查询词典 drying floor

The previous literatures indicate the inversion temperature exists under superheated steam drying with an atmospheric pressure, when the temperature of superheated steam is higher than the point of inversion temperature, the drying rate of superheated steam is faster than that of air drying, but if the temperature of superheated steam is lower than the point of inversion temperature, the drying rate of superheated steam is slower than that of air drying.

已有的研究表明，在过热蒸汽干燥时存在一个温度点，称为&逆转温度&，当过热蒸汽的温度高于&逆转温度&的温度时，过热蒸汽干燥速率比空气要快，低于逆转温度时则正好相反。由于木材浮压干燥的工业化应用是在负压区实现的，因此对真空状态下过热蒸汽干燥是否也存在&逆转温度&问题的研究非常重要。

Wooden floor installation checks and accept a standard: Material should accord with resident requirement and active product standard; The floor is installed should firm, breathed noise, without become loose; Wooden floor surface should plane burnishs, wait for a phenomenon without broken bits of dig mark, dig and burr, the floor of besmear varnish its design should clear; Juncture of floor spelling a flower is answered neat, aperture width is consistent, the surface is clean, without excessive glue phenomenon; Skirting board and floor connection are close; The edge on skirting board is flat, differ high endlong should not be more than ± 3 millimeter and metope are clingy, without aperture.

木制地板安装验收标准：材料应符合住户要求及现行产品标准；地板安装应牢固、无声响，无松动；木地板表面应刨平磨光，无刨痕、刨渣和毛刺等现象，涂清漆的地板其图案应清晰；拼花地板接缝应对齐，缝隙宽度一致，表面洁净，无溢胶现象；踢脚板与地板连接紧密；踢脚板上沿平直，全长高差应不大于±3毫米与墙面紧贴，无缝隙。

Matsuyama is located in the summit of the high ten-storey main building, where the first floor of the hotel lobby, Tang Yuan Restaurant dragon and phoenix hall, the situation Garden restaurant and multi-functional business center; the second floor of the Tang Yuan Restaurant deluxe VIP rooms and tea room; on the third floor is the Qin House nightclub; the fourth floor is the Palace sauna; 5 to the ninth floor is the various types of deluxe rooms; 10 floor hotel administrative center.

位于松山之巅的主楼高十层，其中一楼是酒店大堂、唐苑酒家龙凤大厅、情苑餐厅和多功能商务中心；二楼是唐苑酒家豪华贵宾房和茗茶厅；三楼是秦楼夜总会；四楼是汉宫桑拿；五至九楼是各类豪华客房；十楼是酒店行政中心。

Will be the world's first hot dry sludge treatment technology for the company are the United Kingdom Bradford. In 1910, the company developed the first transgenic kiln drying machine sludge and sludge applied to do the practice into the late 80's, sludge drying technology is gradually paying attention to people, sludge drying technology application and promotion, the promotion of the means of sludge treatment and disposal of the change, this change is mainly reflected in: landfill disposal of sludge prior to drying sludge treatment; the proportion of sludge disposal have been burning large improve; Do sludge Products used as a backland for sale, and other industries have been expanding.

世界上最早将热干燥技术用于污泥处理的是英国的Bradford公司。1910年，该公司首次开发了转窑式污泥干化机并将其应用于污泥干化实践，进入80年代末期，污泥干化技术逐渐为人们所重视，污泥干燥技术的应用和推广，促进了污泥处理处置手段的改变，这种改变主要体现在：污泥填埋处置前，要将污泥进行干燥处理；污泥焚烧处置比例得到了较大提高；干污泥产品作为土地回用的肥源出售，产业规模不断扩大等。

Because the fish drying Shrinkage small Shrinkage crack surfaces, more in Water, so the bibulous rate of early (see figure 4) soon, absorbing ability, 1.2 m in bibulous rate (Water absorption Measurement can reach 1 36), In the early EHD water are slower, bibulous rate in 30 m in later, when the water absorption speed enough time to also can achieve higher bibulous rate and natural drying EHD with dry bibulous rate basic same, in addition, natural drying and EHD dry fish good water resistance, 120 m in water can still keep complete shape after drying fish, but by 120 m in pieces after absorbing began.

