查询词典 function and power

Aiming at this problem, the concept of the second order power spectrum was proposed based on the characteristic of the amplitude tune with periodical notch spectrum in thin layer and theoretically researched. The corresponding relationship between the thickness of thin layers and the maximum value of second order power spectrum was established. The theoretical criteria and method for the thickness estimation by second order power spectrum were given. The second order power spectrum map is made by the energy relationship between the thickness of thin layers and the second order power spectrum, and the time responding to strong energy on the map is the time of thin layer.

为此，从薄层振幅调谐具有周期性陷频谱特征出发，提出了二阶功率谱的概念，从理论上对薄层的二阶功率谱特征进行了研究，建立了薄层厚度与二阶功率谱极大值之间的对应关系，给出了利用二阶功率谱进行薄层厚度预测的理论依据和方法，即根据薄层厚度和二阶功率谱的能量关系制作二阶功率谱图，图上强能量团对应的时间即为薄层时间厚度。

Buck and Boost topology switching power conversion circuits as the core of this system, ultra low power MSP430F1222 microcontroller-based controller, microcontroller produced by the PWM pulse width modulation signals, respectively, two-way control switch voltage conversion circuit the turn-on and turn-off in order to achieve the above two kinds of topology switching power conversion circuit, and then to draw power from the flow of electrical energy has been filled into the rechargeable battery, and using microcontroller A / D input voltage implementation of the monitoring, according to the input voltage switching buck - circuit at a lower cost to achieve a highly efficient energy transfer, and the circuit is simple, the parameter to determine easy, self-low power consumption,to achieve full-featured.

本系统以Buck降压和Boost升压拓扑结构开关电源变换电路为核心，以超低功耗单片机MSP430F1222为主控器，由单片机产生PWM脉宽调制信号，分别控制两路电压变换电路中开关管的导通与关断从而实现以上两种拓扑结构开关电源变换电路，进而从一直流电源中吸取电能充入可充电电池，并利用单片机A/D对输入电压实施监测，根据输入电压切换升降压电路，以较低的成本实现了高效率的电能转移，并且电路简单、参数确定容易，自身功耗低，实现功能完整。

On the basis of analysis on the dynamic frequency after power vacancy,the reason of unideal function of traditional device are dissected: it is set by using assumed load and power vacancy.The changed range of real load power and real power vacancy lead to big error.

在对电力系统出现功率缺额后的动态频率特性进行分析的基础上，剖析了传统低频减载装置动作效果不理想的原因：用假定的负荷和假定的功率缺额整定，由于实际负荷功率和实际的功率缺额变化幅度很大，而造成很大的误差。

This can also be divided into two categories: one is to discuss the influence of power factor by way of dividing power circuit into capacitive and emotional under the circumstance of unchangeable voltage and frequency of output power, and the other is discussed the influence from voltage and frequency of power to power factor with the situation of constant component parameters.

具体又分为两种情况：一种是在电源的输出电压和频率都不变的条件下，把电路分为容性和感性，讨论了元件参数对功率因数的影响，另一种是讨论了在元件参数不变的条件下，电源的频率和电压对功率因数的影响。

In the present paper,the goal applies in the development in the mixed style battery cocurrent of motor driver design in the electrically operated bicycle,the use lead-acid battery and the LiFePO4 battery takes the main actuation power to originate,the iron phosphate lithium battery has the life to be long,the electric discharge power is big and the transformation power suits the high electric current product good the characteristic;The lead-acid battery is in a market condition the quite mature battery product has the high security in the thermostable characteristic,and designs a driving circuit to actuate the cocurrent to have brushes the motor to lead the bicycle advance,comes in the enfilade non-ascent road section use LiFePO4 battery as the actuation electric power to originate,in had the ascent road section use lead-acid battery to come as the actuation electric power to originate, has promoted bicycle's endurance and reduces accumulator cell's energy loss.

