 1983, Allain were concerned with the same problem in R〓 with surface tension but under the assumption that the initial fluid domain was near a horizontal strip. In 1987, he obtained the same result without the preceding assumption. In 1996, Tani solved the same problem in R with surface tension. For the solvability of an incompressible viscous instationary fluid in Ω R bounded inside by a free surface S and outside by a rotating boundary S, in 1995 Ciuperca proved its local existence in a Sobolev space for any initial date but without surface tension. In this paper, we consider the same problem with surface tension.

对于边界完全是由自由边界组成的有界区域中粘性不可压流体的非定常运动问题，Solonnikcv于1977年在忽略表面张力情况下证明了初值问题小时间解在Holder空间的存在性，于1984年在有表面张力情况下证明了初值问题问题小时间解在Sobolev空间的存在性，Mogilevskii和Solonnikov于1992年在表面张力系数可以不是常数情况下证明了初值问题小时间解在Holder空间的存在性；对于上面是自由边界、下面是固定边界且两边界在无限处趋于水平的无限区域中粘性不可压流体的非定常运动问题，Beale于1981年在忽略表面张力情况下证明了初值问题小时间解在Sobolev空间的存在性，Allain于1983年在有表面张力情况下证明了R中初值问题小时间解在Sobolev空间的存在性，但其中假定初始区域近似是个水平条，他于1987年去掉了这个假定得到同样的结果，Tani于1996年在有表面张力情况下证明了R中初值问题小时间解在Sobolev空间的存在性；对于R中内面是自由边界、外面是旋转边界S的有界区域中粘性不可压流体的非定常运动问题，Ciuperca于1995年在忽略表面张力情况下证明了初值问题小时间解在Sobolev空间的存在性，本文考虑了在有表面张力情况下初值问题可解性问题。

After the round , Burke, the "Kid's" sponge, sponge-holder, pal, Mentor and Grand Vizier, drew him out to the bootblack stand at the saloon corner where all the official and important matters of the Small Hours Social Club were settled.

大家饮下酒后， Burke，"Kid"的酒友， sponge-holder，把兄弟，师傅和总督把他拉到美容店角落一个擦皮鞋摊旁，这儿是所有" Small Hours Social Club"官方重要事件裁定的地点。

By improving the Holder condition which the divided differences of order one satisfy,we obtain radius of convergence ball the uniqueness ball.All the theoretical conclusions are tested and verified by a numerical example.

通过改进一阶差商所满足的Holder连续条件，得到了两点弦截法的收敛球半径和方程具惟一解的球半径，并用数值例子验证了理论结果。

Oh well, we're Slade - I'm Noddy Holder!

那么我们就是Slade，我就成了Noddy Holder。

Gary Glitter needs an even better PR team than Jade Goody if he's ever going to get back in the charts, Noddy Holder is too busy promoting his nuts to pick up a guitar, and The Fratellis are rubbish.

比起Jade Goody ，Gary Glitter需要的是好的制作团队，他们能让他重回排行榜；Noddy Holder忙得没有时间碰吉他；The Fratellis是垃圾。

Our factory main products are: plastic lamp holder E14, E27 Series, ceramic lamp holder series (such as lawn lamp holder, quartz lamp holder, halogen, Block, etc.), bakelite lampholder E12, E14, E17 series, energy-saving lamp lampholders Series , all kinds of accessories switch, line caps, line clasp, clamp and other products.

我厂的主要产品有：塑胶灯头E14、E27 系列、陶瓷灯座系列（如草地灯座、石英灯座、金卤灯座等）、胶木灯座E12、E14、E17系列、节能灯灯座系列，各种配件开关，线帽，线扣，线夹等产品。

Trans-Blot Cells and Systems 170-3825 Trans-Blot Cell With Wire Electrodes and PowerPac HC Power Supply, 100120/220240 V, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm), power supply, power cord, instructions 170-3850 Trans-Blot System With Plate Electrodes and PowerPac HC Power Supply, 100120/220240 V 170-3853 Trans-Blot System With Plate Electrodes, Super Cooling Coil, and PowerPac HC Power Supply, 100120/220240 V, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm), power supply, power cord, instructions 170-3910 Trans-Blot Cell With Wire Electrodes, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) 170-3939 Trans-Blot Cell With Plate Electrodes and Super Cooling Coil, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) 170-3946 Trans-Blot Cell With Plate Electrodes, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) Trans-Blot Cell Accessories 170-3912 Super Cooling Coil, required for all high-intensity transfers 170-3913 Gel Holder Cassette, includes 2 fiber pads 170-3914 Fiber Pads, 15.5 x 20.5 cm, 6 170-3920 Trans-Blot Standard Wire Electrode Card, cathode 170-3921 Trans-Blot Standard Wire Electrode Card, anode 170-3922 Trans-Blot Cell Buffer Tank 170-3923 Trans-Blot Cell Lid With Power Cables 170-3943 Trans-Blot Platinum Anode Plate Electrode 170-3944 Trans-Blot Stainless-Steel Cathode Plate Electrode 170-3945 Trans-Blot Plate Electrode Pair, platinum anode and stainless-steel cathode 16 规格:说明: Trans-Blot Plus