由于热风干燥鱼的收缩率较小、表面有较多缝隙，所以在吸水初期的吸水速度很快(见图4)，吸水能力很强， 120 m in 吸水率可达到1。 36； EHD在吸水初期的吸水速度均较慢，在30 m in以后吸水速度加快，当吸水时间足够时也能达到较高的吸水率，自然干燥与EHD干燥的吸水率基本相同，另外，自然干燥和EHD干燥鱼的耐水性好， 120 m in 吸水后仍能保持完整形状，而热风干燥鱼经120 m in 吸水后即开始溃散。

Ink-and-drop drying oil, prompted the ink drying acceleration, but drying oil and innovativeink viscometric, tempatation, drying oil consumption does not apply is to make the ink balance out of control and the dirty version.

油不朱洋不收潮湿油，催促油不朱潮湿放缓，但潮湿油又催促油不朱粘滞，因而，潮湿油用度合适是使火不朱不均获得把持而不净版的主给成分。

The results showed that the optimum operating parameters for steaming treatment were as follows: temperature was 95℃, time was 60 s, for tunnel-type drying production line, the loadage was 5.0 kg/m2, hot air temperature was 85℃, wind speed was 1.5 m/s, and for industrial microwave drying production lines, material thickness was 15 mm, drying power was 16 kW, drying time was 90 s.

结果表明，在蒸汽温度95℃，汽蒸时间60 s；隧道式干燥生产线装载量5.0 kg/m2，热风温度85℃，风速1.5 m/s；微波干燥生产线铺料厚度15 mm、干燥功率16 kW、干制时间90 s的条件下，所生产的干制黄花菜经农业部食品质量监督检验测试中心检测其感官、理化和微生物指标均达到了《无公害食品—干制金针菜》NY5186－2002所规定的一级品标准。

The influence of drying parameters of vacuum drying on productivity and quality of Pteridium Aquilinum drying was investigated, and the impact of drying temperature, vacuum degree and material thickness on vitamin C content was studied by nonlinear regressional orthogonal design.

考察干燥因素对蕨菜真空干燥生产率及其品质的影响，用二次正交旋转组合设计的试验方法，探讨干燥温度、真空度、物料层厚度对蕨菜营养成分维生素C含量的影响规律。

The influences of three drying methods include ordinary hot air-drying, far infrared drying and microwave drying to the quality of apple slices were discussed in this paper.

不同干燥方法对苹果片品质的影响不同，探讨了普通热风干燥、远红外线干燥及微波干燥3种方法对苹果片品质(VC的含量、总酸度、复水性及感官品质)的影响。

This is the socalled thin layer penetrating air drying process. The critical thickness of wet silkworm chrysalises is about 27~35 mm. In the thin layer penetrating gas drying process of silkworm chrysalises, the temperature of drying medium is subject to that at which the protein can withstand and the flow rate is subject to the allowable leakage of air from the media layer; c. For the surface convective drying process of stripe porous media e.

对于粒状多孔介质的穿流气流干燥过程，当物料厚度小于某一临界厚度时，厚度的变化对干燥过程无明显影响，即所谓薄层穿透气流干燥过程，就蚕蛹而言，临界厚度约为27~35mm；在蚕蛹薄层穿流气流干燥过程中，介质温度应以蛋白质所能承受的温度为限，流速应以穿流料层时不发生漏风现象为限；c。

Yet, Edith says, there was always money in the bank.

但是Edith说，她的银行户口里面总是有钱。

We have created a series of files that resolve this problem--one for each day of the 40 days of purpose.

我们制作一系列的档案去解决这问题---一个为标竿40天中的每一天。