查询词典 deflection offset

It is pointed out that wind vibration comfort control on tall steel structure by using modem control technique and the lateral deflection control on the frame-core wall structure by using outriggers can be realized.

指出了现代控制技术对高层钢结构风振舒适度控制及外伸臂对框架－核心筒结构体系水平位移指标控制的实现。

The tanks smashed their way into the thick of the slaughter, down-swept deflection bows cutting Cranns and Odeons in half.

坦克们狠狠地撞进屠杀最密集的区域，偏斜的下掠艇首（译注：可类比飞机的后掠翼）将克兰兽和奥迪昂兽切成两半。

For cutting the composite lock gear with unequal tooth thickness, a study is made on the design method of gear sharper cutter with nonstandard parameter involute tooth profile and noninvolute tooth profile. The cutter tooth arrangement, the choice of teeth number of the cutter and the basic method of cutter design are discussed; and a new method of choosing deflection factor by using limited area is presented.

研究加工不等齿厚的非标准参数渐开线齿形，与非渐开线齿形复合的锁闭齿轮插齿刀刀齿的排列、刀具齿数的选择以及刀具设计的基本方法，介绍用限制区域选择插齿刀变位系数的新方法，并给出刀具齿顶后角与侧螺旋角的关系曲线，为插齿刀参数的选择提供依据。

The functions of SiC whiskers are realized by whisker bridging, pulling-out, and crack deflection.

SiC晶须补强增韧机理是晶须桥接、拔出和裂纹偏转。

Fracture behavior study showed that, reinforced of SiC or Si〓N〓 nanoparticles, or SiC whiskers is due to cracks deflection, or twist, or diverse, or stop during propagating, and bridging and pulling-out of whiskers, and accompanied by fracture of a few SiC nanoparticles and whiskers.

断裂机理研究表明：裂纹扩展过程中遇到纳米SiC晶粒、纳米Si〓N〓晶粒和SiC晶须时，将发生偏转、扭曲、分叉、终止及晶须的桥接、拔出，并有少量SiC晶粒、Si〓N〓晶粒和SiC晶须断裂。

The results shows that the flow characteristics of SiC-AlN granulated powder is obviously promoted after spray drying and a suitable particles grade match. With the increasing of pressure, the density of green body increases by the style of ladder at the pressure range of 4080 MPa, 80160 MPa and 160220 MPa, the green body is uniform and densification without hard pelleted particles above 160 MPa. The pressureless sintering SiC-AlN multiphase ceramic possesses superior sintering properties and mechanical properties. It is due to the rampart formation of AlN to SiC grain growth and the reaction of SiC and AlN to form 2H solid solution. It results in the grain fining, crack expansion producing bypass and deflection, fracture section producing tearing-open and pulling-out effects, which cooperatively improves the strength and fracture toughness of the multiphase ceramics.

结果表明：喷雾造粒后，复合粉体的流动特性显著提高，粒度级配合理；随着压强增加，坯体密度在40~80、80~160和160~220 MPa范围内呈现阶梯式增长，160 MPa以上成形后素坯均匀致密，无硬球颗粒存在；无压烧结SiC-AlN复相陶瓷具有优越的烧结性能和力学性能，这是由于AlN对SiC晶粒形成生长势垒，并反应生成2H型固溶体，从而细化晶粒，导致裂纹扩展产生了绕道与偏转效应，呈现晶粒撕裂与拨出现象，协同改善了复相陶瓷的强度及断裂韧性。

Results show that chemical reaction between additives Al2O3 and Y2O3 accelerated the liquid phase sintering and the formation of the YAG non-crystalline,which was beneficial to improving fracture toughness of Cf/SiC composites.Higher sintering temperature resulted in the strongly bonded fiber/matrix interface.Fiber push-off,crack deflection and grains bridging are main toughening mechanisms of silicon carbide cera...

结果表明：烧结过程中，烧结助剂Al2O3、Y2O3之间发生化学反应，促进液相烧结，形成晶界间的次晶相YAG(3 Y2O3.5Al2O3)，有利于提高复合材料的断裂韧性；在较高烧结温度下，碳纤维、烧结助剂与基体间发生反应，形成较强结合界面；纤维拔出、裂纹偏转和晶粒桥联是碳化硅陶瓷的主要增韧机制。

This paper presents a wind vane sensors without the use of cases, combining with gyroscopes and hill-climbing algorithm to control the yaw institutions, can accurately capture the wind direction signal, rapid-conditioning the cabin of the deflection angle, so that wind generators wind wheel normal direction of the wind direction and change is always consistent for maximum capture of wind energy control strategies.

针对风力发电机组的风向变化绝对值小于15°的风能捕获率问题，提出一种在不使用风向标传感器的情况下，采用陀螺仪和爬山算法相结合的方法来控制偏航机构，能够准确的采集到风向信号，快速调节机舱的偏转角度，使风力发电机风轮法线方向与变化的风向始终保持一致，实现最大捕获风能的控制策略。

Light reflection, diffusion, deflection and transmission are all phenomenons of matter's attraction, absorbtion and re-emission.

光的反射、散射、折射和透射都是物质对光的吸引、吸收和再发射现象。

And PowerWord deflection at stand-alone product, wait for a service to upgrading the demand is not high.

而词霸偏向于单机产品，对于升级等服务要求并不高。

The studies on the developing of new media are very important to the increasing of the area density of HDD and to the implementation of hybrid recoding technology.

光磁混合记录方法，是一种可以突破超顺磁极限的限制，并进一步提高硬盘记录密度和读写速率的一种新型超高密度信息存储方式。

In io, mTOR inhibition promotes T cell anergy under conditions that would normally induce priming.

体内研究中，在正常可激发免疫反应的条件下，抑制mTOR可促使T细胞无能。