- 更多网络例句与转角杆相关的网络例句 [注：此内容来源于网络，仅供参考]
-
The specially used slope pressure plate and ancillary seal components can achieve the seal of the top of bridging beam and the drainage of the edge of pinch plate of pillar, and settle the joint of multi members of conical top. Ancillary materials can settle the outwardly turning of pyramid, and sequentially achieve kinds of complicated shaped skylight systems.
SK与A60系统采用相同的框架结构和配套材料，可实现空间角度的T形连接，设置专用的斜坡压板及配套密封件，可实现横梁压板端部密封和立柱扣板边缘的排水，可解决锥形顶部多杆件的连接，配套材料可以解决棱锥外转角，从而实现各种造型复杂的采光顶结构。
-
By comparison with the influence of safety factors,nominal height, corner quantity, and geological condition on project cost for 110 kV steel tubular pole structures overhead transmission line, the paper gives the recommendation values of safety factors for conductor and ground line design.
中文摘要：通过对110kV钢管杆架空线路安全系数的不同取值、不同呼称高、线路经过的不同转角数量和不同地质条件对工程造价的影响进行分析比较，提出了线路设计导、地线安全系数的推荐值。
-
The R/C frame structures were modeled with bar system and the column was modeled with multi-springs. The concrete and steel bars in column were considered as springs in order to reflect the coupling influence between the axial force and the moment-rotation relationship, the hysteresis of springs is based on the material properties and the rotation of column section is followed the plane assumption. The moment-rotation of beam section was modeled with trilinear hysteresis model.
混凝土框架分析模型采用杆系模型，其中柱采用多弹簧模型，柱端的混凝土和钢筋作为弹簧考虑以便反映柱轴力与弯矩－曲率的耦合关系，弹簧的滞回关系根据材料特性确定，柱截面的转动符合平截面假定，梁截面弯矩－转角关系采用三折线滞回关系模型。
-
Through Hilbert transform, a signal's plane trace can be get. There are two frequencies in the tested signal, so the signal's plane trace may be looked as the track of the out pole's end when two poles rotate around parallel axles. Using the knowledge of motion synthesis in theory mechanics, a formula to describing the change of plane trace's step length and angle for two-frequency be get. So we may prolongate the tested signal's plane trace from the echo's initial arriving moment, and get a certain length of the signal's prolongation.
通过Hilbert变换可得到测试信号的平面迹线，测试信号中只含有两个频率成分，视为双频信号，双频信号的平面迹线相当于两连杆绕平行轴转动时外杆杆端迹线，利用理论力学中运动合成和瞬心知识，推导出双频信号平面迹线步长平方满足余弦线性复合函数，而迹线转角可视为线性变化，据此可对回波到来之前的测试信号平面迹线作延长，得到一定长度的信号延展段，信号延展段与实测段作差可得到一次、二次回波的第一个波峰值。
-
Design of a high-rise business-living building with double-tower structure with enlarged base ;2. Dynamic response analysis of an asymmetric two-tower tall storeyed building with enlarged base ;3. Based on the mode analysis and time-history analysis of two examples,the vibration characteristics of the connected twin-tower structures with enlarged base in vertical earthquake excitation was discussed in this paper,and the calculating results of the structures with or without connecter,both with enlarged base are compared.
采用平面杆系模型并用静力凝聚法消除结构耦联的水平自由度和转角自由度，结合两个算例的竖向振动模态分析和时程响应分析，探讨了大底盘双塔楼连体结构在竖向地震作用下的振动特性，对比了大底盘双塔楼结构有无连体结构形式的计算结果，得出了这种结构形式在竖向地震作用下的一些特性和具有参考价值的结论。
-
On the condition that the axes of two chain wheels are in the same horizontal plane, the paper considers that the mesh drive of chain and chain wheel is equal to single small angle movement of four-rod mechanism every time on tight side.
在两链轮的回转中心同处一水平面的条件下，视紧边每一时刻链条与链轮的啮合传动为四杆机构作小转角的单向运动，建立起相应的链条速度模型，并据此分析了影响链传动中链条速度波动的因素，得到了一些有益的结
-
NXL Series strain clampis suitable for distribution wire up to 10kV,fixing the aerial insulation aluminium conductor or naked aluminium conductor on the rotate angle or insulator of terminal strain pole, and then fixing and tighting the aerial conductor ,insulation cover and strain clamp are used together.
NXL系列楔型耐张线夹适用于10kV及以下配电线路中，将架空绝缘铝导线或裸铝导线固定在转角或终端固定在转角或终端耐张杆的绝缘子上，从而将架空导线固定或拉紧，绝缘罩与耐张线夹配套使用，起绝缘防护作用。
-
By adopting the center arm six-bar steering mechanism and using the analytical method to synthesize the four-bar mech...
采用中心臂六杆转向机构，由解析法综合出符合要求的四杆机构，再将其绕中间位置镜像，并确定适当调整各杆的位置，使其在给定输入转角范围内，输出转角值尽可能接近阿克曼原理计算的输出值，使车辆获得良好的转向性能。
-
Then through series experiment of coupling beams only add diagonal bars on the basis of traditional reinforcement with Zhanlin, we can conclude this plan for steel bar can satisfied the ductility demand of short-span coupling beams in tube body structure of Chongqing area. Through the computer simulation we can know: Procedures outputs coupling beams'ductility demand mainly in 1.5 to2.0 (maximum value 2.2), comparing the simulation of 8 or 9 degree , we can see the response of the whole structure and yielding degree are much small.
计算机分析程序输出的连梁的转角延性大多在1.5到2.0之间(最大值2.2)，对比以往本学科点对8度和9度等高烈度区的同类型结构的地震作用模拟分析可以看出，6度区大震作用下不管是结构的整体反应还是各杆件的屈服情况都比高9度和8度区小很多。
- 更多网络解释与转角杆相关的网络解释 [注：此内容来源于网络，仅供参考]
-
return bead：转角处的联珠线脚,曲角线,联珠角线脚
return bar ==> 离合杆 | return bead ==> 转角处的联珠线脚,曲角线,联珠角线脚 | return bead and rebate joint ==> 木框转角凹凸榫上联珠线脚