查询词典 bit depth

Never developing a new style, nay never in indiscretion, nay nay, never shallow or deep from time to time nay, never gloriously radiant Rightwards a bit, guide rainstorms rightwards a bit leftwards a bit, direct lovers leftwards a bit downwards a bit, move heads rightwards a bit upwards a bit, put today upwards a bit Loosen the rigid death tighten the valve of the spring make the amended narration more plain and simple make the soft whips more straight and frank The wind travels on the water ahead the feet walk on the earth behind in the middle I persist in my old ways well, why not a little more humble Well, why not a little more noble Translated by Guo Hezi

不能独辟蹊径，绝对不能不能轻举妄动，绝对不能绝对不能，不能忽浅忽深绝对不能，不能光芒万丈向右一点，把暴雨向右移一点向左一点，把情人向左移一点向下一点，把头颅向下移一点向上一点，把今天向上移一点把坚固的死亡松动一下把春天的阀门拧紧一下让修补的叙述通俗一些让柔软的鞭子耿直一些前面有风行水上后面有脚踏实地中间有我行我素哎，能不能再委琐一点哎，能不能再高尚一点

At 135 mm depth and 0.28 m/sec speed, the biomimetic furrow opener surface with UHMWPE tubular ridges recorded 0.62 kN and 0.17 kW, while at 135 mm depth and 0.92 m/sec speed, the values were 0.91 kN and 0.82 kW. The experimental values of resistance force and power for the conventional surface furrow opener at 100 mm depth, and 0.28 m/sec speed were 0.72 kN and 0.20 kW, while at 100 mm depth and 0.92 m/sec speed, the values were 1.11 kN and 1.0 kW. At 135 mm depth and 0.28 m/sec speed, the conventional surface furrow opener recorded 0.93 kN and 0.25 kW, while at 135 mm depth and 0.92 m/sec speed, the values were 1.50 kN and 1.35 kW.

试验测试结果：当耕深100 mm和耕作速度0.28 m/sec时，实测的普通开沟器的土壤阻力和动力消耗分别为0.72kN和0.20kW；当耕深100 mm和耕作速度0.92 m/sec时，实测的普通开沟器的土壤阻力和动力消耗分别为1.11kN 和1.0kW；当耕深135 mm和耕作速度0.28 m/sec时，实测的普通开沟器的土壤阻力和动力消耗分别为0.93kN和0.25kW；而当耕深135 mm和耕作速度0.92 m/sec时，实测的普通表面开沟器的土壤阻力和动力消耗分别为1.5kN和1.35kW。

The phosphorus forms and BAP vary with horizontal and vertical positions. The total phosphorus, inorganic phosphorus, BAY, and iron-phosphorus contents were high at a depth of 0~20 cm at the first sampling point, and then decreased at 20-40 cm of depth. This shows that the potential release capacity of P at 0-20 cm of depth is higher. The concentrations of total phosphorus and inorganic phosphorus decreased at 0~20 cm of depth and increased at 20~40 cm of depth at the second sampling point, but BAY and Fe-P increased along with the depth consistently. This shows that the deeper layer at the second sampling point had a higher potential release capacity of phosphorus.

不同地点沉积物各磷形态和BAP的垂向变化有较大的差异。1号采样点的总磷、无机磷、铁磷和BAP质量比在沉积0~20 cm处较高，20~40 cm逐渐减小，说明0~20 cm内释磷潜力较大；2号采样点的总磷和无机磷质量比先减小，20~40 cm逐渐增加，而BAP和铁磷质量比随深度增加呈上升趋势，说明2点深层具有较大的释磷潜力。

The predicted values of resistance force and power for the conventional surface furrow opener at 100 mm depth and 0.28 m/sec speed were0.51 kN and0.14kW, while at 100 mm depth and 0.92 m/sec the values were0.98kN and0.88kW. At 135 mm depth and 0.28 m/sec speed, the conventional surface furrow opener recorded 0.70 kN and 0.20 kW, while at 135 mm and 0.92 m/sec speed, the values were 1.40 kN and 1.26 kW. The predicted values of resistance force and power for the biomimetic furrow opener surface with UHMWPE tubular section ridges at 100 mm depth and 0.28 m/sec speed were 0.45 kN and 0.12kW, while at 100 mm depth and 0.92 m/sec speed, the values were 0.73kN and 0.66 kW.

对于超高分子量聚乙烯材料仿生脊型非光滑结构表面，当耕深100 mm和耕作速度0.28 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.45kN和0.12kW；当耕深100 mm和耕作速度0.92 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.73kN和0.66kW；当耕深135 mm和耕作速度0.28 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.62kN和0.17kW；而当耕深135 mm和耕作速度0.92 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.91kN和0.82kW。

In theory, it can have an unlimited bit depth, that is, each sample point 1-8-bit, 24-bit, 32-bit or 48-bit.