电泳转印槽组件 1。缓冲液槽及带有电缆的盖 2。凝胶支架转印夹 3。纤维衬垫 4。电极丝 5。电极板 6。特级冷却芯 Trans-Blot 转印槽是功能灵活的转印设备，可理想地用于多种转印应用。Trans-Blot 转印槽特点包括：*能进行多胶转印，可容纳3 块PROTEAN I xi 凝胶、6块Criterion 凝胶、12块Mini-PROTEAN 3 或Ready Gel 预制胶*多组参数灵活可设，可调节的电压设置（从30 V 的过夜转印到200 V 的1 小时快速实验）*电极间距设置为8 cm 用于标准印迹杂交，或设置为4cm 用于高强度印迹杂交*可选择板式电极：涂有铂金的钛作为正极，不锈钢为负极，能提供高强度电场和比其它电极更高的电流密度。或选择较经济的铂金电极丝*通过特级冷却芯和水循环仪来调节温度―是天然酶（4°C）或高强度转印的理想选择，随着转印时间增加（多达24 小时），不会引起缓冲液耗竭（在高强度转印中必须使用冷却芯，也推荐用于所有板式电极的应用）*带铰链的凝胶支架转印夹能避免滑动，确保凝胶与印迹膜间的紧密接触；每个转印夹都有颜色标记以保证在转印槽中的正确定位 Trans-Blot 转印槽的锁闭凝胶支架转印夹系统。转印夹（1）支撑凝胶（2）印迹膜（3）两侧有纤维衬垫和滤纸（4）确保凝胶三明治内的完全接触。凝胶夹垂直插入缓冲液槽中（5）。

A miniature motor 1 includes: a motor case 2; a gear case 5 connected to the motor case 2, for pivotally supporting an output shaft 15; a brush holder 30, 30 ' for holding a brush 17 and attached to the gear case 5; and a brush holder attaching portion 7, 7 ', which is formed into a recess-shape, into which the brush holder is press-fitted in the axial direction of the output shaft, the brush holder attaching portion being formed integrally with the gear case.

本发明公开了一种微型马达(1)，包括：马达壳体(2)；连接到马达壳体(2)上的齿轮箱(5)，用于可枢转地支撑输出轴(15)；电刷托架(30、30′)，用于保持电刷(17)并安装到齿轮箱(5)上；以及电刷托架安装部分(7、7′)，该安装部分形成为凹陷形状，电刷托架沿着输出轴的轴向压配合到该安装部分内，电刷托架安装部分与齿轮箱一体地形成。

In the case that the oscillation factor isn't sign reversal and neutral factor is p, by discussing the sign of the neutral term's first derivative and using Holder inequality the oscillation conditions of the all solutions of this kind of equation are studied, three sufficient theories that all solutions of the equation oscillate are obtained.

在振动因子q保号、中立型因子p的情况下，通过对中立型项一阶导数符号的讨论，根据Holder不等式，研究了该类方程的解振动的条件，得到了所研究方程所有解振动的三个充分性定理，所得结论是对该类问题已有结论的进一步完善和推广。

After the round , Burke, the "Kid's" sponge, sponge-holder, pal, Mentor and Grand Vizier, drew him out to the bootblack stand at the saloon corner where all the official and important matters of the Small Hours Social Club were settled.

大家饮下酒后， Burke，&Kid&的酒友， sponge-holder，把兄弟，师傅和总督把他拉到美容店角落一个擦皮鞋摊旁，这儿是所有& Small Hours Social Club&官方重要事件裁定的地点。

He is the most remarkable man that I have ever known.

他是我知道的人中最值得注意的人。

Increased appearance of lymphocele was noticed in patients with diabetic nephropathy, congenital malformations of the urinary tract, and inflammatory diseases, including glomerulopathy and extraglomerular ones, after high-voltage radiotherapy and after removal of the renal graft.

经过高压放射疗法和切除移植肾后，在糖尿病肾病患者、泌尿系统先天性畸形患者和炎症患者身上发现淋巴囊肿有所增加，包括肾小球病和球外疾病等。