- 更多网络例句与多重峰相关的网络例句 [注：此内容来源于网络，仅供参考]
-
The measured spectra are analysed with the multiplet alpha spectra analysis program MULT. Thus the alpha-particl probabilities of the five nuclides are obtained.
放射源的α能谱，用多重峰α能谱分析程序MULT对所测α能谱进行非线性分析，获得了这几种核素发射α粒子的辐射几率。
-
A two-proton multiplet at d5.00(2H,m,H-11)and a one-proton doublet doublet at d5.90 could be assigned to an ABC pattern.
一个两质子在d5.00(2H，m，H-11)的多重峰和一个单质子在d5.90 的双峰可以表明该分子是一个ABC的形式。
-
Keywords Actinide nuclides Multiplet α-spectra α-particle emission probabilities Total uncertainty
锕系核素；多重峰α能谱；α粒子辐射几率；总不确定度
-
The results show that the occurrence of postnoon multiple arcs demonstrates a single peak distribution, and the maximum peak is at 1445 UT (1645 MLT) and the position lies to the nightside part of "1500 MLT hot spot"(1300-1700 MLT).
本文利用2001-2003年南极中山站175天全天空摄像机观测，对午后多重极光弧的出现率及其与Kp指数的关系进行了统计分析，结果表明午后多重极光弧出现率呈一单峰分布，最大发生率出现在1445UT(1645MLT)，其位置在1500MLT极光热点(1300-1700MLT)近夜侧的部分。
-
The cold crystallization of uniaxially oriented PET fibers was investigated. The preferred condition for preparation of uniaxially oriented amorphous PET fibers was explored in terms of the draw ratio of as-spun PET fibers at different temperatures.
研究了单轴取向PET纤维的冷结晶过程，对出现的多重结晶峰进行了参数解析，得到了Avrami指数、结晶扩散活化能等结晶动力学参数。
-
Venner C H Multilevel solution of the EHL line and point contact problems Enschdede, Netherlands:University of Twente , 1991,null
郭峰 椭圆接触微观热弹性流体动力润滑求解的多重网格算法研究青岛建筑工程学院硕士学位论文， 1998，null
-
Two series of polyurethane acrylate grafted acrylic resins (Acr-g-TPU-PETA and Acr-gPPU-PETA) self-emulsifying systems are obtained by grafting -NCO group modified polyurethane acrylates with acrylic copolymer prepared from n-butyl acrylate, styrene,βhydroxyethyl methacrylate and acrylic acid The self-emulsifying systems showed Newtonian fluidity with viscosity closed to that of water, the solid contents were around 30% The T〓 of 15～4℃ for dried film before photocuring favored film formation at room temperature DSC and DMA results showed that PU-PETA is compatible with acrylic resin in the grafted resin The TG and dTG curves for Acr-g-PU-PETA samples were substantially different from the corresponding blends, and the brodened dTG peaks for photocured grafted resin suggest that there might be multiple interactions among chain segments The photocued film of the grafted resins self-emulsifying system exhibited good overall properties with polyurethane acrylate grafts ranging from 30% to 50%, and Acr-g-TPU-PETA series showed better properties than Acr-gPPU-PETA series The adhesion of the photocured film was 1～2 grade, impact strength was 50kg-cm and flexibility was 1mm The Shore hardness and the adhesion of the film decreased markedly if PETA was replaced by HEMA as photoactive group due to the lower C=C double bond content in the grafted resin The polyhydroxy amine-linked thioxanthones photoinitiators can be evenly dispersed in self-emulsifying system without color spot appearing in the dried film The films photocured with IV〓～IV〓 generally exhibited higher Shore hardness, gloss and solventresistance than that cured with Irgacure 2959 and did not induce the rusting of the iron substrate Pigmenting with titanium oxide had no effect on the photocuring The polyhydroxy amine-linked thioxanthone IV〓 and IV〓 can be new candidates for the formulation of titanium oxide pigmented photocurable water-borne coatings for their pale-yellow appearance and slight interference with the color of the coatings WB 4759 with high water-solubility coalesced and separated from the dried resin film, and even induced the rusting of iron substrate.
以丙烯酸丁酯，甲基丙烯酸-β-羟乙酯，丙烯酸及苯乙烯合成厂丙烯酸共聚树脂，并与含-NCO端基的聚氨酯丙烯酸酯接枝反应，经水性化后，得到两个系列（Acr-g-TPU-PETA和Acr-g-PPU-PETA）各5个不同配比的丙烯酸树脂接枝聚氨酯丙烯酸酯自乳化体系，粘度与水相近，为牛顿流体，固含量30％左右。光固化前干燥涂膜的玻璃化转变温度在-15℃～4℃之间，有利于室温下成膜。DSC及DMA谱表明两种树脂基本相容。Acr-g-PU-PETA的热失重行为明显不同于共混材料，接枝样dTG峰明显宽化，表明接枝样中链段之间的相互作刚有多重性，丙烯酸树脂与聚氨酯之间有一定的相容性。接枝树脂自乳化体系光固化涂层的综合性能以聚氨酯丙烯酸酯成分为50％～30％者相对较好，且以Acr-g-TPU-PETA系列更理想。光固化膜的附着力为1～2级，冲击强度为50kg·cm，柔软性多为1mm。以HEMA代替PETA作为接枝树脂的活性基团，碳—碳双键密度太低，光固化膜交联点太少，硬度和附着力均较差。多羟基胺连硫杂蒽酮光引发剂能均匀分散于树脂自乳化体系和接枝树脂干膜中，不出现色斑，光固化膜肖氏硬度一般高于以Irgacure 2959为光引发剂的光固化膜，光泽度及耐丁酮溶剂性能均有所提高，不会诱导铁基生锈，钛白着色对光固化结果几乎没有影响。本论文所合成的多羟基胺连硫杂蒽酮光引发剂IV〓与IV〓为浅黄色，对光固化涂层的颜色干扰较小，为配制钛白着色光固化水性涂料提供了新的光引发剂。水溶性太强的WB 4759在干膜中易聚结析出，且对所附着的铁基有诱导锈蚀作用。
- 更多网络解释与多重峰相关的网络解释 [注：此内容来源于网络，仅供参考]
-
multimodal behavior therapy：多功能行为治疗法
multimodal 多峰的 | multimodal behavior therapy 多功能行为治疗法 | multimodal distribution 多重模态分布
-
multiple chiasma：复交叉
multiple antigenic peptide 多抗原肽[以赖氨酰残基作内核而以多拷贝的肽抗原作外表层的分枝状合成肽] | multiple chiasma 复交叉 | multiplet 多重峰;多重态
-
multiplet：多重峰;多重态
multiple chiasma 复交叉 | multiplet 多重峰;多重态 | multipotency 多潜能性
-
integrals：积分
它能将从MS得到的分子式(molecular formula)与从1D和2D NMR数据中获得的化学位移、峰多重性(peak multiplicities)和积分(integrals)相结合,自动地推断出未知化合物的结构.
-
voltages：电压
而这关键技术能够在同一晶片上实现多重可变电压(voltages)的电压区块(power domain),也能够在无需颠峰效能时降低电路电压. Cadence益华电脑低功耗解决方案从早期的设计规划开始,涵盖前端设计、合成与实体设计实现,
-
MHD：磁流体动力学
从飞船的观测结果、磁云形态及演化的理论模型、磁流体动力学(MHD)数值模拟、激波对磁云的作用、多重磁云等5个方面,评述了行星际磁云的研究成果及最新进展.在太阳峰年,大部分的非重现性地磁暴都与磁云有关.最近的研究表明,