查询词典 correlation method

The correlation between live traits and carcass traits was determined mainly by the close correlation between girth of paunch, dock width, live backfat thickness and leaf percentage; close correlation between heart girth, dock width, dock length and dressing percentage and bind hock proportion, and correlation between body lunch, heart girth and lean meat percentage.

湖北 白猪活体性状与胴体性状之间的相关主要是由：腹围、臀宽及活体膘厚与板油率密切相关，胸围、臀宽、臀长、臀围与屠宰率及后腿比例密切相关，体长、胸围与瘦肉率和肥肉率间的较强相关所决定的。

Correlation analysis revealed that the percentage of damaged seeds had a significant negative correlation with the micronaire and a significant positive correlation with the lint index , and did not show significant positive correlation with the 2.5% fiber spanlength, uniformity, strength, fiber elongation and the seed index.

相关分析结果表明，棉花种子虫害率与马克隆值成显著负相关；与衣指成显著正相关；与 2.5%跨距长度、整齐度、比强度、伸长率和子指等指标相关性较低。

The sensitivity degree of correlation analysis methods to noises, the effect of matching length on correlation analysis methods, and the applicability of correlation analysis methods to geomagnetism matching algorithm for flying objects were discussed according to the simulation results, which would offer a reference for the selection of correlation analysis methods and form a base for further deep studies on matching algorithms.

根据仿真结果，讨论了各种相关分析方法对不同噪声的敏感程度、匹配长度变化对各种相关分析方法的影响以及各种相关分析方法对飞行器地磁匹配制导的适用性，为相关分析方法的选择和对匹配算法进行更深入的研究奠定了一定基础。

The common method, that all strong-correlation terms of the model are eliminated, can bring the loss in the engineering application, so the new method is proposed that the identified model reserves some correlation. The augmented matrix A is constructed by the outputΔW and the matrix S. The"determinating order based on ratio of determinant"is brought out to screen the strong-correlation terms in the structure identification. The latent root estimation is improved in screening the eigenvalues and eigenvectors. Thus the estimation precision is improved greatly.The consistence check of guidance instrument error coefficients of flight test and ground test is the purpose of flight experiment. The causes of inconsistency of the two models are analyzed. The hypothesis test of linear regression model based on F statistics is proposed to check the consistence.Finally, the instability of error coefficients is probably caused by the change of the flight environments, therefore, the relation between the error coefficients and flight environment is analyzed. The approach is presented to identify SINS guidance instrument error models and compensate the error in the segmented sections corresponding to the change of vertical acceleration of aircraft.

在结构辨识中，常用的方法由于将模型中的强相关项全部剔除而给工程应用带来损失，因此，本文提出了新的有益思想，即在保留一定相关性的基础上进行辨识：将输出向量ΔW与环境函数矩阵S构成增广矩阵A，然后采用"比定阶行列式"来剔除相关向量的方法，这样既可以尽可能多地保留了对落点影响大的强相关参数，又可以对落点影响小的强相关参数给予剔除；在参数估计中，改进了特征根估计中特征根和特征向量的筛选方法，提出"近零"准则，从而大大提高了参数估计的精度；再者，鉴于天地模型"一致性"检验是飞行试验和SINS制导工具误差系数分离的主要目的，因此，本文又深入分析了造成天地模型不一致的原因，提出了采用基于F统计的线性回归模型假设检验方法来进行捷联制导工具误差模型的天地"一致性"检验；最后，鉴于飞行环境剧烈变化可能会对惯性仪表误差系数稳定性带来一定的影响，因此本文深入地分析了SINS制导工具误差系数与外界环境的关系，提出了基于过载变化大小的分段辨识和分段实时补偿的算法。

The revised Hargraves formula has the best result compared with Penman-Monteith formula, the average relative error is 6%, moreover, Hargaves method requiring the least data in calculating ETo, so this method has the high actual application value; The following are Radiation method and Blaney-Criddle method ; The worst is the Pan method, even after revised, the highest and average relative error is 36% and 10%, respectively. So, in this study, Penman-Monteith method, Radiation method, Blaney-Criddle method and Hargraves method are used except Pan method.

在这四种方法中，修正后的Hargraves方法与彭曼—蒙特斯方法的计算结果符合最好，其平均相对误差为6％，而Hargraves方法需要的气象数据只有计算时段的最高、最低温度，该方法具有较高的实际应用价值；辐射方法和布兰尼—克里德尔方法次之；蒸发皿方法最差，即使在修正后，E601型蒸发皿的最大误差也高达36％，平均为10％，所以在预报系统的研究设计中采用了除蒸发皿方法之外的四种方法。

