- 更多网络例句与脉冲时间调制相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Spectrum control technology and its application researchBasic theory of smoothing by spectral dispersion in high-power laser system was studied. Periodical frequency modulation was obtained by chirped pulse stacking, and novel special gratings were proposed here to obtain angular spectral dispersion and temporal smoothing of focal spot.
并在国际上首次成功地应用于激光聚变高功率激光系统中。3、激光脉冲光谱控制技术及应用研究研究了高功率激光光谱色散平滑的基本理论，提出利用堆积啁啾脉冲的周期性光谱调制特性和新颖特殊光栅实现光谱角色散和激光束远场焦斑的时间平滑。
-
In order to drive a high impedance load such as HPM sources, it is necessary to commutate FCG's long pulse width, high-current and low voltage pulse to a short pulse with high voltage.
为用FCG驱动象HPM源这样较高阻抗的负载，必须使用脉冲功率调制电路把FCG产生的低电压、大电流、上升时间长的电压脉冲转化为高电压、上升时间短的脉冲。
-
The results show the temporal pulse shape modulation is affected by the broadening factor and the delay time, as spectrum modulation is only affected by the delay time, and the intensity factor changes similarly with the cosine function of the phase factor.
研究结果表明，时间调制与基元脉冲的展宽量及相邻脉冲之间的延迟时间有关，光谱调制只与相邻脉冲之间的延迟时间有关，而强度的演化则与相位因子的余弦函数演化具有一定的相似性。
-
After introducing to the inner structure and the driver timing of a interline area-CCD KAI-1010M briefly,a high speed and low cost CCD driver circuit used in digital space survey camera was designed in a new way.
介绍了行间转移面阵CCD芯片KAI-1010M的内部结构和驱动时序，采用新方法和低成本器件设计了该CCD芯片的驱动电路，把电源和电机控制的脉冲宽度调制技术引入CCD驱动电路，采用超高速运放驱动高速负压信号以减小其上升沿和下降沿时间，达到高速低成本驱动要求，解决了驱动设计中的技术难点。
-
We used counting - interpolation time interval measurement principle and alternate storage ZDT, refined arming timing into two different measurement timing, pointed out requirement of zero dead time arming under different modulation domain measurements , gave the design of zero dead time module in modulation domain pulse analyzer, and introduced the realization method in detail. The correctness of the method has been verified in work.
文章采用计数-内插时间间隔测量原理和交替存储ZDT，并将触发时序提炼为两种不同测量时序，通过分析，指出不同测量时序下实现调制域测量功能对无死区触发要求，给出调制域脉冲分析仪无死区触发模块设计方案，详细介绍无死区需求实现方法，并已在工程中验证了该方法的正确性。
-
The beam pulsing subsystem generates three beam pulsing signals to chop and buncher the beam,and one "start" signal for lifetime measurement.The time measurement subsystem measures the time interval of the "start" and the "stop" signal from PMT.
其二为高精度时间测量电子学系统，该系统必须对脉冲调制电子学系统给出的时间起始信号和探测器给出的时间停止信号进行高精度的时间间隔测量，以达到谱仪装置好于200ps的时间分辨。
-
The effect of timing-jitter on the bit error rate performance of the Gaussian monocycles in pulse position modulated time-hopping UWB systems is investigated and simulated in this paper under various channel conditions, including additive white Gaussian Noise channel and multiple access interference.
本文详细推导出在单链路以及多用户环境中时间抖动对高斯脉冲的跳时脉位调制超宽带系统的性能影响的数学表达式，并作了相应的仿真分析。
- 更多网络解释与脉冲时间调制相关的网络解释 [注：此内容来源于网络，仅供参考]
-
highway：总线
所谓时间槽分配TSA功能是指,它能把串行数据按时间槽(Time Slot)分时处理,它可和脉冲编码调制PCM(Pulse Code Modulation)总线(Highway)之间实现连接或者是在多个μPD7721x电路之间交换数据(进行数据输入/输出).
-
laser diode：激光器
本实验系统使用波长为405nrn、功率为30mW的日亚蓝光半导体激光器(laser diode)作为光源,使用ISA总线接口与计算机通信,将功率数据和脉冲时间数据置入CPLD(复杂可编程逻辑器件)芯片,实现激光多阶功率写入控制和脉冲调制.
-
pd action：比例微分动作
365. PCM, pulse code modulation 脉冲编码调制,脉码调制 | 366. pd action 比例微分动作 | 367. pdm 脉冲持续时间调制
-
PTM Pulse-Time Modulation：脉冲时间调制
PTL Photothermoluminescence 光热发光 | PTM Pulse Time Modulation 脉冲时间调制 | PTMC Polytrimethylene Carbonate 聚三甲基碳酸酯
-
unreliable：不可靠
不可靠(unreliable)的意思是它不能保证IP数据报都是通过射频脉冲调制的或经过复杂调制的信号,在过去15至20年的时间里,随着数字通信技术的飞速发展,这一趋势也越来越明显.
-
pd action：比例微分动作
365. PCM, pulse code modulation ==> 脉冲编码调制,脉码调制 | 366. pd action ==> 比例微分动作 | 367. pdm ==> 脉冲持续时间调制