查询词典 fault analysis

The fault mode and f ault tree analysis for large turbogenerators are carried out by ways of su bsystems, subcomponent s and fault trees, which can be used to supply enough diag nostic rule sources and theoretical base for the study of fault diagnostic exper t system of large turbogenerators.

按照分系统、分部件的方式，并引入故障树的方法，对大型汽轮发电机展开了有关故障模式和故障树的分析，从而最终为大型汽轮发电机故障诊断专家系统的研究提供足够的诊断规则来源和理论基础。

At the same time, on the base of analysis of the present situation, the development trend and the leading edge technology, the necessity and feasibility about the exploitation of the full hydraulic bulldozer"s sate monitoring and fault diagnosis system is given; According to the structure, working feature and working environment, it works out system schema and system composition; The system is divided into display module, communication module and fault diagnosis module by means of block design, the implementation method and key parameter are also given; In light of the features of the full hydraulic bulldozer, the state monitoring and fault diagnosis platform composed of controller RC6-9 and display DI2/10 is designed based on CAN-Bus and the hardware design is completed; It lists the measured values and state of monitored parameters which should be real-time displayed in monitoring module as well as the data which will be transmitted; Furthermore, On the base of the study of, it gives 34 kinds of constant faults" diagnosis methods; Using BODAS software and DPS software, it compile the program code of the controller and the displayer; At last, this paper design and make the simulation test device of control system of construction machinery, through the experiment, the realizability, the categoricalness, the reliability, the stability and real-time are tested, in addition, the improved methods are given.

本文收集整理了国内外智能推土机研究的相关文献资料，综合分析了国内外智能推土机的研究现状、发展趋势和前沿技术，论证了开发全液压推土机智能系统的重要组成部分&全液压推土机状态监测与故障诊断系统&的必要性和可行性；根据全液压推土机的结构、作业特点和作业环境，制定了全液压推土机状态监测与故障诊断系统方案，确定了系统的结构组成；采用模块化设计方法，将整个系统分成了显示、通信和故障诊断三个模块，给出了各模块功能的实现方法，确定了各模块的关键技术参数：选用RC6-9和DI2／10作为系统的控制器和显示器，用CAN总线搭建了系统的通信平台，完成了系统的硬件设计；确定了系统监测参数和通信数据，对全液压推土机常见故障特征进行了分析，给出了34种常见故障的诊断方法；在BODAS软件和DPS软件的集成编程环境下，编写了控制器和显示器程序；设计并制作了工程机械控制系统模拟试验板，并在此基础上通过多次的程序调试与试验，对所设计的全液压推土机状态监测与故障诊断系统功能的可实现性、完备性、可靠性、稳定性和实时性进行了检验，证实了此系统的可行性，并提出了进一步的改进方案和措施。

The analysis shows that: a The classifiable fault styles are mainly two types: one is fault occurs in single bridge arm, the other one is fault occurs in two bridge arms.

故障情况分析表明： a 可分类的故障类型主要包括两大类，一类是一个桥臂上的晶闸管故障，一类是两个桥臂上的晶闸管同时故障。

The paper studies fault diagnosis technology based on fruticose gas pipe network which is universal in small towns,and gives a particular description of domestic and foreign gas pipe network fault diagnosis technique based on hardware and software currently. The author uses graph theory to build up hydraulic analysis model of natural gas network and presents its solution methods. Besides, the author works out the relation between gas pipe pressure and flux in unsteady condition of fluid flow according to pressure boundary condition and differential equation group, and puts forward fault diagnosis methods and steps of the fruticose natural gas pipe network of middle pressure based on the simplification of this relation.

本文针对小城镇比较普遍的枝状天然气分配管网进行故障诊断技术研究，详细叙述了目前国内外基于硬件和软件的燃气管网故障诊断技术，利用图论理论建立了天然气管网水力分析模型并叙述了其求解方法，根据燃气管内流动的微分方程组和压力边界条件求解出非稳定流动时燃气管道压力和流量的关系，并在对此关系进行简化的基础上提出了基于中压枝状天然气管网的故障诊断方法和步骤。

Based on the analysis of the major pattern of the faults in Tazhong, the feature and the patterns of the fault system was revealed. The patterns of flower structure, imbricated thrust ,Y-fault, back to back thrust fault, and ramp were developed in this zone.

