查询词典 equalizing file

Generally speaking, documents are immediately误删除found their mistake, so just delete the file on disk where the file allocation table in a relatively high position, we can use this to speed up the pace of recovery.

一般来说，误删除文件都是马上发现自己的误操作，所以刚删除的文件在磁盘里的文件分配表处于较靠前的位置，我们可以利用这一点，加快恢复的速度。

Floppy disk can not read and write, the more try Scandisk is a good idea, because of the existence of long file names, file allocation table can be easily damaged, and difficult to repair.

在无法读写软盘时，多试试Scandisk是个好主意，由于长文件名的存在，文件分配表很容易被破坏，且难修复。

Hard disk data storage has four regions: boot sector, file allocation table, directory, district, zone file data.

硬盘数据存储有四个区域：引导区、文件分配表、目录区、文件数据区。

PCInspector File Recovery is able to find and unerase deleted partitions on your hard disk even if the boot sector or file allocation table has been deleted or damaged or deleted from the network drive.

PCInspector文件恢复是能够找到和删除分区unerase在您的硬盘上，即使引导扇区或文件分配表已被删除或损坏或删除网络驱动器。

These clusters in the file allocation table in FAT cluster做上bad marks, so that it will not be covered by the permanent presence in the disk (the disk has been used in the cluster must be FAT file allocation table上簇do the tags, otherwise they will be other documents were covered by the use of).

这些簇在文件分配表FAT中做上坏簇的标记，使其不被覆盖而永久地驻留在磁盘中（磁盘已使用的簇必须在文件分配表FAT中做上簇的标记，否则会因其它文件的使用而被覆盖）。

File attributes for the new file.

文件属性为新的文件。

File, and that the original file attributes are preserved, thuspreserving ownership information.

而且原始文件的属性也保留了，从而保留下了自己原来的信息。

Vc set in the properties file, including read and modify the file attributes.

详细说明：在vc中设置文件的属性，包括读取和修改文件属性。

It allows you to search by file name and limit results by date, size, file attributes and category.

本程序运行您按照文件名字和通过限定文件日期、大小、文件属性和类型来进行搜索。

In PL/1, to associate a file with a data set and to complete a full set of attributes for the file name.

在PL/1语言中，使文件和数据集联系起来并为文件名建立一组完整的属性。

"Second Life is remarkably easy to work with, and is very popular,"

"第二次生命是显着容易的工作，并且很受欢迎，"

For example, we usually assume that materials are homogeneous and isotropic and free of internal defects or flaws.

为了得到适合有限元分析的模型，我们必须经过如图2所示的简化步骤。