查询词典 adjustable point

Was founded in 1998, the main distribution line agents and flake-like electronic components, has Huake, thick sound, YAGEO resistance, Howard Branch, YAGEO, Samsung, TDK's capacitor, the United States AVX and KEMET, Japan NEC tantalum capacitor, NEC, PHILIPS, MOTOROLA, long electric brand b / triode, ST and ROHM's regulator tube, TOREX, Pui Ling, Li Qi, Jing-fu, Taiwan's power supply LDO regulator IC, DC / DC step-up IC, DC / DC step-down IC, TDK, too enticed, Fenghua inductor, bead, Panasonic adjustable capacitance, an adjustable resistor, three-ying Korea and Japan's Sanyo electrolytic capacitors, and insurance management, light-emitting diodes, thermistors, varistors, the brand of integrated circuits and so on; are a professional supporting electronic components for over many years of experience supporting services.

深圳金星电子科技有限公司成立于1998年，主要代理经销直插式和片状式的电子元器件，有华科、厚声、YAGEO的电阻，华科、YAGEO、三星、TDK的电容，美国AVX和KEMET、日本NEC的钽电容， NEC 、PHILIPS、MOTOROLA、长电品牌的二/三极管，ST和ROHM的稳压管，TOREX、贝岭、立奇、富晶、台湾的LDO电源稳压IC、DC/DC升压IC，DC/DC降压IC，TDK、太诱、风华的电感、磁珠，松下的可调电容、可调电阻，韩国三莹和日本三洋的电解电容，及保险管、发光二极管、热敏电阻、压敏电阻、各国品牌集成电路等等；是一家专业的电子元器件配套商，已有多年的配套服务经验。

Optimal screw path length: The distance from the optimal entrancepoint to the optimal vent point Screw tail distance: The distance between left and right optimalentrance point Transverse section angle: Half of the included angle between left andright optimal screw Sagital section angle: The average of angle between both side optimalscrew with the upper terminal plate 1.2.2 Modify the threshold of CT value to distinguish the rear partof the lumbar, Observate the the optimal entrance point and the adjustable range.

1.2.2三维重建观察螺钉最佳进钉点的位置和各方向螺钉进钉点关系，调整CT值下限阈值使椎弓后部结构尽量显示清晰，以利观察。 1.3统计方法本实验采用SPSS13.0统计软件。对同一椎体左右两侧椎弓根螺钉相对数据行计量资料配对样本t检验，对男女组间相关数据行计量资料独立样本t检验，对男女组内不同腰椎节段间相关数据行单向方差分析及不同腰椎节段间LSD法多重比较。

Sb can combine with Cu and P to form a low melting point compound which lowers the melting point of binary Cu-8P eutectic alloy by nearly 200℃. Bi and Cu can create compounds with low melting point(270℃) distributing at the boundaries and that is the reason why the melting point of (Cu-8P)-Bi is lower than that of binary Cu-8P eutectic alloy. The eutectic cluster can be refined with the addition of Fe, and that is the reason why the addition of Fe can decrease the melting point of Cu-8P alloy. Two means of decreasing the melting point of Cu-8P are found.

一定量的Sb与Cu， P形成低熔点相，从而大幅降低了Cu-8P合金的熔点，使其熔点降低近200℃；加入少量Bi后， Bi与Cu在共晶团晶界上形成熔点为270℃左右的低熔点化合物，且Bi的加入明显细化Cu-8P合金共晶团，从而使Cu-8P合金的熔点降低；加入Fe能明显细化Cu-8P合金的共晶团，使层片间距由8μm减为2μm以下，并使共晶团由层片状向短棒状转变，虽然Fe与Cu形成熔点为806℃的高温相，但Fe的细化作用使得Cu-8P合金的熔点降低，但降低幅度不大。

For a continuous map of trees or graphs to itself, we show the properties that every isolated chain recurrent point is an eventually periodic point, and an isolated chain recurrent point which is not in the orbit of a critical point and has no critical point in its orbit is a periodic point.

