查询词典 basic angle

Butt Weld and docking and corner combinations Weld, in Weld ends located arc plate and extraction plate in igniting board then leads to the welding seam, joint halfway shall weld joints in front of 2.0 mm Department Firing arc, welding pieces after preheating rod will return to weld the origin, pool filled to the required thickness, before forward welding; Welding speed : Isokinetic welding requirements to ensure weld thickness, width uniform, which masks to look for hot metal and slag bath equidistance (2-3 mm)%; Arc welding rod length : different models and determined that the general requirements of arc length is stable, acid electrode generally 3-4 mm, 2-3 mm normally alkaline electrode%; Welding perspective : According to determine the thickness of two pieces of welding, welding angle has two aspects : First, the angle between the direction of the rod and welding of 60-75 ; The second is the angle between two electrodes and welding around, the same thickness as welding, welding and welding pieces incident angle of 45 ; When the thickness ranging from welding, welding electrode and thick and thin pieces of welding electrode side angle greater than the angle between the side pieces; Arc : admission to the end of each weld should be filled crater, in the direction opposite to the direction of the back-arc welding, arc welding unchanged inside pit in 1974, to prevent the crater bite of meat.

对接焊缝及对接和角接组合焊缝，在焊缝两端设引弧板和引出板，必须在引弧板上引出后再焊到焊缝区，中途接头则应在焊缝接头前方15～20㎜处打火引弧，将焊件预热后再将焊条退回到焊缝起始处，把熔池填满到要求的厚度后，方可向前施焊；焊接速度：要求等速焊接，保证焊缝厚度、宽度均匀一致，从面罩内看熔池中铁水与熔渣保持等距离（2～3㎜）为宜；焊接电弧长度：根据焊条型号不同而确定，一般要求电弧长度稳定不变，酸性焊条一般为3～4㎜，碱性焊条一般为2～3㎜为宜；焊接角度：根据两焊件的厚度确定，焊接角度有两个方面，一是焊条与焊接前进方向的夹角为60～75 ；二是焊条与焊接左右夹角有两种情况，当焊件厚度相等时，焊件与焊件夹角为45 ；当焊件厚度不等时，焊条与较厚焊件一侧夹角应大于焊条与薄焊件一侧夹角；收弧：每条焊缝焊到末尾，应将弧坑填满后，往焊接方向相反的方向带弧，使弧坑甩在焊道貌岸然里边，以防弧坑咬肉。

Biomechanics of should joint at the empty out and transition moment: In the instant of leaving of the left foot, the angle between shoulder and hip was 27°, the angle of pull was 150°, the angle of axis between shoulder was -12°; In the instant of touchdown of the right foot, the angle between shoulder and hip was 72°, the angle of pull was 151°, the angle of axis between shoulder was -85°, the speed of left shoulder was 2.43 m/s, the speed of right shoulder was

腾空和过渡阶段肩关节的生物力学指标：左脚离地瞬间肩髋角度为27 ，拉引角度为150 ，肩轴角度为-12 ；右脚着地瞬间肩髋角度为72 ，拉引角度为151 ，肩轴角度为-85 ，左肩速度为2.43m／s、右肩速度为1.37m／s；左脚着地瞬间肩髋角度为58 ，拉引角度为136 ，肩轴角度为19 ，左肩速度为3.49m／s，右肩速度为1.89m／s。

Methods: 48 patients with Angle's Class II,division 2 malocclusion, 60 patients with Angle's Class II,division 1 malocclusion, as well as 15 patients with high-angle and 15 patients with low-angle facial skeletal type in Angle's Class II,division 1 malocclusion were separately compared with 50 patients with Angle's Class I who had normal profile by cephalometrics .

