查询词典 debugging aid

This article mainly expounds principles and methods of computer-aided diagnosis and debugging technology platform for cascaded narrowband filter.

本文阐述了建立级联式窄带通滤波器的计算机辅助诊断和协同调试技术平台的原理和方法。

Its main function is to produce radar echoes, clutters and noise. Its used for radar subsystems debugging when the microwave frontend is not available.

它的主要功能是用来产生目标的回波、杂波和环境噪声，在前端电波不存在的情况下对雷达分系统进行调试。

The old system of laser range finder, which processes laser emission system, laser incepting system and measuring round-trip time of light pulse by separated cell circuit, makes the cost of exploiture expensive, debugging difficult, circuit complex, precision inaccurate, reliability low, bulk and weight great, even without any standard suited gate together with other instruments. Therefore, popularization application of laser range finder is cumbered.

早期的激光测距系统在激光接收机中通过分立的单元电路处理激光发、收信号以测量光脉冲往返时间，使得开发成本高、电路复杂，调试困难，精度以及可靠性相对较差，体积和重量也较大，且没有与其他仪器相匹配的标准接口，上述缺陷阻碍了激光测距系统的普及应用。

Finally, this article can in detail narrate the practical low frequency power amplifier installment and the debugging, and to debugs the question which in the process appears to give the briefing.

最后，本文具体叙述实用低频功率放大器的安装与调试，并对电路在工作中易出现的失真情况做了细致的分析。

This is an audio coding and decoding process, I have all the documents through the debugging.

这是一个音频编码与解码的程序，所有文件本人都调试通过了。

In the part of system assembling and debugging, various sensor is demarcated and the whole test system is debugged.

在系统的组装调试方面，对温度、压力、流量传感器进行标定调试，对整个测试装置进行调试运行。

The no form of this command disables debugging output.

以 no 形式出现的指令，可以停止除错结果的输出。

In our daily life during debugging and test the circuit , when initialing the oscillograph, always we press the " AUTOSET " for short.

在我们日常的调试电路板和测量的过程中，初始化示波器时，往往我们&偷了一下懒&，按一下示波器上的&自动设置&按钮即可。

Some technical problems arose during the debugging of the accelerator. The ion source did not produce arc. The accelerator tube cracked. The control system was out of order. The transporting capacity of the charge belt degraded. The corresponding reasons were analyzed and some measures were adopted to solve the problems. The drawing voltage was raised to its predetermined position after the ion source produced arc and should be reduced to zero before turning off the accelerator. Transition flange was lathed and the accelerator tube was re-assembled. The control equipment at high voltage was shielded. TVS diodes were installed at the input and output ends.

调试中出现了离子源不起弧、加速管破裂、控制系统失灵和输电带输电能力降低等技术问题，分析了出现这些问题的原因，然后分别采取了相应的措施加以解决：变换工作流程，在每次关机前先把引出电压降为零，开机时等离子源起弧后再把引出电压升到预定值；对过渡法兰进行车加工，重新封装；对高压端的控制设备采取屏蔽措施，在输入、输出端使用TVS二极管，对控制软件进行抗干扰设计；对绝缘气体进行循环干燥等。

Lucubrating Hardware Description Language, and grasping use-method of its debugging software.

3采用Verilog HDL硬件描述语言编写和调试了FPGA中的位置信号处理和角度解算、SPI通讯以及信号综合的程序，并运用此程序代码进行了开关磁阻电机专用集成芯片的设计以及版图的制作。

Chimborazo and Cotopaxi, took me by the hand.

越过琴博腊索山和科托帕克西山。

This car is in a good condition.

这辆车的状况很好。