查询词典 boot block

If the boot block programming lockout is activated, only the data in the other memory sectors will be erased to FF while the data in the boot block will not be erased (remains as the same state before the chip erase operation).

如果引导块编程锁定被激活时，只有在其他部门的数据存储器将被删除到FF，而在启动块中的数据不会被删除（仍然是以前的芯片擦除操作）相同的状态。

If the DQ0/DQ1 output data is "1," the 64Kbytes/16Kbytes boot block programming lockout feature will be activated; if the DQ0/DQ1 output data is "0," the lockout feature will be inactivated and the boot block can be erased/programmed.

如果DQ0/DQ1输出数据是"1"，64Kbytes/16Kbytes引导块编程锁定功能将被激活，如果DQ0/DQ1输出数据是"0"，锁定功能将被灭活和引导块可擦除/编程。

X60008EIS8-50 Pinout: In order to detect whether the boot block feature is set on or not, users can perform software command sequence: enter the product identification mode (see Command Codes for Identification/Boot Block Lockout Detection for specific code), and then read from address 7FFF2.

X60008EIS8-50引脚说明：为了检测是否启动区块功能或没有设置，用户可以进行软件的命令序列：输入产品识别模式（见识别/引导块锁定检测特定的代码指令代码），然后从地址7FFF2阅读。

The #TBL will lock the whole 64Kbytes top boot block, it will not partially lock the 16Kbytes boot block.

在＃任务型会锁定整个64KB的顶部引导块，它不会锁定16Kbytes部分引导块。

A cold boot using a rescue disk (a clean floppy disk with boot instructions and virus scanning capabilities) is often necessary to clean or remove boot sector infectors.

冷起动开始使力循环的计算机在使用营救磁盘（清洁在搜寻能力的用引导命令和病毒软盘）的冷起动经常为了使引导区清洁。

Zero once the damaged track will be the primary boot hard drive and the partition table information will be seriously damaged, resulting in the hard disk can not boot. 0 tracks damaged judge: System self-test pass, but the boot partition C disc lost or directory is missing, there are laws of the hard disk "... creak ... creak" seek the sound of running SCANDISK scanning C disk, in the first cluster a red "B", or can not find Fdisk the hard disk, DM died in the 0 track, the track such a situation that is zero damage!

零磁道一旦受损，将使硬盘的主引导程序和分区表信息将遭到严重破坏，从而导致硬盘无法引导。0磁道损坏判断：系统自检能通过，但启动时，分区丢失或者C盘目录丢失，硬盘出现有规律的"咯吱……咯吱"的寻道声，运行SCANDISK扫描C盘，在第一簇出现一个红色的"B"，或者Fdisk找不到硬盘、DM死在0磁道上，此种情况即为零磁道损坏！

The new boot appears in the list of the subtools but we can't see it in the viewport because the new boot is on top of the other boot.

新的系统引导出现在子工具清单，但我们不能看到口，因为新的启动对其他引导顶部。

Open Storm video, audio and video in the Storm "Main Menu" and click on the "Advanced Options" and "overall control" in "integrated settings" under the "boot CD to run automatically Storm","audio and video to run automatically when the storm shells Storm of Television "," pop-up storm boot recommended "in front of the hook removed, and then click OK, the next boot will not be automatically loaded on start of the storm video.

打开暴风影音，在暴风影音&主菜单&里点击&高级选项&，将&全局控制&里&综合设置&下的&开机自动运行暴风影音&，&运行暴风影音时自动弹出暴风影视&，&开机弹出暴风推荐&前面的钩去掉，然后点击确定了，下次开机就不会自动加载暴风影音启动项了。

Integrating trellis-coded modulation with threaded algebraic space–time block code, trellis-coded modulation space-time block code is presented, which has the advantage of full-diversity and small detection delay. Based on TCM pre-processing, the minimum distance between different codeword matrixes of the TCMST block code is maximized, so the average bit error rate of the TCMST block code is lower than that of the TAST block code at the same signal noise ratio.

TCMST分组码具有满发送分集度和检测延迟小等优点；由于采用了TCM预处理，使得不同TCMST分组码码字矩阵间的最小距离达到了最大化，因此在相同信噪比情况下，TCMST分组码具有比TAST分组码更低的平均误比特率。

Traveling Block - The block and tackle which is rigged with the crown block by multiples of drilling line strung between the crown block and the traveling block.

游动滑车：通过排列穿过天车和游动滑车的多股钻井绳和天车装配在一起的滑轮及装备。

The studies on the developing of new media are very important to the increasing of the area density of HDD and to the implementation of hybrid recoding technology.

光磁混合记录方法，是一种可以突破超顺磁极限的限制，并进一步提高硬盘记录密度和读写速率的一种新型超高密度信息存储方式。

In io, mTOR inhibition promotes T cell anergy under conditions that would normally induce priming.

体内研究中，在正常可激发免疫反应的条件下，抑制mTOR可促使T细胞无能。