查询词典 col width

Track roller: Singe flange 4 Double flange 2 Carrier roller: 2 Idler 1 Type of track: single grouser combined Tension mode of track: hydraulic Pitch: 203 mm Number of shoes 38 pieces Width of shoe 500 mm Length of track on ground 2570 mm Sealed and lubricated track ▲▲The pitch , numbers and width of track shoes are the same with the general track.

支重轮 单边四个双边二个托链轮二个引导轮一个履带型式单履齿组合式履带涨紧型式液压涨紧节矩 203 mm 履带板数 38 块履带板宽 500 mm 履带接地长度 2570 mm 密封和润滑履带▲▲该履带的节距、履带板数、履带板宽与普通的履带相同。

The result showed that the changes of stoma density ranged from 91~173 unitmm^(-2). Guard cell length ranged from 25.8~32.4 μm. Guard cell width ranged from 18.4~24.2μm. Guard cell width in sports variety was longer than in original variety.

结果表明：叶片气孔密度的变化范围在91~173个／平方公厘，保卫细胞长度变化在25.8~32.4μm之间；保卫细胞宽度变化在18.4~24.2μm之间，芽变品种的保卫细胞的宽度有变长的趋势。

The width of the guard ring is vital to the capability of EIS imaging and the appropriate width of guard ring for 64 electrodes array is from 5 mm to 7 mm.

电极屏蔽地环宽度大小对于EIS成像中检测性能的影响至关重要，介于5～7 mm之间的屏蔽地环宽度对于64电极阵列较为合适。

The paper has a further research on the influence of compound soil nailing behavior in the perspective and the axial strength of the soil nails of the effect of the stiffness of soil, the stiffness of soil-cement mixing piles, the width of soil-cement mixing piles, the length of nails, the angle of nails. The paper also has a research on the influence of compound soil nailing behavior in the perspective of silt and hardpan of the effect of the width of soil-cement mixing piles.

深入分析了土体的弹性模量，水泥搅拌桩的弹性模量，水泥搅拌桩挡墙的宽度，土钉长度的变化以及土钉倾角的变化对复合型土钉墙变形性状和土钉轴力的影响，以及水泥搅拌桩挡墙的宽度在淤泥土层以及砂土土层中对复合型土钉墙支护变形性状的影响。

Big bitmaps will confine to the entire area of this control with a vertical scroll bar on Right side ( the scroll bar will be displayed if the height of the image is greater than the height of this control) and a horizontal scroll bar at the bottom of this control (the scrollbar will be displayed if the width of the image is greater than the width of this control).

大位图将只对本一份关于右侧垂直滚动条控制整个地区（滚动条将显示，如果图片的高度大于这个控件的高度）和水平滚动条的底部此控制（滚动条将显示，如果图像的宽度大于这个控件的宽度更大）。

Compared with D buffalo, the withers height, hip croop height, hucklebone width of ND buffalo respectively increase 5.5%, 7.4%, 9%, the withers height, hip croop height, hucklebone width of MD buffalo respectively increase

结果显示，杂交水牛尼本的鬐甲高、十字部高、坐骨节宽比德宏水牛分别提高5.5%、7.4%、9%，差异显著。杂交水牛摩本的鬐甲高、十字部高、坐骨节宽比德宏水牛提高5.9%、8.0%、11.9%，差异显著。

The factors for selecting the wavelength ranges to be measured are considered. The experiment equipment is introduced, with six key issues stressed, radiant power of light source should be higher, width of the I/O slits of the monochromator should be reasonable and both of them should be adjusted to an equal width, the focal length of the convergent lens should be longer, the exit of humidistat should be square, the function of vacuum pump and fog collecting hood is important, and the wavelength adjustment of the monochromator and the auto-record of the measuring signal should be controlled by a micro-computer.

讨论了实验中光波长范围的一些选择因素，详细介绍了实验装置，特别强调了实验装置中的6个要点：即光源的辐射功率要大；单色仪的出入射狭缝要合理且两者宽度应调成一致；会聚透镜的焦距要大；加湿器最后出口的孔必须是方的；真空泵和雾气收集罩的作用；微机控制单色仪波长鼓及测量信号的自动记录。

An analytical model was built up on the jet deflection in the crossflow by applying the theorem of momentum, which takes full account of mixing between the upstream fluid and burner jet, and of the total pressure difference between the two sides of the jets. Through analysis of this model, experimental study and numerical simulation, effects of the nozzle spacing ratio, width of the furnace corner, width of the nozzle and imaginary circle diameter on the aerodynamic field in the furnace were obtained.

本文综合考虑了炉内旋转气流与燃烧器射流的混合和燃烧器射流向火侧与背火侧的全压差等因素，应用动量定理建立了横向气流中射流偏转的分析模型，并结合冷态模化试验和数值模拟计算，得到了燃烧器间隙率、炉膛切角、喷口宽度和假想切圆直径等因素对炉内空气动力场影响的规律。

Considering the effect of load and helical angle on the instaneous width of contact area, this paper uses the BEM program for calculating the deformations at different place along the width of convex tooth and concave tooth of W-N gear and gets the relevant deformation curves.

并首次应用三维边界元方法，在计入齿面瞬时接触迹宽度随外载、螺旋角而变化的条件下，计算了双圆弧齿轮凸齿面端部和凹齿面端部的变形。

For example, Japanese katakana characters can be written as full-width or half-width.

例如，日语片假名字符可以写为全角或半角形式。

"Second Life is remarkably easy to work with, and is very popular,"

"第二次生命是显着容易的工作，并且很受欢迎，"

For example, we usually assume that materials are homogeneous and isotropic and free of internal defects or flaws.

为了得到适合有限元分析的模型，我们必须经过如图2所示的简化步骤。