第三章主要讨论一些特殊连续统上连续自映射的孤立链回归点与最终周期点之间的关系，证明了对树或图上连续自映射，孤立链回归点是最终周期的，且如孤立链回归点不在临界点的轨道中，也无临界点在其轨道中，则此点必为周期的。

Resistance to Earth magic by an amount equal to your skill in Earth and lasts one hour per point of skill. 1 point resistance per point of skill 2 points resistance per point of skill 3 points resistance per point of skill 4 points resistance per point of skill P

每提高一个土魔法等级可以增加1点防御值每提高一个土魔法等级可以增加2点防御值每提高一个土魔法等级可以增加3点防御值每提高一个土魔法等级可以增加4点防御值 P

Results show that floes' VC and D at the surface water were closely related to current velocity; and the peaks of VC lag those of the current velocity. The lag variation during ebb and flood tides is 10-30min and 30-50 min, respectively. Current velocity at 50 cm/s is a turning point of D vs. vertical average current velocity, before the point, Dm increases with current velocity, and decreases after the point. Similarly, VC at 75μl/L becomes a critical point in the surface water, below the point, D increases with VC, and above the point, D stabilizes.Δp is D dependent, larger floes have much lower Δp than smaller floes. Both D and Δp of floes affect ω. In the surface water during spring tide and neap tide, a power exponent relationship exists between Δp and D, and ω and D.

研究表明：①长江口徐六泾表层絮凝体体积浓度主要受水流流速影响，再悬浮现象明显，体积浓度过程线滞后流速过程线，落潮期间滞后10-30min，涨潮则滞后30-50min；②小于一定流速时絮凝体平均粒径随流速增大而增大，大于一定流速时絮凝体平均粒径则随流速增大而减小，徐六泾夫、小潮表层絮凝体在50cm/s的垂线平均流速时出现平均粒径与垂线平均流速关系的转折；③徐六注大、小潮表层絮凝体平均粒径在体积浓度75μl/L时出现平均粒径与体积浓度关系的转折，体积浓度小于75μl/L时粒径随体积浓度增加而增大，超过75μl/L时粒径随体积浓度的增加变化不明显；④絮凝体有效密度由粒径大小控制，粒径大，有效密度小，反之亦然，粒径和有效密度共同决定絮凝体静水沉速，有效密度和沉速与平均粒径之间均存在良好的幂指数关系。

The critical point means such a state that all the differences between gas and liquid disappear completely,being a most important parameter of dividing the types of fluid and being widely verified in both theory and practice.Currently,four methods of determining critical point are summarized as follows:①laboratory measurement through examining critical opalescence or recording the bubble point and dew point curves;②empiric relation;③calculation of the bubble point and dew point curves by PVT software;and ④ direct calculation according to thermodynamic theories.

随后对临界点进行确定，临界点是气液一切性质差异均消失的状态，是区分流体类型最重要的参数，并得到了理论和工程应用的广泛验证，目前确定临界点大致有四种方法：①实验测定，通过观察临界乳光现象或记录流体的泡点和露点线；②经验关系式；③通过PVT软件计算流体的泡点和露点线；④利用热力学理论直接计算。

Distance from the origin point to O point was (1.84±0.69)cm,unharmful separation point to O point was (0.05±0.12)cm,muscle entry point to O point was (4.35±0.12)cm.

结果 桡神经旋后肌支数为2.6±0.52，其自然分支处距O点(1.84±0.69)cm，干支分离后分支距O点(0.05±0.12)cm，入肌点距O点(4.35±0.12)cm。

And discusses the wrinkle of metal board workpieces shape process,the adjustable Method of point body height,the better design method on point body parameters,the CMM/CAD/CAM in flexible automation system on multipoint die .

介绍了多点冲模的原理，探讨了多点冲模成形过程板料起皱、点销高度的控制调整方法、点销相关参数的确定、冲压柔性自动化系统中CMM /CAD/CAM系统集成等问题。

The dew point demand option consists of the following: Digital Dew Point Display, Adjustable Set Points, Demand Cycle Light, High Humidity Alarm Light With Dry Contact, 4~20mA Output for Remote Annunciation.

该功能包括：数字显示露点、可设定的控制点、露点控制指示灯、高露点报警指示灯及报警信号、输出露点信号（4-20mA的电流信号）。

The system can be widely used in belt weighing and batching process control,etc.

介绍了基于智能模糊控制的嵌入式配料系统的设计方法，对模糊PID控制过程和系统调零作了重点的讨论，同时给出了PID控制的程序流程图和系统定长调零子程序。

"I dunno," she answered,"but if you show me aroun', I'll recognize it from the lighthouse just outside the porthole."

"我不知道，"她回答说，"如果你能带我转转，我能认出来的，因为灯塔就在舷窗外。"