折
- 更多网络例句与折相关的网络例句 [注：此内容来源于网络，仅供参考]
-
The safety factor obtained with the relationship between elastic strain energy and the reduction coefficient is similar to that obtained by other traditional slope steady analyzed method.
摘 要：为分析采用强度折减法确定边坡安全系数过程中边坡弹性应变能随折减系数变化与边坡失稳破坏的内在联系，建立数值模型，记录边坡弹性应变能与折减系数关系曲线；通过对某边坡的分析，绘制弹性应变能与折减系数关系曲线。
-
The relationship between elastic strain energy and the reduction coefficient can be used as criteria in slope stability analysis using strength reduction method.
研究结果表明：采用强度折减法，当边坡处于稳定状态时，折减系数增大引起边坡变形增大，导致边坡体弹性应变能随之增大；但是，边坡岩土体能够承受的弹性应变能是有极限的，当折减系数增大到某一值时，边坡体的弹性应变能达到极限，再增大折减系数将导致边坡失稳破坏；边坡体弹性应变能与折减系数服从指数关系；利用弹性应变能与折减系数关系曲线得到的边坡安全系数与采用其他经典的方法所得边坡安全系数基本一致，弹性应变能随折减系数变化而变化的规律可以作为边坡稳定性强度折减法分析的失稳判据。
-
The relationship between the ratio of Ca to Si with shrinkage value was needed to be studied further.The strength of M-AAS was comparatively high, but the flexural strength was regressed in the long term. The compressive and flexural strengthes of 3 days were able to surpass 8MPa and 78MPa, respectively, and compressive strength of 90 days were all around 100MPa, but compared to flexural strength of 28 days, the flexural strength of 90 days was regressed by 19.0%. The high strength property of M-AAS associated with its hydration products and Interfacial Transition Zoo. The main hydration products of M-AAS were microcline and CSH, no calcium hydroxide was found. The coexistence of microcline and CSH worked as micro-aggregate by each other, and no weak ITZ, both resulted in its high strength. The regression of its strength was related to its high shrinkage property, because the crazing caused by shrinkage would decrease the strength, especially the flexural strength.
M-AAS强度较高，但长期抗折强度倒缩。3天抗折和抗压强度分别可超过8MPa和78MPa，90天抗压强度在100MPa左右，但90天抗折强度比28天抗折强度相比低19.0％。M-AAS的高强特性与其水化产物和界面过渡区有关，M-AAS的水化产物主要为微斜长石和CSH凝胶，没有氢氧化钙，微斜长石与CSH凝胶相互填充和配合共同起到强度的作用，M-AAS砂浆中几乎没有发现界面过渡薄弱区。M-AAS的强度倒缩现象与其收缩值较大有关，收缩会引起M-AAS硬化体内部出现微裂缝，使强度下降。
-
Two He-Ne lasers have been designed in experiment,one with simplest 2D axisymmetric folded-combined cavity that are composed of a concave-plano-concave folded cavity and a plano-concave cavity , and other with simplest 3D axisymmetric folded-combined cavity that are composed of two concave-plano-concave folded cavities and a plano-concave cavity.
本文实验设计了由一个凹-平-凹折迭腔与一个平凹腔组合的二维轴对称折迭-组合腔型He-Ne激光器及由两个凹-平-凹折迭腔与一个平凹腔组合的最简单立体轴对称折迭-组合腔型He-Ne激光器。
-
The results showed that when the cross-sectional shape as a regular polygon unchanged, all the param-eters are only associated with the width of the crease.
结果表明：当截面形状不变且为正多边形时，各尺寸参数只与折痕宽度有关；随着折痕宽度的增大，所有参数都按比例同步增大，即该类新型纸容器的各折边长度尺寸由截面形状及折痕宽度唯一确定。
-
This reporter has learned that March 23 flight from Shanghai to Xiamen, the price of 3 packs 290, Day 20 Shanghai to Sanya Price for 4 packs of 760 yuan, the Shanghai-Kunming route March 23 Price for 5 packs of 530, 3 month on the 19th route from Shanghai to Zhangjiajie Price for 4 packs 530, flights from Shanghai to Chengdu on March 23 for the 4 pack Price 640 yuan, while in the previous February, February 11 from Shanghai to Chengdu, the price of 5 discount at 810 yuan Shanghai to Zhangjiajie February 13 at the price of about 6 packs, air routes from Shanghai to Xiamen, the price of 6 at around 580 fold.
记者了解到，3月23日上海至厦门航线的价格为3折290元，20日上海到三亚的价格为4折760元，上海至昆明航线3月23日的价格为5折530元，3月19日上海至张家界航线的价格为4折530元，上海至成都航线3月23日价格为4折640元，而在此前2月份，2月11日上海至成都的价格在5折810元，上海至张家界2月13日的价格约在6折，上海至厦门航线的价格在6折580元左右。
-
According to the theory of slope break belt, he slope break belt types based on their shapes in Beixi slope are classified into inverted fault step type, single curve break type, multiple-step fault break type, and multiple-step slope break type.
