查询词典 anode rays

The synthesis of the NiFe〓O〓 spinel matrix material, the utility of grain composition of the spinel ingredients when synthesizing the inert anode, and the synthesis of the inert anode was studied essentially in this thesis.

本文重点研究了镍铁尖晶石原料的合成，合成惰性阳极制品时原料的粒度配比和惰性阳极制品的合成。

The results show that Sb addition can diminish the crystal grain, but the content of segregative phase at crystal boundary increases, and the current efficiency of material is low. Compared with Sb addition, Sn addition can also diminish the crystal grain, the current efficiency increases, the content of segregative phase at crystal boundary reduces, but diffusional corrosion of the anode surface is not uniform. The cooperation of Sb and Sn can prevent Si from segregating effectively and enhance the current efficiency obviously. At the same time, anode materials have preferable surface dissolution characteristics.

结果表明： Sb具有细化晶粒的作用，但晶界存在较多偏析相，电流效率偏低；与Sb相比较， Sn也具有细化晶粒的作用，电流效率有所提高，晶界偏析相较少，但阳极的表面腐蚀溶解不均匀； Sn和Sb的协同作用在于能有效地抑制Si的偏析，显著提高阳极的电流效率，使得阳极表面具有良好的腐蚀溶解性。

At 25℃,in 30w/o KOH aqueous,when current density is 2000A/m 2,the evolution oxygen overpotential of the oxidized Ni anode decreases 260mV relative to unoxidized Ni anode.

常温下，电流密度2000A／m2电解30％KOH水溶液时，脉冲电流氧化的Ni阳极析O2超电势比普通Ni阳极下降260mV。

The invention discloses an electrochemical method for preparing a hydroxylapatite particle thin coating on the surface of a metal implant, which comprises the following steps: electrolyte is put into a container equipped with a constant temperature heating system and heated to be 30 DEG C to 95 DEG C, and then the temperature is kept; platinum is taken as the anode and evenly distributed around the container, and the metal implant is taken as the cathode, put in the middle of the container and totally soaked in the electrolyte; DC voltage of 2V to 4V is added between the anode and the cathode, the surface of the metal implant has cathode reduction reaction, the pH value is increased and the supersaturation degree of the hydroxylapatite is also increased, so as to crystalize on the surface of titanium; after 0.5h to 5h of deposition, a layer of hydroxylapatite particle thin coating which can be excellently adhered to the matrix metal is formed on the surface of the implant.

本发明公开了一种在金属植入体表面制备羟基磷灰石颗粒薄涂层的电化学方法，在装备了恒温加热系统的容器中装入电解液，并将电解液加热到30～95℃恒温；将铂作为阳极均匀分布在容器四周，金属植入体作为阴极置于容器中间，完全浸没在电解液中，两极之间加直流电压2～4V，金属植入体表面发生阴极还原反应，pH值升高，羟基磷灰石过饱和度增加，从而结晶在钛金属表面；经过0.5～5小时沉积后，在植入体表面即可形成一层与基体金属结合优良的、薄的羟基磷灰石颗粒薄涂层。

In the course of selecting oxide additives material in the nickel-ferric spinel based inert anode, both the solubility in the cryolite molted salt of oxide additives and the whole thermodynamics action in electrolyte of oxide additives are discussed in this article, thus to have a comparatively reasonable selection of the nickel-ferric spinel based inert anode material.

在选择镍铁尖晶石基惰性阳极材料氧化物添加剂过程中，不仅探讨了氧化物添加剂在冰晶石熔盐中的溶解度，而且还探讨了氧化物添加剂在电解液中的整个热力学行为，从而对镍铁尖晶石基惰性阳极材料做出了较为合理的选择。

Experimental and practical researches of impurity distribution activities and common effect, and analysis on the removing and distribution activity of the impurities in the Guixi Smelter anode copper like As Sb and Bi and the forming structure and conditions of the flotating anode slime have been done.

很久以来，许多从事冶金或相关专业的研究人员，对As、Sb、Bi、Pb等杂质在铜电解精炼过程中的行为进行了多项研究，如对存在形态和行为、阳极泥的形成机理，以及对阴极铜质量的影响进行了一系列的探索研究，并取得了可喜的科研成果。

The copper anode slime produced in one copper smelter domestically was pre-treated with pressure acid leaching method and the leaching behavior of copper,tellurium and selenium in copper anode slime was studied.

以国内某铜冶炼厂所产的铜阳极泥为原料，采用加压酸浸的方法对该铜阳极泥进行预处理，对铜阳极泥中铜、碲、硒等元素的浸出行为进行了研究。

The best combination of anode and cathode flow channel flow was anode flow channel cross-finger, the flow field composed of the cathode flow channel cross-refers was the best combination of flow field.

阳极流道与阴极流道的最佳组合为阳极交指流道、阴极交指流道组成的流场为最佳组合流场。

The formation of the striations was affected by the combination effect with the distribution of spatial potential and surface charge on the anode surface, especially the distribution of electron charge on the anode surface would greatly influence the structure of striations.

条纹现象的形成是由阳极表面附近的空间电势分布和表面电荷分布共同作用产生的，特别是表面的电子电荷分布对条纹现象的影响很大。

In respect that various requirements of load and temperature on different parts of the baker, firebrick lining was chose reasonably, and the dosage of light heat preservation brick is in enlargement. As a result of that, the weight of the furnace was decreased, and increased its performance of heat preservation and cumulation was increased consumedly. With the use of ""W"" type fire tunnel and straight-through dilatation joint, and two enlargement of the perpends on the wall appropriately, all the problems of heat preservation in the anode baker, uniform temperature in the tunnel, and its life span were solved effectively. In the research of anode blocks in and out of the furnace, and of tidying it up, the multi-function crane clamps was alented and the assembling unit was reconstructed, which made it easy to automatic ally assemble the carbon blocks of various specifications with only one set of assembling unit.In the aspects of automation, a new type pulse combustor and solid thermocouple, as a result of that, not only the control accuracy of the fire tunnel's temperature was increased, but also the system function was improned to be more dependable, safe and practicable.

在焙烧炉炉体研究方面，针对焙烧炉不同部位的负荷及温度要求的不同，合理选用耐火材料，加大轻质保温砖的用量，既减轻炉体的重量，又大大提高炉体的保温蓄热性能；火道墙采用&W&型火道结构，直通性膨胀缝，并适当加大火道墙竖缝，有效地解决了阳极焙烧炉的保温、火道温度均一及火道墙的使用寿命等问题；在阳极炭块装出炉及清理等研究方面，通过对编解机组及多功能天车夹具进行改造，实现一套机组对多规格炭块的自动编组、解组及装出炉问题；焙烧炉自动化控制研发中，采用先进的分散式控制系统，研制开发新型脉冲燃烧器及实体型热电偶，不仅提高了火道温度的控制精度，而且提高了系统的可靠性、安全性、实用性。

"Second Life is remarkably easy to work with, and is very popular,"

"第二次生命是显着容易的工作，并且很受欢迎，"

For example, we usually assume that materials are homogeneous and isotropic and free of internal defects or flaws.

为了得到适合有限元分析的模型，我们必须经过如图2所示的简化步骤。