查询词典 double angle formulas

Factory adjustable eccentric block and the fixed angle between the eccentric block of 0 °, then the exciting force for the vibration of the motor nominal excitation force F, the different angle between the exciting force when the table below, paying particular attention to , adjust the excitation force applied, to both ends of the vibrating motor with adjustable eccentric block to adjust in the same direction the same angle.

出厂时可调偏心块和固定偏心块之间的夹角为0°，这时的激振力为振动电机的额定激振力F，不同夹角时的的激振力如下表，要特别注意，调整激振力时，要将振动电机两端的可调偏心块向同一个方向调整相同的角度。

The wood of China fir and Taiwan zelkova were used for cutting test. Cutting conditions of the tool were rake angle 35°, sharpness angle 29° and clearance angle 26°. Five depths of cut were laboratory fraise for metal cutting. The cutting force measurements, based on the cutting surface of the test material, were performed by a quartz piezoelectric three component dynamometer.

采用杉木与台湾榉之气乾材为试验材料，切削试验以高速度钢材质之平刀进行二次元纵切削(90-0)之平削试验，切削条件中刀具斜度角为35°，刀端角为29°，余隙角为26°，切削深度为0.05、0.1、0.2、0.3与0.5 mm，切削速度为1.1cm/s。

At the field of view angle prompt, enter the angle that describes half the angle of view of the smaller dimension of a perspective viewport.

在视域角度的提示下，输入一个角度描述一个透视视口的较小定义的视图的角度的一半。

Last year, 6.5 centimeters in diameter, more than the price of ponkan 8 angle, while the current orange festival, with the quality ponkan prices in the 4 angle between 5-5 angle, almost half of last year.

去年直径在6.5厘米以上的芦柑的价格是8角多，而本届桔子节上，同品质的芦柑价格在4角5到5角之间，几乎只是去年的一半。

The improved e-N method can also yield results well agree with those obtained by DNS.4 The transition prediction for boundary layers on cones with different key parameters such as angle of attack, cone half angle and the Mach number of the coming flow, have been made, to show the reliability of the modified e-N method.5 For the calculation of base flow, boundary layer equations can be used in the case of small angle of attack.

但是它要依赖于对初始扰动的正确预估，这显然又取决于更多飞行数据的积累和分析。e-N方法的转捩预测结果与直接数值模拟得到的结果也吻合较好。4通过对不同来流攻角、不同半锥角和不同马赫数的三维圆锥边界层的转捩位置进行预测，证实了改进的e-N方法对于三维边界层转捩预测是可靠的。5对于基本流的计算，边界层方程可以用于小攻角的情况，其计算量远远小于直接数值模拟，但背风面的剖面不可靠。

Beginning with "1" and following the other angle , note that 2,9,22,41,66,97,134,177,226,281, and 342 are all on a same angle of 90*, or an angle of 60* and 240* as measured by the Hexagon Chart .

从1开始，跟随着其他的角度，标定2，9，22，41，66，97，134，177，226，281，和342，都是同样规则的落在90度角上，或者60度和240角上。

Beginning with "1" and following the other angle, note that 2,9,22,41,66,97,134,177,226,281, and 342 are all on a same angle of 90°, or an angle of 60° and 240° as measured by the Hexagon Chart .

和 "1"的开始而且跟随另一个角，笔记 2，9，22，41，66，97，134，177，226，281，和 342 在 90 °的一个相同的角，或如六角形图解所测量的 60 °和 240 °的一个角上是全部。

Beginning with "1" andfollowing the other angle , note that 2,9,22,41,66,97,134,177,226,281,and 342 are all on a same angle of 90*, or an angle of 60* and 240* asmeasured by the Hexagon Chart .

从1开始，跟随着其他的角度，标定2，9，22，41，66，97，134，177，226，281，和342，都是同样规则的落在90度角上，或者60度和240角上。

Beginning wit h "1" and following the other angle , note that 2,9,22,41,66,97,134,177,226,281, and 342 are all on a same angle of 90*, or an angle of 60* and 240* as measured by the Hexagon Chart .

从1 开始，跟随着其他的角度，标定2，9，22，41，66，97，134，177，226，281，和 342，都是同样规则的落在 90 度角上，或者 60 度和240 角上。

Beginning with"1"and following the other angle,note that 2,9,22,41,66,97,134,177,226,281,and 342are all on asame angle of 90*,or an angle of 60*and 240*as measured by the Hexagon Chart.

从1开始，跟随着其他的角度，标定2，9，22，41，66，97，134，177，226，281，和342，都是同样规则的落在90度角上，或者60度和240角上。

The system can be widely used in belt weighing and batching process control,etc.

介绍了基于智能模糊控制的嵌入式配料系统的设计方法，对模糊PID控制过程和系统调零作了重点的讨论，同时给出了PID控制的程序流程图和系统定长调零子程序。

"I dunno," she answered,"but if you show me aroun', I'll recognize it from the lighthouse just outside the porthole."

"我不知道，"她回答说，"如果你能带我转转，我能认出来的，因为灯塔就在舷窗外。"