应用坡折带理论，根据形态特征将贝西斜坡的坡折带划分为反向断阶型、简单弯折型、多级断折型和多级坡折型4种类型。
-
In this paper, we have investigated the development of organic-inorganic composite PR material, prepared a new organic-inorganic nanocomposite PR material of PVK-CdS/DMNPAT, characterized every component and tested it photorefractivty by two beam coupling experiment.The work of this paper includes mainly three parts as followed:(1) An azo dye DMNPP was prepared via reoxidation and coincidence reaction and its derivative DMNPAT was prepared by attaching a long methacrylate chain in DMNPP.
本学位论文分析了国内外有机无机复合光折变材料的研究现状，根据目前有机无机纳米复合光折变材料研究中存在的问题，依照有机无机纳米复合光折变材料各功能组分的基本要求设计并制备了PVK-CdS/DMNPAT的有机无机纳米复合光折变材料，对各组分的合成表征以及光折材料的光折变性能做了较系统的研究。
-
Hand-folded four-Pack (50g/mdoes-quadratical and the following paper) or hand-fold three fold (60-80g/m-squared paper) in a manner worthy of the books which should be in the book-to-last three fold in a manner worthy of the fold sewup hemomediastinum, to rule out the air and in a manner worthy of the book to prevent wrinkles appear, but now there are many flats in manual folding, knowing very well that should be hemomediastinum, but the pursuit of production would go for the big is not hemomediastinum, and finally after the wrinkles in buchbinderei and unrectifiable is extremely serious.
手工折四折（50g/m平方及以下的纸张）或手工折三折（60-80g/m平方纸张）的书帖均应在书帖倒数第三折折缝上破口，以排除书帖内空气而防止皱褶出现，但现在有许多单位在手工折页时，明知应破口，但一味追求产量就是不破口，最后书籍装订后皱褶极为严重而无法补救。
-
It is found that for the same volumetric flow rate, the pressure drop in the shell side of the curved baffle heat exchanger is remarkably lower than that of the traditional one. And the pressure drop percentage deceases even more for a smaller curvature radius of the curved baffle and height of the baffle cut.
结果发现：在流量一定的情况下，曲面弓形折流板换热器的壳程压力降明显低于普通弓形折流板换热器的壳程压力降，而且随着曲面折流板曲率半径和折流板圆缺口高度的减小，曲面弓形折流板换热器的壳程压力降降低的百分比增大。
- 更多网络解释与折相关的网络解释 [注：此内容来源于网络，仅供参考]
-
accelerated depreciation：兩- 加速折舊(貶值) 港- 加快折舊 台- 加速折舊
abuse of trust 港- 違反信託 | accelerated depreciation 兩- 加速折舊(貶值) 港- 加快折舊 台- 加速折舊 | accelerating trend 內- 加快態勢 港- 加速趨勢
-
depreciation reserve：內- 折舊儲備金;折舊準備金 港- 折舊儲備;折舊準備
depreciation of exchange rate 兩- 匯率貶值 | depreciation reserve 內- 折舊儲備金;折舊準備金 港- 折舊儲備;折舊準備 | depress the market price 兩- 壓抑市價 港- 打擊市價
-
depreciation accounting：兩- 折舊會計
depreciation 兩- 貶值;折舊 港- 損耗 台- 折舊 | depreciation accounting 兩- 折舊會計 | depreciation allowance 兩- 折舊費 內- 折舊備抵 港- 折舊免稅額
-
folded laser：折疊雷射 = 折疊[腔]激光器
folded cavity 折疊共振腔 = 折疊腔 | folded laser 折疊雷射 = 折疊[腔]激光器 | folded potential 折疊勢
-
mansard roof：复折式屋顶,复折屋顶,折线形屋顶
mansard dormer window 复折屋顶窗 | mansard roof 复折式屋顶,复折屋顶,折线形屋顶 | mansard roof truss 复折屋架
-
pincher：折叠、折印、夹锭钳
pinch压折、折皱、折印、夹紧、压紧、压缩 | pincher折叠、折印、夹锭钳 | pincher trees折皱
-
CREASING MACHINE：压波纹机, 折皱机 折边机, 弯折机
creaser | 摺皱者, 各种压摺之器具 | creasing machine | 压波纹机, 折皱机 折边机, 弯折机 | creasing strength | 耐折叠强度
-
fanfold paper：扇折纸,折迭式报表纸,折迭式记录纸
扇折 fanfold | 扇折纸,折迭式报表纸,折迭式记录纸 fanfold paper | 折迭纸式打印机 fanfold printer
-
Hinge Line：折叶线
选择父视图之后,定义折叶线(Hinge line)图标自动激活(折叶线是与投影方向垂直的线). 利用矢量功能选项,可在父视图中定义向视图的折叶线,这时,窗口中会出现表示折叶线方向的矢量符号. 如果指定的折叶线方向不符合要求,
-
mansard roof：复折式屋顶,复折屋顶,折线形屋顶
mansard dormer window ==> 复折屋顶窗 | mansard roof ==> 复折式屋顶,复折屋顶,折线形屋顶 | mansard roof truss ==> 复折屋架