- 更多网络例句与电荷泵相关的网络例句 [注：此内容来源于网络，仅供参考]
-
The neutron monitor has high sensitivity, light weight and small size. A charge pump circuit is adopted for I-F converter of the gamma monitor. Local data acquisitor consists of CMOS single piece processor with high speed and low power dissipation. A FLEX microcomputer is used as remote centre computer for data handling and graph plotting.
它们的特点是：中子监测器的体积小、重量轻、灵敏度高；γ监测器的测量电路采用电荷泵电路构成的I-F变换电路；本地数据采集器是由高速低功耗CMOS单片计算机为核心组成的；远端中心计算机采用了FLEX微计算机系统对数据进行处理，并以绘图的方式输出，给出直观、便于分析的结果。
-
Additional features include power on reset, overtemperature protection, a charge pump, highCside safing sensor closure detection, an analog multiplexer, a monitor to ensure battery potential, and a programmable monitor to ensure firing potential.
其他功能还包括上电复位，过热保护，安全处理highCside封闭检测传感器，模拟多路复用器，监视器，以确保电池的潜力，一个可编程的监测，以确保发射潜力的电荷泵。
-
This error voltage serves as is controls the electric charge pump breakover resistance (to call that it controls resistance pressure), then obtained a stable output voltage.
这个误差电压被用作是控制电荷泵导通电阻，进而获得了一个稳定的输出电压。
-
It consists of a bridgeable divide-by-8 prescaler with an integrated preamplifier, a 15-bit programmable divider, a crystal oscillator and a reference divider with two selectable divider ratios (512 / 1024), and a phase/frequency detector together with a charge pump which drives the tuning amplifier.
它包括一个集成前置放大器，一个15位可编程分频器，晶体振荡器和一个带有两个可选分率（512 / 1024），和相位/频率检测器连同参考分频器的弥合的分频8预分频器电荷泵的驱动器调谐放大器。
-
Under complex conjugate matching between antenna and charge pump, the measured range can reach 4.3m with stable DC output voltage equal to 1.3V.
在电荷泵电路与电感耦合宽频天线输入阻抗为共轭匹配时，且直流输出电压为1.3V，其量测距离可以到达4.3m。
-
Utilizing low cost P-sub N-well process and compound device, we propose a novel high power efficiency all-PMOS charge pump which has the advantages of four phase Dickson charge pump and Doubler charge pump.
最后，基于廉价的P衬N阱CMOS工艺，综合四相位Dickson电荷泵和Doubler电荷泵的优点，采用复合开关管技术，提出了一种新颖的、高效率全PMOS电荷泵升压电路。
-
A novel driver circuit is presented to solve this problem.A charge pump circuit is used in the design.
文中设计了一种新颖的适用于D类功放的驱动电路，在芯片内部采用一个电荷泵电路。
-
Based on the analysis of operation mechanism and development of the charge pump,as well as the factors limiting its efficiency and speed,a new method using triple-well structure and charge transfer switches is suggested to eliminate threshold voltage drop and body effect.The clock driving circuit is specially optimized to lower output resistance,and speed up the response.
在分析电压泵工作原理和结构演变并指出当前实现方法在驱动和响应上的制约因素的基础上，结合目前先进Flash Memory工作电压和工作要求，提出了结合三阱工艺和CTS方法以消除体效应和阈值电压降从而提高性能的四相位电荷泵设计方法，专门对时钟驱动进行的优化，提高了响应速度。
-
Design and optimization methods of low dropout voltage regulator are studied through the analysis of their topology and operational process.
研究了电容式电荷泵电路的基本类型和动作原理，建立了一个理论模型，给出了电荷泵电路的性能评估方法。
-
It adopts a fractional-N PLL synthesizer to realize the FM modulator.An extra offset current has also been applied to eliminate the effects of the mismatch in CP.
该调制器基于小数分频锁相环技术，并在电荷泵单元中引入额外偏差电流消除电荷泵失配对带内噪声的影响。
- 更多网络解释与电荷泵相关的网络解释 [注：此内容来源于网络，仅供参考]
-
D/A Digital-to-Analog：数字/模拟(转换)
CP Change Pump 电荷泵 | D/A Digital to Analog 数字/模拟(转换) | DEF Design Exchange Format 设计数据交换格式
-
Divider：分频器
如图1所示,锁相环(PLL)包括鉴频鉴相器(PFD)、电荷泵(CP)、低通滤波器(LP)、压控振荡器(VCO)以及分频器(DIVIDER)模块,其基本工作原理见文献[3],[4]. 鉴频鉴相器(PFD)检测Fref与FB的位相差,产生UP和DN脉冲信号,控制电荷泵(CP)对滤波器(LP)进行充、放电,
-
lp：滤波器
鉴频鉴相器(PFD)检测Fref与FB的位相差,产生UP和DN脉冲信号,控制电荷泵(CP)对滤波器(LP)进行充、放电,其充、放电时间正比于UP和DN信号的脉冲宽度,滤波器输出Vctrl为压控振荡器输出信号FVCO频率的控制电压,
-
Main：主
调光和开/关由两线I2C串行接口控制,17种电流源可用作MAIN, SUB, RGB, CAM和AUX LED驱动器,内部的软起动限制了浪涌电流,开路/短路LED保护,短路/热保护,自动电荷泵模式开关,主(MAIN)和副(SUB)显示器有256种亮度,
-
Electroosmotic pump：电渗泵
电荷泵:Charge-Pump | 电渗泵:Electroosmotic pump | 数据泵:data pump