查询词典 chisel point

Thence in a southeasterly direction to Corner Point No. CP14 (X = 484 330, Y = 683 415); thence in a. northeasterly direction to Corner Point No. CP15 (X = 484 390, Y = 683 490); thence in a southeasterly direction to Corner Point No. CP16 (X = 484 415, Y = 683 470); thence in a southwesterly direction to Corner Point No. CP17 (X = 484 355, Y = 683 395); thence in a southeasterly direction to Corner Point No. CP18 (X = 484 430, Y = 683 335); thence in a southeasterly direction to Corner Point No. CP1, the point of beginning.

从该点起向东南延伸至隅角点CP14（X = 484 330，Y = 683 415）；从该点起向东北延伸至隅角点CP15（X = 484 390，Y = 683 490）；从该点起向东南延伸至隅角点CP16（X = 484 415，Y = 683 470）；从该点起向西南延伸至隅角点CP17（X = 484 355，Y = 683 395）；从该点起向东南延伸至隅角点CP18（X = 484 430，Y = 683 335）；从该点起向东南延伸至隅角点CP1。

Sb can combine with Cu and P to form a low melting point compound which lowers the melting point of binary Cu-8P eutectic alloy by nearly 200℃. Bi and Cu can create compounds with low melting point(270℃) distributing at the boundaries and that is the reason why the melting point of (Cu-8P)-Bi is lower than that of binary Cu-8P eutectic alloy. The eutectic cluster can be refined with the addition of Fe, and that is the reason why the addition of Fe can decrease the melting point of Cu-8P alloy. Two means of decreasing the melting point of Cu-8P are found.

一定量的Sb与Cu， P形成低熔点相，从而大幅降低了Cu-8P合金的熔点，使其熔点降低近200℃；加入少量Bi后， Bi与Cu在共晶团晶界上形成熔点为270℃左右的低熔点化合物，且Bi的加入明显细化Cu-8P合金共晶团，从而使Cu-8P合金的熔点降低；加入Fe能明显细化Cu-8P合金的共晶团，使层片间距由8μm减为2μm以下，并使共晶团由层片状向短棒状转变，虽然Fe与Cu形成熔点为806℃的高温相，但Fe的细化作用使得Cu-8P合金的熔点降低，但降低幅度不大。

For a continuous map of trees or graphs to itself, we show the properties that every isolated chain recurrent point is an eventually periodic point, and an isolated chain recurrent point which is not in the orbit of a critical point and has no critical point in its orbit is a periodic point.

第三章主要讨论一些特殊连续统上连续自映射的孤立链回归点与最终周期点之间的关系，证明了对树或图上连续自映射，孤立链回归点是最终周期的，且如孤立链回归点不在临界点的轨道中，也无临界点在其轨道中，则此点必为周期的。

Resistance to Earth magic by an amount equal to your skill in Earth and lasts one hour per point of skill. 1 point resistance per point of skill 2 points resistance per point of skill 3 points resistance per point of skill 4 points resistance per point of skill P

每提高一个土魔法等级可以增加1点防御值每提高一个土魔法等级可以增加2点防御值每提高一个土魔法等级可以增加3点防御值每提高一个土魔法等级可以增加4点防御值 P

Results show that floes' VC and D at the surface water were closely related to current velocity; and the peaks of VC lag those of the current velocity. The lag variation during ebb and flood tides is 10-30min and 30-50 min, respectively. Current velocity at 50 cm/s is a turning point of D vs. vertical average current velocity, before the point, Dm increases with current velocity, and decreases after the point. Similarly, VC at 75μl/L becomes a critical point in the surface water, below the point, D increases with VC, and above the point, D stabilizes.Δp is D dependent, larger floes have much lower Δp than smaller floes. Both D and Δp of floes affect ω. In the surface water during spring tide and neap tide, a power exponent relationship exists between Δp and D, and ω and D.

研究表明：①长江口徐六泾表层絮凝体体积浓度主要受水流流速影响，再悬浮现象明显，体积浓度过程线滞后流速过程线，落潮期间滞后10-30min，涨潮则滞后30-50min；②小于一定流速时絮凝体平均粒径随流速增大而增大，大于一定流速时絮凝体平均粒径则随流速增大而减小，徐六泾夫、小潮表层絮凝体在50cm/s的垂线平均流速时出现平均粒径与垂线平均流速关系的转折；③徐六注大、小潮表层絮凝体平均粒径在体积浓度75μl/L时出现平均粒径与体积浓度关系的转折，体积浓度小于75μl/L时粒径随体积浓度增加而增大，超过75μl/L时粒径随体积浓度的增加变化不明显；④絮凝体有效密度由粒径大小控制，粒径大，有效密度小，反之亦然，粒径和有效密度共同决定絮凝体静水沉速，有效密度和沉速与平均粒径之间均存在良好的幂指数关系。

The critical point means such a state that all the differences between gas and liquid disappear completely,being a most important parameter of dividing the types of fluid and being widely verified in both theory and practice.Currently,four methods of determining critical point are summarized as follows:①laboratory measurement through examining critical opalescence or recording the bubble point and dew point curves;②empiric relation;③calculation of the bubble point and dew point curves by PVT software;and ④ direct calculation according to thermodynamic theories.

随后对临界点进行确定，临界点是气液一切性质差异均消失的状态，是区分流体类型最重要的参数，并得到了理论和工程应用的广泛验证，目前确定临界点大致有四种方法：①实验测定，通过观察临界乳光现象或记录流体的泡点和露点线；②经验关系式；③通过PVT软件计算流体的泡点和露点线；④利用热力学理论直接计算。

Distance from the origin point to O point was (1.84±0.69)cm,unharmful separation point to O point was (0.05±0.12)cm,muscle entry point to O point was (4.35±0.12)cm.

结果 桡神经旋后肌支数为2.6±0.52，其自然分支处距O点(1.84±0.69)cm，干支分离后分支距O点(0.05±0.12)cm，入肌点距O点(4.35±0.12)cm。

Point angles at outer corner and chisel edge corner are proposed to be used as the drill design parameters to determine the type uniquely and the relief angle is used as a supplement parameter.

针对该钻型的特点，提出用钻尖主刃的外缘和横刃转点处的锋角作为其设计参数值。

So one more drill point geometric parameter is needed, such as heel clearance angle, chisel edge clearance angle.

为了获得唯一的后刀面廓形，必须增加一个辅助参数。可供选择的补充参数有尾隙角、横刃后角、周边后角、切深后角等。

So one more drill point geometric parameter is needed, such as heel clearance angle, chisel edge clearance angle.

可供选择的补充参数有尾隙角、横刃后角、周边后角、切深后角等。

Don not attempt to do something which you can not to do.

不要企图做那些办不到的事情。

The expression of CTGF and TNF-αweredetected by immunochemistry and the number of Clara Cells was calculated.

光镜下观察肺组织的病理变化，采用免疫组化染色观察肺组织中结缔组织生长因子和肿瘤坏死因子-α的表达和Clara细胞的数量。