The primary studying works and characteristics:1 To summarize reinforcing theory of cement mixing pile composite foundation2 To analyze the primary mechanics characters and changing rules of cement mixing pile, based on analysis of test data both indoor and outdoor.3 To discuss siding frictional resistance, ending resistance, ultimate bearing capacity of simple mixing pile and effectiveness factor of grouped piles, loading ratio of soil between piles under cushion cap of grouped piles and stress ratio of pile and soil and so on, and use many computation method and experimentation method to ensure bearing capacity of mixing piles composite foundation.4 To point out and analyze eight sides flaws and problems of the bearing capacity calculation method of mixing pile compositefoundation which ensured by national and normative method/ formula.5 To apply test results of loading tests and a few settlement observation data, use gray theory to predicate ultimate bearing capacity of deep mixing piles, actual example demonstrate engaging between theoretical predicted value and actual value.6 To apply groovy layerwise summation method to discuss entity piles method, double foundation method, equivalent layerwise summation method and consolidation theoretical method and so on, especially by combination of engineering example, use FEM to calculate or discuss the settlement and changing rules of composite foundation.7 To discuss problems of critical length of composite foundation by combination of engineering example and numerical analysis method, and analyze the contrast of critical length between simple pile load and most area load of composite foundation, not only critical length of composite foundation is relative to modulus ratio between piles and soil, but also upside load distribution area of composite foundation.

主要的研究工作与特色为：(1)总结了水泥搅拌桩复合地基的加固原理；(2)在对室内外试验资料进行统计分析的基础上，系统分析了搅拌桩水泥土的主要力学特性及其变化规律；(3)探讨了搅拌单桩的侧摩阻力、端阻力、极限承载力及群桩效率系数、群桩承台下桩间土荷载分担比及桩土应力比等，提出用多种计算方法并结合试验方法来综合确定搅拌桩复合地基的承载力；(4)明确指出和分析了按国家有关规范的方法确定搅拌桩复合地基承载力所存在的八个方面的缺陷与问题；(5)利用过去没有加载至破坏阶段的载荷试验成果和较少的沉降观测数据，尝试了用灰色理论预测深层搅拌桩的极限承载力，实例表明理论预测值与实测值吻合较好；(6)在常规分层总和法的基础上，探讨了复合地基沉降计算的实体墩基法、双层地基法、等效作用分层总和法、固结理论法等，特别是结合工程实例，用有限元数值计算等方法计算和讨论了搅拌桩复合地基的沉降及其变化规律；(7)结合工程实例，用数值分析方法探讨了复合地基临界桩长的问题，指出和分析了单桩荷载下的临界桩长与复合地基大面积荷载下的临界桩长存在很大的差别，复合地基的临界桩长不仅与桩土模量比有关，而且与复合地基上部荷载分布面积有关。

The fluctuation structures were observed in theexcitation function of all the outgoing channels.Statistics method based on thefluctuation correlation was used to study and analyze the excitation systematically,which demonstrates a series of characters in the dissipative collision 〓 and〓 by which they are different from the compound nuclei in the cross sectionfluctuation,such as strong correlation among outgoing channels,long range energycorrelation and angular correlation.

各个出射道的激发函数中都观测到了涨落结构，运用涨落关联的统计理论方法对激发函数进行了系统地研究和分析，揭示出〓和〓耗散反应截面涨落区别于复合核截面涨落的一系列特征性质，如强烈的出射道关联、长程的能量关联和长程的角度关联。

This contour phase correlation method is superior to the conventional phase correlation in two aspects. Firstly, the contours of images are extracted, and the phase correlation is applied to the contours of images instead of the whole original images, which is more efficient and robust. Secondly, when there are multiple peak values approximate to the maximum peak value in the δ function array, the corresponding translations can be regarded as candidate translations and calculated separately, and the best translation should be determined by the optimization of conformability of two images in the overlapping area.

本轮廓相位相关算法对常规的相位相关算法作了两点改进：(1)提取出图像的轮廓，只对二值化的轮廓图像进行相位相关计算，效率和鲁棒性提高；(2)当相位相关的δ函数阵列中存在多个和最大峰值比较接近的峰值时，将其对应的平移量都作为候选平移量，然后根据重叠区图像的一致性选取其中的最佳值。

By the means of projection operator method, we study the effects of the cross-correlation time 'tau' and the cross-correlation intensity 'lambda' between noises on the normalized intensity correlation function C.

利用投影算子方法，我们研究两噪声之间的交叉关联时间'tau'和交叉关联强度'lambda'对强度关联函数C的影响。

The correlation projection analysis proposed in this paper, including Canonical Correlation Analysis, Generalized Canonical Correlation Analysis and Partial Least Squares Analysis, is a feature extraction method based on two groups of features or two data matrices.

本文提出的相关投影分析，包括典型相关分析、广义典型相关分析和偏最小二乘分析是建立在两组特征或两个数据矩阵上的特征抽取方法。

After explaining total design of automated test system for microcircuit , the thesis introduces GPIB standard .

文章在说明了微电路模块自动测试系统的总体设计后，对GPIB标准进行了介绍。

He interceded in my behalf.

他替我说情。