查询词典 finite base

In Chapter 2, we will give an introduction into the theory of Diophantine approximation for formal Laurent series over a finite base field.

在这一节，我们发展一些重要的基本性质，例如：广义Borel-Cantelli引理及数论中类似的结果等。

ECC system makes use of the finite group of elliptic curve on the finite field instead of finite cyclic group used in the discrete logarithm problem. The theory of ECC is being studied a lot and it is the focus of the cryptography and the industrial estate, especially the technique of the implementation of ECC.In this thesis, the meaning of the information technology is discussed firstly, then we analyze the classical cryptography algoritham. After that, the mathematics base of elliptic curve cryptosytems are introduced, especially the theory of the finite field. As for some algorithms, we also give out the program of reliazation.

随后，介绍了研究椭圆曲线密码系统所需要的数学理论基础，特别是有限域中的椭圆曲线理论，并对相关的方法给出相应的实例及其程序实现；论文第三章讨论给出了椭圆曲线密码体制的研究现状，综述了椭圆曲线与现有一些密码算法的结合，介绍了椭圆曲线的离散对数问题以及椭圆曲线面临的攻击，详细描述了椭圆曲线密码系统的实现细节及各个部分的实验数据。

This thesis is concerned with metric Diophantine approximation for formal Laurent series over a finite base field.

我们将在本论文中探讨有限体下正规Laurent级数上的Diophantine逼近。

The finite element model of base plate is used in modal analysis and transient dynamic analysis by means of the elasticity finite element method.

同时运用弹性力学有限元法对座钣建立的有限元模型进行模态分析和瞬态动力学分析。

Some important factors in finite element analysis, such as the quality of meshing andtime-step, are studied and analyzed deeply, which is the base of correct finite elementcomputation.

对影响有限元分析的有关重要参数(如，网格尺寸、网格比例、时间步长等)进行了深入的研究和讨论，为正确地进行有限元计算提供了重要依据；在模型验证的基础上，分别利用模拟器对裂缝半长、导流能力对产能的影响进行了模拟研究，得出了有意义的结论。

At the same time,the finite element model of base plate is used in modal analysis and transient dynamic analysis by means of the elasticity finite element method.

为了优化发射器座钣的结构设计，采用有限单元法对某型号发射器座钣三维空间板壳结构进行了整体三维建模，同时运用弹性力学有限元法对座钣建立的有限元模型进行模态分析和瞬态动力学分析。

With consideration of various analysis methods for reinforced embankment, the model of homogeneous earth slope is setup on the base of Finite Element Method. Using ANSYS-APDL language, the nonlinear finite element program for static analysis of the high reinforced embankments is made in this paper.

在综合考虑加筋路堤各种分析方法的基础上，利用ANSYS的APDL语言，建立了基于有限元法的加筋路堤参数化模型，编写了对加筋路堤进行稳定性分析的非线性有限元程序，并且综合各种影响因素对加筋路堤结构进行优化设计。

This paper is on the basis of analysedding and summarized that these projects were blown up and tested materials in the past, use fracture mechanics, the dynamics blast theory and finite element analytical method, have carried on the system, detailed analysis and describes to this kind of method of blasting, proving theoretically that can cut the base rock effectively in this kind of method of blasting, reduce base blowing up stress value inside the rock , play and protect underpart base rock blow up into the function influenced in vibration, and blew up mechanism and analysed the main influence factor blown up according to it, had put forward the rational optimization measure to the relevant parameter when implementedding and blown up .

本文在分析总结以往这些工程爆破试验资料的基础上，运用断裂力学、爆破动力学理论及有限元分析方法，对这种爆破方法进行了系统、详细的分析及论述，从理论上证明此种爆破方法可以有效地切割基岩面，降低基岩内部的爆破应力值，起到保护下部基岩不受爆破振动影响的作用，并根据其爆破机理分析了爆破的主要影响因素，对实施爆破时的相关参数提出了合理的优化措施。

After take analyzed deeply for the opened magnet circuit with FEMM (Finite Element Method Magnetics) we find out the field distributing that is separated into three sections . One is the main area what we called as positive field section. Beside the main field there are tow areas that are called the inverted field sections. Loudspeaker arise a very serious distortion when the voice coil moving into inverted field areas. The direction of induced current in the coil part of entered inverted field area is same with the current driving into loudspeaker so that total currents increas largely and heat increase rapidly. With more coils moving into inverted area the voice coil will take on negative inductance properties. It is the main reason that voice coil is burned by heating with increasing current due to arise negative inductance. So opened magnetic circuit is not suitable for the woofers in which the voice coil have wider displacement range. When using this kind magnetic circuit design, the voice coil moving range should be less than the range of positive field to avoid loudspeaker arise serious distortion and heating. Even though voice coil moving range is in the positive area, loudspeaker will still arise more distortion because the field distribution is very cliffy at tow sides of the positive area and full range of magnetic field distribution is not parallel that will arise distortion. Base on above reasons, opened magnetic circuit is not an ideal magnetic circuit for low-frequency loudspeakers. But it can be used in mid-range or high-frequency productions.