在理论上它能够有无限位深，即：每样本点1-8位、 24位、32位或48位。

The minimum required hardware for Windows 7 is as follows: a 1 gigahertz or faster 32-bit or 64-bit processor; 1 gigabyte of memory for the 32-bit version of Windows 7 or 2 GB for the 64-bit version; and 16 GB of available hard disk space for 32-bit or 20 GB for 64-bit.

Windows 7的最低系统要求如下：至少1GHz主频的32位或64位处理器、32位版本的Windows 7要求1GB内存和16GB可用的硬盘空间；64位版本的Windows 7则要求2GB内存和20GB可用的硬盘空间。

The main technique applied in our method is derived from the features of the eight bit-planes of a gray image. The XOR bit-wise operation is used for two bit pixels among the neighboring bit-planes from the most significant bit to the least significant bit.

本提出方法是将欲隐藏之灰阶影像分解成八张位元平面，并利用其影像前几个位元平面0与1分布会有群聚现象，将两两位元平面间作XOR (Exclusive-or)运算，再使用线性四元树的观念将运算后的资料进行有效BFS编码，之后再隐藏於伪装图之像素最低位元，使最后藏入资料的伪装图影像仍呈现高度清晰的图像显示，也就是说PSNR的测度皆能远大於30dB。

This article in the collection analyzes the domestic and foreign high speed roller bit bearing research pertinent data in the foundation, in view of the present high speed roller bit bearing in the field application existence's question, through to the roller bit bearing main failure mode and the reason analysis, found the extension roller bit service life the theory basis, uses the method which the theory and the experiment unified to develop to the roller bit bearing surface strengthening technology as well as the bearing enclosure system's preliminary study, has provided a new mentality and the method for roller bit's design, further impelled the modern well drilling processing technology the development.

本文在收集分析国内外高速牙轮钻头轴承研究有关资料的基础上，针对目前高速牙轮钻头轴承在现场应用存在的问题，通过对牙轮钻头轴承主要失效形式和原因的分析，找到延长牙轮钻头使用寿命的理论依据，采用理论与实验相结合的方法开展了对牙轮钻头轴承表面强化技术以及轴承密封系统的初步研究，为牙轮钻头的设计提供了一条新的思路和方法，进一步推动现代钻井工艺技术的发展。

Pinout: C High-performance 32-bit RISC Architecture C High-density 16-bit Instruction Set C Leader in MIPS/Watt C Little-endian C Embedded ICE (In-circuit Emulation) 8-, 16- and 32-bit Read and Write Support 256K Bytes of On-chip SRAM C 32-bit Data Bus C Single-clock Cycle Access Fully Programmable External Bus Interface C Maximum External Address Space of 64M Bytes C Up to Eight Chip Selects C Software Programmable 8/16-bit External Data Bus Eight-level Priority, Individually Maskable, Vectored Interrupt Controller C Four External Interrupts, including a High-priority, Low-latency Interrupt Request 32 Programmable I/O Lines Three-channel 16-bit Timer/Counter C Three External Clock Inputs C Two Multi-purpose I/O Pins per Channel Two USARTs C Two Dedicated Peripheral Data Controller Channels per USART Programmable Watchdog Timer Advanced Power-saving Features C CPU and Peripheral Can be Deactivated Individually Fully Static Operation: C 0 Hz to 75 MHz Internal Frequency Range at VDDCORE = 1.8V, 85C 2.7V to 3.6V I/O Operating Range 1.65V to 1.95V Core Operating Range -40C to +85C Temperature Range Available in 100-lead TQFP Package

M5L8253P-5引脚说明： C型高性能32位RISC架构C高密度以MIPS /瓦C小端C十六位指令集C领袖嵌入式冰8 - 16 -位和32位的读写支持256K的片上SRAM的 32位数据总线C单时钟周期存取字节完全可编程的外部总线接口C最大的外部地址空间的64M字节多达8个C芯片选择C软件可编程8位外部数据总线8级优先级，独立可屏蔽，向量中断控制器C四外部中断，其中包括一个高优先级，低延迟中断要求32个可编程I / O口线三通道16位定时器/计数器C三个外部时钟输入C两多用途I / O引脚每通道2个通用同步C两专用外设数据控制器通道每个USART可编程看门狗定时器先进的节能特性 CPU和外设可停用独立全静态工作中：C 0 Hz至75 MHz的频率范围内的VDDCORE = 1.8，85℃2.7V到3.6VI / O的操作1.65V到1.95V范围核心工作电压范围在- 40C至+85 C温度范围内使用的100引脚TQFP封装

A 16-bit z-buffer bit depth in which 15 bits are reserved for the depth channel and 1 bit is reserved for the stencil channel.

对于16位z缓冲区位深度，其中15位是为深度通道保留的，1位是为模具通道保留的。

Chimborazo and Cotopaxi, took me by the hand.

越过琴博腊索山和科托帕克西山。

This car is in a good condition.

这辆车的状况很好。