查询词典 atomizing nozzle

The air just emerging from the nozzle is highly energetic and, as it moves away from the nozzle , it entrains some of the surrounding air which tends to slow the mass down.

气流刚出喷嘴时能量最高，随着飞行距离的增加，周围的空气被卷进来，会使运动着的空气减速。

Gasifies the stove burner nozzle regarding Shell Oil Company's powdered coal gasification craft in although already designed has the flame detector set, but we still thought this design not to be able the very good reflection burner nozzle real situation.

问题：对于壳牌粉煤气化工艺中气化炉烧嘴尽管已经设计有火焰检测装置，但我们依然认为这个设计不能很好的反映烧嘴的真实情况。

In order to compare the new gasifier and the multi-nozzle opposition gasifier,the numerical simulation method at hot state was applied to study the gasifying process both of the new gasifier and the multi-nozzle opposition gasifier.

为了考察新型水煤浆气化炉与多喷嘴对置式水煤浆气化炉的对比，应用数值模拟的方法，对该新型水煤浆气化炉与多喷嘴对置式水煤浆气化炉的气化进行了热态数值模拟研究。

In order to study the pressure-swirl nozzle's atomization characteristic, the particle diameter distributions along axis of the nozzle have been measured by immerging.

摘要为了研究一种高压静电压力旋转喷嘴的雾化特性，采用浸入法测量了该喷嘴喷雾雾滴粒径在喷嘴轴向的分布状况。

However, if the nozzle design is being studied, check the Boost Velocities and Nozzle Design box.

不过，如果喷嘴的设计目前正在研究，检查推动速度和喷嘴的设计中。

To know more altitude compensation and base characteristics of plug nozzle, cold-flow tests on 1-cell 2D linear plug nozzle, which utilize high pressure air as propellant were conducted.

为研究塞式喷管的高度特性和底部特性，采用高压空气为工作介质对单元直排塞式喷管进行实验。

In order to understand the amount of the argon gas entered the mold and the distribution of argon gas in the mold when blowing argon gas through stopper or upper nozzle, the water model with 1∶1 scale was built to investigate the effects of casting speed, argon flow rate, the manner of blowing argon, nozzle port angle and other parameters on the argon gas distribution in the different wide slab casting mold.

针对塞棒、上水口吹氩时，吹入的氩气有多少进入到结晶器钢水内和氩气在结晶器断面上如何分布的问题，采用1：1水模型，重点研究了吹气量、吹气方式、拉速、浸入式水口倾角等工艺参数对不同宽度结晶器内气体分布状况的影响。

The steam is cooled by the cold engine nozzle, condensing and eventually freezing at the nozzle exit to form icicles.

热蒸汽被喷口边缘冷却、压缩并最终形成了喷口边缘的冰柱。

Nozzle due to improper installation, such as threaded is not on tight, equipment, improper adjustment of the gear required to water-cooled cutting torch at work, did not seek pass into the flow of cooling water, and frequent arcing, will cause premature damage to the nozzle.

因喷嘴安装不当，如丝扣未上紧，设备各挡位调整不当，需用水冷却的割炬在工作时，未按要求通入流动的冷却水以及频繁起弧，都会造成喷嘴过早损坏。

On the basis of the mechanism research of nozzle spraying, the measurement of the particle size of droplet which produced by nozzle atomization, the dust examination on the working face and the simulation of dust along the whole working face, the author puts forward a optimized dust-laying system of support spraying, and it has obtained a good dust-laying effect dust-laying work.

由于综放工作面的产尘量较采用其它生产工艺的采煤工作面的产尘量要大，因此，从保护现场作业人员职业安全健康以及企业安全生产的角度考虑，必须将综放工作面的粉尘浓度控制在可容许的范围以内。

The changes of the HAF after liver injury may be related to the volume of blood loss, the intraabdominal pressure and the pneumoperitoneum duration.

肝撞击伤伴失血后肝动脉血流量的变化与失血量、气腹压力以及气腹持续时间等有密切联系。

Reneging on our commitments to the world's poor cannot be an austerity measure, she said.

放弃我们给世界上的穷国的承诺不能成为一种紧缩措施。