查询词典 dynamic friction

AbstractThe effects of space of fins, number of tube rows and relative humidity of incoming air on airside performance of wavy fin with hydrophilic coating under dehumidifying conditions were experimentally explored for seven wavy fin-and-tube heat exchangers with hydrophilic coating. The Colburn factor and the Fanning friction were applied to describe airside heat transfer and friction characteristics, respectively.

摘 要：为了确定翅片间距、管排数和入口空气相对湿度等参数对析湿工况下带亲水层波纹翅片空气侧特性的影响，对7个带亲水层的波纹翅片管换热器进行了试验研究，并分别以Colburn换热因子和Fanning摩擦因子来反映空气侧换热和压降特性。

The effects of space of finsnumber of tube rows and relative humidity of incoming air on airside performance of wavy fin with hydrophilic coating under dehumidifying conditions were experimentally explored for seven wavy fin-and-tube heat exchangers with hydrophilic coating. The Colburn factor and the Fanning friction were applied to describe airside heat transfer and friction characteristicsrespectively.

为了确定翅片间距、管排数和入口空气相对湿度等参数对析湿工况下带亲水层波纹翅片空气侧特性的影响，对7个带亲水层的波纹翅片管换热器进行了试验研究，并分别以Colburn换热因子和Fanning摩擦因子来反映空气侧换热和压降特性。

Generally speaking,"cold-water the effect of friction than the" dry cloth friction is better.

一般来说，"冷水磨擦的效果比"干布磨擦要好一些。

Close the valve, the need to open and close with the Coma Berenices two pieces of the sealing surface of the seal formed between certain specific pressure, while also overcoming the stem and the packing between the stem and the nut thread between the stem end bearing at and other friction parts of the friction, and therefore must apply the closing force and closing a certain moment, the valve in the open and close the process, the required hoisting hoisting force and moment of change, and its maximum is close to the final instant or open the initial transient.

关闭阀门时，需要使启闭件与发座两密封面间形成一定的密封比压，同时还要克服阀杆与填料之间、阀杆与螺母的螺纹之间、阀杆端部支承处及其他磨擦部位的摩擦力，因而必须施加一定的关闭力和关闭力矩，阀门在启闭过程中，所需要的启闭力和启闭力矩是变化的，其最大值是在关闭的最终瞬时或开启的最初瞬时。

Close the valve, the need to open and close with the Coma Berenices two pieces of the sealing surface of the seal formed between certain specific pressure, while also overcoming the stem and the packing between the stem and the nut thread Automatic Control Valves between the stem end bearing at and other friction parts of the friction, and therefore must apply the closing force and closing a certain moment, the valve in the open and close the process, the required hoisting hoisting force and moment of change, and its maximum is close to the final instant or open the initial transient.

关闭阀门时，需要使启闭件与发座两密封面间形成一定的密封比压，同时还要克服阀杆与填料之间、阀杆与螺母的螺纹之间、阀杆端部支承处及其他磨擦部位的摩擦力，因而必须施加一定的关闭力和关闭力矩，阀门在启闭过程中，所需要的启闭力和启闭力矩是变化的，其最大值是在关闭的最终瞬时或开启的最初瞬时。

Close discharge valve, the need to open and close with the Coma Berenices two pieces formed between the sealing suce sealing certain specific pressure, while also overcoming the stem and the packing between the stem and the nut thread between the stem end Department and other friction parts bearing friction, and must exert a certain degree of closing force and closing moments, PUMP CONTROL VALVE EN700X the valve in the open and close the process, the required hoisting hoisting force and torque is the change, Its maximum is in the closed or open end of the initial transient instantaneous.

关闭放料阀门时，需要使启闭件与发座两密封面间形成一定的密封比压，同时还要克服阀杆与填料之间、阀杆与螺母的螺纹之间、阀杆端部支承处及其他磨擦部位的摩擦力，因而必须施加一定的关闭力和关闭力矩，阀门在启闭过程中，所需要的启闭力和启闭力矩是变化的，其最大值是在关闭的最终瞬时或开启的最初瞬时。

The results indicate that the result of local Coulomb friction model and nonlocal friction model is not too distinctive.

研究结果表明：不考虑表面微凸的情况，局部库仑摩擦模型与非局部摩擦模型的结果差别不大。

Find out main friction again --Cylinder block and mixing the friction of the oil one, improve.

并对其主要摩擦——缸体与配油盘的摩擦，进行了结构改进。

In the paper,by using Fourier Series,basic harmonic balancing approximation and optimum numerical iterration,the response computation of a two-degrees-of-freedom dry friction damped vibration absorber system with velocith-dependent variable coefficient of sliding friction under harmonic excitation is discussed.

研究了两自由度滑动摩擦系数随相对速度变化的干摩擦吸振系统简谐激励响应计算问题，提出了最优化处理方法，并推导了相应的迭代方程。

The concept of a shroud dry friction damping factor is presented to measure dry friction damping on shroud interface.

提出用阻尼因子的概念解决关于凸肩干摩擦阻尼大小的度量问题。

The system can be widely used in belt weighing and batching process control,etc.

介绍了基于智能模糊控制的嵌入式配料系统的设计方法，对模糊PID控制过程和系统调零作了重点的讨论，同时给出了PID控制的程序流程图和系统定长调零子程序。

"I dunno," she answered,"but if you show me aroun', I'll recognize it from the lighthouse just outside the porthole."

"我不知道，"她回答说，"如果你能带我转转，我能认出来的，因为灯塔就在舷窗外。"