剖面上断裂主要表现为基底卷入式的较高角度逆冲断裂，主要逆断裂均发育有与其背冲的伴生断层，构成&两断夹一隆&的花状构造样式；平面上发育近北西、近北东及近东西向三组断裂。

On the foundation of the analysis,a fault diagnosis method which is an advanced pattern recognition method is proposed and a fault diagnosis system of generator excitation power unit based on virtual instrument is developed.It is proved by experiment that the fault diagnosis system can precisely judge which thirstier goes wrong and get accurate diagnosis result.

发生晶闸管直通故障时，瞬间将造成相电压短路，短路电流使保护电路动作；而发生晶闸管开路故障时(如晶闸管器件门极损坏或触发脉冲丢失等故障)，功率单元仍然工作，但输出励磁电压的脉动增大，平均值降低，这种带病工作导致励磁电压波形产生畸变，从而导致了发电机工作在不稳定状态，同时也加大了对电网的干扰[2]。

In this paper, the conjunct fault feature of broken rotor bar and stator inter-turn short circuit fault have been summarized and the mutual relation of the two has been disclosed according to detailed analysis. As establishes an important theoretical foundation for combination detection of broken rotor bar and stator inter-turn short circuit conjunct fault.

本文通过对仿真结果的详尽分析，系统地概括出了笼型异步电动机发生转子断条与定子绕组匝间短路双重故障时的故障特征，明确揭示了二者之间的相互关系，为实现转子断条与定子绕组匝间短路双重故障联合检测提供了重要的理论依据。

The Hilbert modulus is defined as the sum of the square of a signal and its conjugation.Hilbert modulus is used to covert the fundamental component in original phase current to direct current component,the fault characteristics frequency of bar break is transformed into the twice slip frequency.The problem is solved that fault characteristic component in the spectrum analysis of the current is easily to be blanketed by fundamental component and is hard to highlight fault characteristics.

将Hilbert模量定义为原始信号与其共轭信号的平方和，利用Hilbert模量将原相电流中的基波分量转变为直流分量，原频谱分析的转绕组断条的故障特征分量转变为频率为二倍转差频率的电流分量，决了相电流频谱分析方法中断条故障特征成分容易被基波湮没而难以突出故障特征的问题。

On the basis of deep research on fault sealing property and its main influence factors, the functional relation of mud content in fault infills with fault displacement and faulted mudstone thickness is described quantitatively through the analysis of lithology influence factors in fracture belt.

在深入研究断层封闭性及其主要影响因素的基础上，根据对断裂带中岩性影响因素的分析，定量描述了断裂带填充物中泥质所占百分含量的大小与其断层位移和被错断泥岩厚度之间的函数关系，并提出了根据断裂带填充物中泥质含量的大小来判断断层封闭性的标准。

By studying the deformation and evolutionary sequences around the Panshan granitic pluton, east-central Yanshan orogenic belt, and 40 Ar/ 39 Ar thermochronological test and analysis,we present the structural evolutionary process of the overlying strata before pluton intruded as well as it was intruding. The sequences of regional deformation are as follows: before the intrusion of Panshan granitic pluton, the N-S trend contraction in the east-central Yanshan orogenic belt took place, which resulted in the regional EW-trending Malanyu multi-fold and Jixian thrust fault; then Panshan granitic pluton intruded into the south limb of the Malanyu multi-fold and cut-through the Jixian thrust fault; later, the reactivity of the Jixian thrust fault cut off the synclines around thePans han granitic pluton.

通过对燕山东段盘山花岗岩岩体周缘构造变形特征、演化过程的研究，并结合40Ar/39Ar 热年代学测试和分析，提出盘山岩体侵位前、侵位时其上覆岩层的构造演化过程：三叠纪末(210-200 Ma)盘山岩体侵位前，燕山中东段受南北向挤压作用形成了近东西向的马兰峪复背斜和蓟县逆冲断裂；盘山岩体侵位于先期形成的马兰峪复背斜南翼，并侵蚀了蓟县断裂；蓟县断裂的后期再次活动截切了盘山岩体的周缘向斜。

The system can be widely used in belt weighing and batching process control,etc.

介绍了基于智能模糊控制的嵌入式配料系统的设计方法，对模糊PID控制过程和系统调零作了重点的讨论，同时给出了PID控制的程序流程图和系统定长调零子程序。

"I dunno," she answered,"but if you show me aroun', I'll recognize it from the lighthouse just outside the porthole."

"我不知道，"她回答说，"如果你能带我转转，我能认出来的，因为灯塔就在舷窗外。"