查询词典 cathode drop

In the paper, some factors influencing the effect of reduction including the anodic material, the cathodal material, the area ratio of cathode to anode and the kind of electrolyte have been investigated and screened out. The result showed that under the same reduction conditions, the reduction of Cr6+ has better effect to use lead-antimony alloy as anode, iron plate as cathode, which area ratio is 7:1 and potassium sulphate as electrolyte.

本文首先对影响电解还原效果的阳极材料、阴极材料、阴阳极面积比和支持电解质加入的种类等因素进行了研究筛选，结果表明：在同样电解还原条件下，实验中阳极采用铅-锑合金，阴极采用铁板，阴阳极面积比取7∶1，支持电解质取为硫酸钾时，具有较好的Cr~(6+)还原效果；同时在采用铅-锑合金作阳极的条件下，通过正交实验，对影响直接在碱性介质中电解还原低浓度含铬废水的其他因素进行了研究，即研究了在电化学还原过程中，Cr~(6+)的初始浓度、极板间距、支持电解质的加入量、搅拌情况等因素对还原效果的影响程度，确定出了主要的影响因素。

A catholyte reservoir (76) external to the cathode chamber supplies catholyte (40) to and removes gases (73) from the cathode chamber.

设置在阴极室外部的阴极电解液储存器（76）向阴极室供应阴极电解液（40）并从阴极室排出气体（73）。

Analytical results show that: Anode evaporation rate, which determines mostly the production rate of UFMP, is influenced by the many factors including electric parameters of arc, ambient conditions and material properties et al; Existence and increase of anode ejection can influence the production rate and property of UFMP; It is firstly found and investigated that surface connexity phenomenon of Al anode material. Analyses and calculation show that formation of anode spot and existence of self-magnetic field force play an important part in surface connexity process; Effects of cathode material on prepared UFMP is also experimentally studied and theoretically analysed. It shows that effect of the cathode is inconsiderable under the experimental conditions used in the study. At last, the experimental results found in part one are analysed and discussed in detail.

然后详细分析了电弧与电极间的相互作用过程，结果表明：决定超微粉产率的阳极材料蒸发率受许多因素影响，它主要与电弧电参量，环境条件及材料性质有关；阳极表面液滴喷溅的存在和加剧将严重地影响所制超微粉的产率和性质；首次发现和实验研究了Al阳极表面凸起现象，并对此现象进行了详细的理论分析和实际估算，认为阳极斑点的形成及自磁场作用力的存在在该过程中起着重用作用；实验研究和理论分析了阴极材料对所制超微粉的影响，认为在本文所用实验方法及条件下，阴极材料对粉的影响很小。

Production Technique: Most of the countries in the world use the method of rolling constant electrolysis to electrolyze copper foil. Its cathode roller is usually spinned into seamless cathode roller whose surface is even. The rollers are connected through sealing technique.

三、生产工艺：目前世界上大多数国家生产电解铜箔采用辊式连续电解方法，其阴极辊筒一般都是经过旋压制成的无缝阴极辊筒，具有均匀的表面性能，采用焊接工艺制造。

The only difference between these two cells was that in Lenard's cell the electrons were taken from the cathode by light, whereas on the "3-electrode lamp" the cathode is a white-hot filament capable of sending into the vacuum currents of much higher intensity.

在研究过程中，莱纳德还发明了一种光电管，以加速电子和测量它们的能量，这种光电管是三极管最初的雏形，不同之处在于，在莱纳德的光电管中，电子是由阴极光发射的，而三极管中的阴极是白炽丝，可以向真空发射更高强度的电流。

In early November he was repeating an experiment with one of Lenard's tubes in which a thin aluminium window had been added to permit the cathode rays to exit the tube but a cardboard covering was added to protect the aluminium from damage by the strong electrostatic field that is necessary to produce the cathode rays.