开式磁路是由2片钕铁硼磁铁和主导磁板和导磁垫片组成，我们在实践过程中发现这种磁路结构不适合于低频扬声器的使用，我们通过使用FEMM（Finite Element Method Magnetics）软件包对该磁路进行了分析，该磁路的磁场范围被分成3个区域，其中在主导磁板附近形成一个正向磁场，在正向磁场的两边存在反向的磁场，音圈在工作时有很大一部分进入了反向磁场中，在反向磁场内线圈的感应电流方向与驱动电流方向相同，使得音圈呈现出负感抗特性，由于音圈的负感抗特性引起电流的增加导致音圈发热甚至烧毁，因此在扬声器中使用开式磁路时，音圈的运动范围应控制在正向磁场范围之内，否则音圈运动到反向磁场区域时将会产生很大的失真和发热，即使在设计时已经将音圈的运动范围控制在正向磁场范围之内，由于正向磁场的2个边缘磁场强度衰减太快，同时开式磁路中磁场的分布不是平行的，而是自由发散的分布，这样肯定会导致扬声器的非线性失真，因此我们得到的结论是：开式磁路并不是一个理想的磁路，它不适合于低频扬声器的使用，但它还可以应用于中高频扬声器。

The opened magnetic circuit is composed as tow NdFeB permanent magnets and a top plate without U-yoke. After take analyzed deeply for the opened magnet circuit with FEMM (Finite Element Method Magnetics) we find out the field distributing that is separated into three sections . One is the main area what we called as positive field section. Beside the main field there are tow areas that are called the inverted field sections. Loudspeaker arise a very serious distortion when the voice coil moving into inverted field areas. The direction of induced current in the coil part of entered inverted field area is same with the current driving into loudspeaker so that total currents increas largely and heat increase rapidly. With more coils moving into inverted area the voice coil will take on negative inductance properties. It is the main reason that voice coil is burned by heating with increasing current due to arise negative inductance. So opened magnetic circuit is not suitable for the woofers in which the voice coil have wider displacement range. When using this kind magnetic circuit design, the voice coil moving range should be less than the range of positive field to avoid loudspeaker arise serious distortion and heating. Even though voice coil moving range is in the positive area, loudspeaker will still arise more distortion because the field distribution is very cliffy at tow sides of the positive area and full range of magnetic field distribution is not parallel that will arise distortion. Base on above reasons, opened magnetic circuit is not an ideal magnetic circuit for low-frequency loudspeakers. But it can be used in mid-range or high-frequency productions.

开式磁路是由2片钕铁硼磁铁和主导磁板和导磁垫片组成，我们在实践过程中发现这种磁路结构不适合于低频扬声器的使用，我们通过使用FEMM（Finite Element Method Magnetics）软件包对该磁路进行了分析，该磁路的磁场范围被分成3个区域，其中在主导磁板附近形成一个正向磁场，在正向磁场的两边存在反向的磁场，音圈在工作时有很大一部分进入了反向磁场中，在反向磁场内线圈的感应电流方向与驱动电流方向相同，使得音圈呈现出负感抗特性，由于音圈的负感抗特性引起电流的增加导致音圈发热甚至烧毁，因此在扬声器中使用开式磁路时，音圈的运动范围应控制在正向磁场范围之内，否则音圈运动到反向磁场区域时将会产生很大的失真和发热，即使在设计时已经将音圈的运动范围控制在正向磁场范围之内，由于正向磁场的2个边缘磁场强度衰减太快，同时开式磁路中磁场的分布不是平行的，而是自由发散的分布，这样肯定会导致扬声器的非线性失真，因此我们得到的结论是：开式磁路并不是一个理想的磁路，它不适合于低频扬声器的使用，但它还可以应用于中高频扬声器。

I can't say anything hurtful about anyone.

我不能说任何伤害人左右。

She was a short fat woman , garbed in a very tight , very gaudy red dress .

大冬天的，我们穿两件毛衣她却穿件短袖，不停地扇扇子，一个劲叫热。