查询词典 deflecting torque

From the view of torque controlling strategy, the relation between the torque controlling strategy such as the electric current feedback method、 PWM open loop method etc and the vehicle driving way is analyzed firstly, then the conclusion could be drawn that the PWM open loop method has more advantages than the electric current feedback method when they are both used in the same vehicle which is direct driving by hubcap motor. Secondly, based on the electric motor mathematic model and its experiment, a new permanent brushless dc motor phase electric current detector method in which a digital signal processor and single current sensor are used is introduced.

从转矩控制策略角度来看，分析了电流反馈法以及开环PWM电压调速控制方法与车辆的驱动方式关系，得出了电机驱动电压受限的情况下，无论是从对车辆的动力性能影响还是从对车辆的驱动要求来讲，开环PWM电压调速控制方法较电流反馈法更适用于以轮毂电机直接驱动方式的两轮电动车中；其次，根据电机的数学模型以及电机试验波形，提出了一种利用数字信号处理器以及单个电流传感器检测三相永磁无刷电机电枢电流的新方法，这种方法具有较强的适应性、实时性，它可以根据控制系统的要求，适时地提供所需电流数据，是目前许多文章关于无刷电机相电流平波的重要技术基础。

There are several problems in the conventional direct torque controlsystem such as large torque-ripple,inconstant inverter switching frequency.

摘 要：传统的直接转矩控制存在转矩脉动大、开关频率不恒定等问题。

On the basis of the calculation results, the cogging torque, rotation induced voltage and static torque is calculated.

利用磁路元的计算方法，计算了电机的定位转矩、旋转感应电压和静转矩，本文采用的磁路元法弥补了传统的永磁磁路计算方法之不足，计算精度能够满足工程计算的要求。

Once again, the most common torque need for the lower incisors is labial root torque to bring them into a more upright position.

再次，最常见的扭矩需要下切牙是唇根扭矩，使它们更加垂直位置。

Hence, an additional 5° of labial root torque was added to the lower incisors, providing them with -6° of torque (figure 9c).

因此，额外的5 °的唇根扭矩添加到下切牙，向他们提供与-6 °扭矩（图9C条）。

In lingual orthodontics, the applying of intrusion force was less useful than the well control of the M/F ratio to control the torque of upper incisors. If the crown of the incisor had been inclined lingually, it would be very difficult to recover the torque.

3舌侧正畸中，首要的是控制好M/F值，否则即使加大垂直压低力也难以抵抗冠唇向转矩的不足；而且一旦产生舌倾趋势，将比唇侧正畸更难以恢复。

Planet reduction shown in figure 6. Loose nut 6 "nut + washer + anti-loose nut". The explored view is Adjust torque 350~400N.m, rotate hub 13 at the same time. 5 and a radial force F=70N crease, hub can rotate free. Then fix lock washer into nut 6, fasten loose nut with torque 400N.m and make spacer control 0.05~0.15mm.

调整时，用 350~400N.m 力矩旋紧螺母 6，同时转动轮毂 13，使两轴承处于正确位置，然后，稍旋松螺母 6，在轮辋螺栓处施加一个切向力 F=55N.m，此时轮毂应能自由转动，然后装上止动垫片 5，将其卡爪折入螺母 6 的防转槽内，再用 400N.m 的力矩旋紧防松螺母，使轴向间隙控制在 0.05～0.15mm 之间。

The motor s physics process in the changing of magnetic store energy and mechanism and parameter calculation in the self inductance, mutual inductance, magnetic flux linkage and electromagnetism torque is discussed in such respect of multi return and electromagnetism torque theory.

从多电流互感回路理论出发，以电磁转矩这一机电耦合项为依据，讨论电机的磁场储能与机械能相互转换的物理过程、隐极电机的电流回路中自感和互感参数计算、磁链方程及电磁转矩计算

Besides this, the calculation of magnetic energy and electromagnetic torque of SCLRM is deduced by virtual displacement principle, and the physical essence of the electromagnetic torque is also analyzed in detail.

利用虚位移原理推导出了SCLRM中的磁场能量和电磁转矩的计算方法，并详细分析了电磁转矩产生的物理本质。

Based on the analysis of calculation theories on magnetic field and torque of permanent magnetic gears, the characteristic curve of torque-angle are calculated with the use of Ansoft electromagnetic calculation software.

本文在分析永磁齿轮磁场和转矩计算理论的基础上，利用Ansoft 电磁计算软件计算了平行轴永磁齿轮的矩角特性曲线，并研究了恒定负载下永磁齿轮的转速波动情况。

Warden: That's a beautiful dog, but don't bring her again.

那是条漂亮的狗，但是不要再把她带来了。

You get up in the morning – no hangover!

你第二天早上起来的时候—不会宿醉！