英语人>词典>汉英 : 接头处 的英文翻译,例句
接头处 的英文翻译、例句

接头处

基本解释 (translations)
layup

更多网络例句与接头处相关的网络例句 [注:此内容来源于网络,仅供参考]

Colour code all the connection at the loading station.

在供给站管线接头处用颜色表明各管线

However, we observed distinct abnormalities within presynaptic terminals of spinal MNs at the neuromuscular junction, as well as profound denervation.

无论如何,我们观察到神经肌肉接头处的脊髓运动神经元突触前末梢的明显的异常,还有显著的去神经支配。

The key point for constructing the novel recombinant exotoxin fusion protein B7-PE40 KDEL was to preserve the molecular biology characteristics of themselves, such as flexibility, antigenicity, hydrophilicity, epitope and secondary structure and to enhance their cytotoxic activity.

分子构建成功新型重组B7-PE40KDEL融合蛋白的关键在于,要使所构建的B7-PE40KDEL能分别保留B7-1、B7-2和PE40KDEL各自的表位特征、没有新的抗原表位产生、柔性接头处具有极低的抗原性以及具有更强的杀伤效力。

Install drain valve in bottom float chamber tapping.

在底部浮子腔接头处插入排水阀。

After technology improvement, the used material reduces, and the crack, shrinkage cavity of end face and puckering don't exist in the furcation part.

工艺改进后,材料减少,原来存在的裂纹、缩口以及接头处参差不齐的问题得到彻底地解决。

Based on the analytic model of an eccentric slider crank mechanism with elastic effects at both joints of the coupler and four coupler Mathieu-typed equations of motion in terms of the generalized coordinates of the system,the extract solution is developed from the improved Hill method with accelerated convergence.

在所建立的连杆接头处具有弹性效应的曲柄滑块机构的动态解析模型以及在广义坐标下推导出的4个马修型运动方程的基础上,由具有加速收敛性的改进希尔法进行了精确求解。

Wear may sometimes be detected by using a small pry bar under the joint.

有时,在接头处用一个小杠杆就能检测出耐用性。

Peplos appeared at the junction of steel-wire when the fracture was healed.

宿主反应:待骨折愈合,内固定取出时,发现在钢丝接头处有囊膜形成。

Objective To establish an artificial somatic-autonomic reflex arc in rats and observe the following distributive changes of neural fibers in the bladder.

目的 观察体神经-内脏神经人工反射弧建立后,大鼠膀胱肌间神经丛分布的改变以及神经肌肉接头处的变化。

The analysis of some company"s hose failures indicates that 70% of the failures are caused by leakage between the hose and the fitting. In order to solve the hose fitting leakage problems of the hose assemblies, the experimentation has been carried out and the conclusion is that the fitting"s intension is not strong enough to prevent leakage. Plasticity theory is utilized to analyze the relationship of the working pressure of the hose, the connector material and the geometric dimensions. The calculation about crimp power of the hose assemblies is found, and the suggestions for assembly are given according to plasticity principle, also the program for analysis of fittings intension is developed with AutoLisp which runs in AutoCAD.

由某公司提供的胶管组合件故障资料分析,该公司的约70%胶管故障是由于接头处漏油造成的,为解决软管组合件接头处漏油的问题,本文通过试验得出了接头强度满足不了密封要求的结论,从塑性力学角度给出软管工作压力与软管接头的材料、几何尺寸之间的关系,对胶管组合件扣压力量给出计算方法,对扣压工序依据塑性力学原理提出指导意见,并在AutoCAD平台上以AutoLisp语言编写了接头零件的强度分析计算程序。

更多网络解释与接头处相关的网络解释 [注:此内容来源于网络,仅供参考]

Openings adjacent to welds:开孔,邻近焊缝

Offset of edges of plates at joints 在接头处板边的偏差 | Openings adjacent to welds 开孔,邻近焊缝 | closure of 封闭

FAB:抗原结合片段

重症肌无力是由抗乙酰胆碱受体抗体介导的自身免疫病,而致病性抗乙酰胆碱受体抗体多为IgG类抗体,它的2个抗原结合片段(Fab)与神经肌肉接头处突触后膜上相邻的2个乙酰胆碱受体结合,可加快乙酰胆碱受体的内化作用(即抗原调变);

starved joint:缺胶接头,接头处胶粘剂不足

spigot joint 插管接头,套管接合,接嘴,联轴节接合 | starved joint 缺胶接头,接头处胶粘剂不足 | T joint T形接合(头)