查询词典 anode

Reasons of caustic soda concentration abrupt decrease in late period of graphite anode electrolyzer and metallic anode electrolyzer operation were discussed.

对石墨电槽和金属槽运行晚期碱浓度突然降低的原因进行了探讨，认为导致碱浓度降低的主要原因是隔膜的性能和组织成分发生了质的变化，丧失了正常工作的效能。

This paper describes an anode-out-electrolyzer-moulding and sintering process of 60kA side-mounted self-sintered anode for aluminium electrolyzer, analyses the technical feasibility and the economy of this process.

本文论述了60kA侧插自焙阳极铝电解槽阳极的槽外铸型和焙烧方法，分析了这种方法的技术可行性及其经济效果。

With the increase of heat flux density to anode, anode surface temperature will be increased.

随着注入阳极能流密度的增大，阳极表面温度也增大。

A resistor is connected between the output end of the live wire and the output end of the earth wire, another resistor is connected between the output end of the null line and the input end of the earth wire, a neon lamp in a photoelectric coupling switch is connected at the two ends of the earth wire switch in parallel after being connected with the resistors in series, one end of a light sensitive resistor in the photoelectric coupling switch GR2 is connected with the anode DC+ of an integrated circuit IC power in the creepage protector, the other end of the light sensitive resistor is connected with the anode of a diode D3, the cathode of the diode D3 is connected with the triggering pole of the silicon-controlled rectifier SCR in the creepage protector, the neon lamp and the light sensitive resistor are positioned into a dark box, and a small hole which avoids the light sensitive resistor is formed on the dark box.

一种防止地线触点未导通的全能安全插头，包括各带开关的地、零、相三线接线和由零序互感器、脱扣器、放大器、整流器、试验回路和可控硅组成的漏电保护器，所述的火线输出端、地线输出端间连接电阻，所述的零线输出端、地线输入端间串接电阻，光电耦合开关内的氖灯与电阻串联后并联在地线开关两端，光电耦合开关GR2内光敏电阻的一端与漏电保护器内的集成电路IC电源正极DC＋连接、光敏电阻的另一端与二极管D3的正极连接，二极管D3的负极与漏电保护器内的可控硅SCR触发极连接，氖灯和光敏电阻置于暗箱中，暗箱上开一避开光敏电阻的小孔。

After being connected with a resistor in series, the primary input end of a transformer is connected with the output end of the live wire and the output end of the null line in parallel, the secondary output end is connected with the two ends of the earth wire switch in parallel after being connected with another resistor in series, one end of a neon lamp in a photoelectric coupler is connected with the input end of the earth wire E and a secondary end of the transformer, the other end of the neon lamp is connected with the centers of the two resistors, one end of a light sensitive resistor in a photoelectric coupling switch is connected with the anode of an integrated circuit power in the creepage protector, the other end of the light sensitive resistor is connected with the anode of a diode, the cathode of the diode is connected with the triggering pole of the silicon-controlled rectifier in the creepage protector, the neon lamp and the light sensitive resistor are positioned into a dark box, and a small hole which avoids the light sensitive resistor is formed on the dark box.

防止地线触点未导通的全能安全插头，包括各带开关的地、零、相三线接线和由零序互感器、脱扣器、放大器、整流器、试验回路和可控硅组成的漏电保护器，变压器初级输入端串联电阻后并接在火线输出端和零线输出端，次级输出端与电阻串联后并联在地线开关两端，光耦内氖灯的一端与地线E输入端和变压器次级的一端连接，氖灯另一端与二电阻的中心连接，光电耦合开关内光敏电阻的一端与漏电保护器内的集成电路电源正极连接、光敏电阻的另一端与二极管的正极连接，二极管的负极与漏电保护器内的可控硅触发极连接，氖灯和光敏电阻置于暗箱中，暗箱上开一避开光敏电阻的小孔。

An extremely high temperature of anode humidification is also unreasonable; as a result, when the current density is high, the liquid water should be injected directly into anode gas channel to guarantee both high inlet H〓 concentration and well-humidified membrane. 4. The utilization of Pt in the cathode catalyst layer will decrease with the increasing current density; as a result, based on the principle of maximal Pt utilization, the catalyst layer can be designed much thinner or not uniformly in the catalyst distribution.

而在此截面上，交指型流场燃料电池阳极侧的液态水饱和度的极值位置并不确定；在电池阴极处，液态水饱和度的极值总是出现在z=0.002m处的气体扩散层和膜的界面上，并且该处的液态水饱和度沿x方向存在一个最大值，与此相应的氧气的质量浓度分数在该处达到极小值，因此极限电流密度将首相出现该处，但总体来说液态水饱和度沿x方向的分布较为均匀。4。

To solve the problem of complex process and high fabricating cost in the current fabrication techniques of carbon nanotube displays, a fully printing technique was presented to fabricate CNT-FED. All the inner structure cells, including cathode and anode electrode patterns, CNT arrays, phosphor dots and cathode and anode spacer, were fabricated by a screen printing process.

针对现有的碳纳米管场发射显示器制造技术中存在的工艺复杂、成本过高的问题，提出了用于制造碳纳米管场发射显示器的全印刷制造技术，即采用丝网印刷工艺制备CNT-FED器件内部包括各电极图形、碳纳米管阵列、荧光粉点阵和绝缘支撑层在内的所有结构。

The anodic oxidation reactions of borohydride ion involves a novel and complex reaction system of three hydrogen valence states: protide H(superscript --protium H(superscript 0*-proton H(superscript +. Based on cyclic voltammetry and polarization studies, a multi-step mechanism for the oxidation of BH4-on Cu anode in NaOH solution was presented, and a kinetic expression containing the coverages of BH(superscript - subscript 4) and OH-adsorbed on the surface of Cu anode was deduced by the steady state approximation theory.

鉴于BH(上标-下标 4)阳极氧化反应涉及一个复杂的氢负离子H(上标-下标 4)－氢单原子H(上标 0*)－质子H之间价态转化的新颖反应体系，在循环伏安和极化实验研究基础上，提出了NaOH溶液中BH(上标-下标 4)在Cu电极上氧化反应的多步骤机理，导出了包含表面吸附态BH(上标-下标 4， ad)和OH覆盖率θ和θ的电极反应动力学方程。

The results indicated that substrate sandblast contributed to enhance the adhesion between the titanium substrate and the MMO coating, while increasing in the coating mass led to increased durability of the anode, and the coating consumed rate of the coated anode was almost zero.

所研制的RuIrTiSnCo涂层钛阳极具有良好的电化学稳定性和较长的寿命，强化寿命达到96h，约为次氯酸钠发生器标准的5倍，是海水介质外加电流阴极保护中比较理想的辅助阳极。

Knowledge of tungsten anode X-ray tube spectra is essential for X-ray dose control, X-ray image quality evaluation and dual-energy X-ray imaging etc. A model-based tungsten anode X-ray tube spectrum reconstruction method is presented in this paper.

X射线球管光谱信息是进行X射线曝光剂量控制、X射线成像质量评估、X射线双能量成像等必不可少的，为此本文提出一种基于模型的钨靶X射线球管光谱重建方法。

It goes back to what I told you...

现在回到我告诉过你的。。。

With a supporter in Mr Charest and an admirer in Mr Dumont, Mr Harper may be encouraged to call an election himself.

由于在沙雷那边有个支持者，杜蒙那边有个崇拜者，鼓励哈珀为自己举行一次选举。