分别选取48例安氏II类2分类错患者、60例安氏II类1分类错患者以及各15例典型安氏II类1分类高低角骨面型患者为研究组，以选取的50例安氏I类正常面型患者为对照组。采用反映面骨关系的一般性测量项目与作者针对唇齿关系设计的测量项目进行比较分析。

The main work and innovation1 In general , a image compression method has different effect to different image . Some are fit for image which has much high frequency . Some are fit for image which has much low frequency .This paper analysis the applicability of fractal algorithm . In this dissertation , an improved algorithum is given . The basic algorithum without eight change and the joint use of quantitative coding , The compression ratio and PSNR can be adjusted , and it can get more quickly speed of coding .2 To a group of exact fractal code , the decoding image can be any resolution .With this characteristic ,choose the proper domain block and range block,this paper get an algorithum which can get higher decoding PSNR and speed than the basic fractal algorithum.3 Give a new method to calculate the scale factor . The calculation of basic algorithum is complex and enormous . The factor of scale is an important variable of the basic algorithm. Now there are two methods to calculate the factor of scale .A new method was given to calculate the factor of scale. The calculation load and complexity are reduced by the new method. Compared with the basic algorithm , the method can reduce coding time.4 The basic fractal algorithum is based on the Collage theorem and contraction mapping theorem . A mathematic model based on basic fractal algorithum is given .

本文的主要工作及创新点主要包括以下几点：1一般情况下，一种图像压缩的方法对不同特点的图像，压缩效果会有所不同，本文利用分形压缩编码对不同特点的图像进行编码，分析了分形编码对不同图像的编码适用性，利用去掉8种变换的分形编码算法与简单的均匀量化编码方案相结合，得到了一种可以调节压缩比与解码质量的分形编码方案，该提高编码速度6倍以上。2分形编码的特点之一是分形解码的分辨率无关性，即对于一组分形编码可以将其解码到任意分辨率下，本文利用分形编码的这一特点，结合不同的量化编码方案，选择合适的定义域块与值域块及适当的编解码分辨率，得到了一种提高解码质量，编码速度提高12倍以上的加速算法。3比例因子是基本分形算法中的一个重要变量，目前有两种计算比例因子的方法，文中给出了一种新的求比例因子的方法，该方法简化了求比例因子的计算，从整体上减小了基本分形算法的计算量，简化了算法4分形压缩的数学基础是不动点定理与拼贴定理，本文根据基本的自动分形编码方法，建立数学模型对其进行推导，得到了用普通数学的极限理论解释分形编码的数学表达式，从而对由基本分形编码得到的解码图像中的像素点的值给出了确定的表达式。

Evidence suggests that 1 under more stable stratification, the basic flow, if moving faster at low and high levels (particularly in the presence of jets there), allows a resulting meso-β unsteady wave to propagate eastward with respect to basic flow and even at greater velocity compared with it; 2 vertical windspeed shear of basic flow causes instabilities of the TWT perturbation; 3 considering the second derivative of basic-flow wind with respect to z (denoted by zz≠ 0 which is simply given as β* hereafter) the expression for the phase velocity of vortex Rossby wave is obtained, which is unidirectional in propagation with respect to basic flow; 4 VRoW has its physical origin from β*, i.e., from z-varying heterogeneities of y-direction averaged vorticity of the basic flow field; 5 VRoW phase velocity is associated with zonal wave number k, its energy is dispersive and the group velocity exists in the x direction; 6 when windspeed meets the condition of β*, TWT disturbance instability may be that of mixed VRoW and gravity wave; 7 if basic flow is subject to linear shear but does not meet the condition of β*, the TWT instability is that of inertia-gravity wave.