本论文中，目的在研制应用於混合式电池於电动自行车之直流马达驱动器设计，使用铅酸电池与磷酸铁锂电池来作为主要驱动动力来源，磷酸铁锂电池具有寿命长、放电功率大及转换功率佳适合高电流产品的特点；铅酸电池为一市面上相当成熟的电池产品具有高度的安全性於耐高温的特性，并设计一驱动电路来驱动直流有刷马达来带动自行车前进，於直路无斜度路段使用磷酸铁锂电池来作为驱动电力来源，於有斜度路段使用铅酸电池来作为驱动电力来源，提升了自行车的续航力和降低蓄电池的能量损耗。

SD series power inverters for tale communication facilities are devices that invert mains supply and battery power into uninterrupted and filtered AC power to provide computer and other electric equipment with continuous power supply in the case of unstable mains supply and power failure.

SD系列通信逆变电源设备是一种将市电及电池的电能转化为不间断的、净化的交流电能的变换装置，用以给计算机和其他电气设备提供可使用的连续交流电源，以备市电的不稳定及断电。

The article presents the cause of the formation of market power in electric power market, the relation between scarcity and market power, and the analysis methods of market power, enumerates several mitigatory measures of market power and analyzes advantages and disadvantages of them.

对电力市场中市场势力的形成原因、市场势力与稀缺性的关系以及市场势力的分析方法进行了研究探讨，列举了几种平抑市场势力的方法，并对各种方法的优缺点进行了分析，为我国电力市场的规范发展提出了建

The following exciting results are derived: 1 When considering the influence of some nonlinear elements such as hard-limit of exciters, the effects of some devices such as Power System Stabilizer, Unified Power Flow Controller and Static Var Compensator as well as using real parameter values of power systems in simulation , the SNB surface and the HB surface on the boundary of small signal stability region will turn close to each other and even coalesce together; 2 Under some conditions, coupling between slow exciters and shunt capacitors will bring negative damping in power system dynamics, which increases the possibility of oscillatory instability, so that a power system with mass shunt compensators is easily subjected to the oscillatory instability.

同时发现：1 系统中的慢速励磁，在某些情况下会与并联补偿电容器组产生负阻尼现象而显著降低系统的动态性能，大大增加系统出现振荡失稳的可能性；2 在采用较多并联电容器组补偿的电力系统中，更容易出现振荡型失稳。

Load model is representation of the relationship between the power and bus voltage. Load characteristics of power system have a significant effect on power system analysis of power flow and stability that includes transient stability, voltage stability and dynamic stability. The accurate load characteristics will help engineer to analysis power flow and stability.

中文摘要负载模型可反映负载功率和电压之间的相互关系，电力系统的负载特性对系统负载潮流及稳定度包括暂态稳定度、电压稳定度及动态稳定度的分析皆有著重大的影响，准确的负载特性将有助於电力工程人员在负载潮流与稳定度之模拟分析。

By producing pseudorandom number series, we rectify the power spectrums of normal random inputs in the same shape as power spectrums of simulating signals. Through Laplace transformation, we can acquire the frequency response functions of rectifier. Two simulating examples were presented. The power spectrum curves based on one peak function model were almost coincided with the power spectrum curves of simulating loads shown in the figures. Simulating results of input loads had good accuracy. Creating a simulating method and program of input load in this paper was effective.

本文利用随机过程仿真的一般理论在已知随机载荷的分布特性、均值、方差和功率谱函数以后，实现随机载荷的计算机仿真，即利用仿真技术得到符合已知载荷的分布特性和功率谱特性的随机载荷的时间序列。1 产生伪随机数序列及分布整形采用乘同余法产生伪随机数的递推公式为[2 ] ：yi+1 =λyi ( 1 )式中M =2

After explaining total design of automated test system for microcircuit , the thesis introduces GPIB standard .

文章在说明了微电路模块自动测试系统的总体设计后，对GPIB标准进行了介绍。

He interceded in my behalf.

他替我说情。