在1895年伦琴正在调查外部影响的各类真空管设备，仪器由海因里希赫兹，约翰希托夫，威廉克鲁克斯，尼古拉特斯拉和菲利普冯勒纳德，放电时，是通过他们。 [ 7 ]在11月初他是在重复实验之一勒纳德的管道，其中一个薄铝窗口增加了允许退出阴极射线管，但纸板覆盖增加了保护铝损坏的强烈静电场是必要的生产阴极射线。

More appropriate electrochemistry reacts the condition is:訧 R-Ta/Ti is positive pole, electric stone Chinese ink board is zincous electrolyte for L-1 H2SO4 of cathode;4mol ·, l-1 H2SO4 of · of 2mol · L-1 VOSO4-2mol mixes solution to be cathode electrolyte, electroanalysis at 1A 6h.

较适宜的电化学反应条件为：以Ir-Ta/Ti为阳极，导电石墨板为阴极；4mol·L-1 H2SO4为阳极电解液，2mol·L-1 VOSO4-2mol·L-1 H2SO4混合溶液为阴极电解液，于1A电解6h。

The surface state and electrochemistry properly platinum-plated on open-cell foamed titanium electrode was investigated and he compared with IrTi anode and platinum-plated titanium toil cathode. The results show that open-cell foamed titanium can uniformly coat with excellent bonding strength platinum-plated, thickness coating 2 μm. The cathode release hydrogen voltage of platinum-plated on open-cell loamed titanium electrode is fall. The anode release oxygen voltage of platinum-plated on open-cell foamed titanium electrode is higher than Irli anode in high current.

采用电镀技术在多孔钛表面沉积了均匀的铂金属层，分析了多孔钛镀铂后的表面状态及电化学性能，并与IrTi涂层阳极及镀铂钛网阴极进行比较，结果显示：多孔钛板开孔孔隙表面可均匀沉积结合力良好的铂层，镀层厚度为2μm；镀铂多孔钛阴极析氢电位比镀铂钛网高，且在大电流下，阳极析氧电位比IrTi涂层阳极高。

As for PAn-based composites, the influences of the kinds of oxidant, the amount of hydrochloric acid and barbon black on conductivity were investigated, Li/PAn button-type secondary batteries were assembled with PAn-based composites which were synthesized by chemical oxidative polymerization and used as cathode, the influences of the kinds of oxidant, synthesized technics, conducting carbon black added mode and PAn/metal oxide composites used as cathode on the properties of these batteries were studied.

对于聚苯胺基复合材料体系，研究了氧化剂种类、盐酸用量、炭黑用量对复合材料电导率的影响；以化学法制备的聚苯胺基复合材料作正极组装了Li/PAn二次扣式电池，探讨了氧化剂种类、聚合工艺、导电剂的加入方式以及PAn与金属氧化物复合后作电池正极的性能。

It can be concluded from the above experiment results that for the auxiliaryheated arc plasma generator, an area which has uniform temperature distribution andhigher temperature. In this area, the diameter of the key arc root increases and thiscondition is beneficial to reduce the cathode erosion. At the same time, it is animportant segment for the secondary arc to rotate on the cathode surface and to heatthe surface for the auxiliary heated arc plasma generator.

总结上面的实验结果可以看出：在辅助加热电弧等离子体发生器中，利用辅助电弧对阴极表面的加热作用，能够在阴极表面形成一个温度较高且分布均匀的区域；在温度较高的区域内，主弧弧根直径增大，这种情形有利于减小阴极烧损；同时，辅助电弧旋转加热阴极表面是辅助加热电弧等离子体发生器的一个重要环节。

The system can be widely used in belt weighing and batching process control,etc.

介绍了基于智能模糊控制的嵌入式配料系统的设计方法，对模糊PID控制过程和系统调零作了重点的讨论，同时给出了PID控制的程序流程图和系统定长调零子程序。

"I dunno," she answered,"but if you show me aroun', I'll recognize it from the lighthouse just outside the porthole."

"我不知道，"她回答说，"如果你能带我转转，我能认出来的，因为灯塔就在舷窗外。"