在大气层结比较稳定的情况下，如果基本气流在低层和高层较大(有可能存在低空急流和高空急流)，此时产生的β中尺度不稳定扰动相对于基流向东传播，甚至于快速向东传播。基本气流在垂直方向上的风速切变对于中尺度横波型的扰动起着不稳定的作用。如果考虑基流的二次切变，可以得到涡旋Rossby波的相速度表达式，涡旋Rossby波相对于基本气流是单向传播的。涡旋Rossby波产生的物理根源是基本流场的风速二次切变，亦即基本流场y方向的平均涡度在空间z方向上的不均匀所致。涡旋Rossby波的相速度与纬向波数也有关，它的能量是频散的，其在纬向x方向也存在群速度。在基本流场的风速存在二次切变时，横波型不稳定可能是混合的涡旋Rossby重力波的不稳定；而在基本流场的风速仅仅存在线性切变，不存在二次切变时，横波型扰动的不稳定则是重力惯性波的不稳定。

As walk-off angle and acceptance angle of beam limit the conversion efficiency and the tunable wavelength range of difference frequency generation, research include effective nonlinear coefficient, walk-off angle and acceptance angle as functions of wavelength, the relationship between conversion efficiency and acceptance angle, and the impact of crystals length on the process of frequency conversion.

由于光束的走离角、允许角限制了转换效率和差频调谐波长范围，研究内容还涉及了有效非线性系数、走离角和允许角与波长的关系，转换效率与允许角的关系，以及晶体长度在频率变换过程中产生的影响。

Based on force diagram an analytical expression between some factors and splaying angle of the bar is brought forward, pointing out that splaying angle of the bar should be 2 3 degrees, and slitting angle should be 30 degrees approximately, outboard slant angle on the slitting groove should be 45 50 degrees and bite angle should be 7 8 degrees.

为稳定小规格带肋钢筋的三线切分轧制，对涉及棒材张开角的切分孔孔型诸角度进行了分析，通过对轧件受力状态的讨论，提出了诸因素与棒材张开角之间的解析式，指出满足三线切分稳定轧制时的棒材张开角应为 2°～ 3°，相应的孔型切分角为 30°左右，孔型外侧壁倾角应在 4 5°～ 5 0°之间，咬入角可控制在 7°～ 8°之间等。

Under the vertical load, the strength of rock mass is higher when there is only one group of joint and the dip angle is less than 20 or higher than 80; When dip angle is between 20 to 80, the strength of rock mass is much lower, it is smallest when dip angle is about 50, and it is lower when this kind of dip angle is in combination with other angle.

7在铅直向荷载作用下，岩体中只存在一组倾角小于20°或者大于80°时，岩体的强度相对较高；当岩体中存在一组节理的倾角在20°～80°间时，岩体的强度值很小，而且在与其他倾角的节理组合时，岩体的的强度值变化不太大，特别是当节理倾角为50°左右的时候，岩体的强度相对最低。

Exterior Opposite Angle Area : According to one angle area of the triangle, if we extend the two angle lines to the opposite direction, the area formed by the extending lines which like mirror area to the original angle is called here Exterior Opposite Angle Area.

外部对角映射区：针对三角形的一个角，将构成该角的两条相邻线段进行对角方向的虚线，这两条虚线围成的区域就是该三角形一个角的外部对角映射区。

Exterior Opposite Angle Area: According to one angle area of the triangle, if we extend the two angle lines to the opposite direction, the area formed by the extending lines which like mirror area to the original angle is called here Exterior Opposite Angle Area.

外部对角映射区：针对三角形的一个角，将构成该角的两条相邻线段进行对角方外部对角映射区向的虚线，这两条虚线围成的区域就是该三角形一个角的外部对角映射区。

Fostering the concept of multi-culture firmly and mastering the development of advanced culture correctly are conductive to resisting terrorism, separatism of nationalities and ultraism of religion, which is of great academic theoretical, immediate and profound historical si...

牢固树立多元文化的理念和正确把握先进文化的发展方向，有助于在世界范围内自觉地抵制恐怖主义，民族分裂主义和宗教极端主义。不仅具有重大的学术理论意义，而且也具有重大的现实意义和深远的历史意义。

But if anyone walks in the night, he stumbles, because the light is not in him.

11：10 若在黑夜行走，就必碰跌，因为那光不在他里面。