中点

基本解释 (translations)

midpoint

词组短语

median point · middle point · neutral point · mid-point · mid-position · centre point

与中点相关的网络例句 [注：此内容来源于网络，仅供参考]

Align the center of the slides with the center of the container bottom panel.

滑轨中点与柜底板的中点对齐，把滑轨固定在柜底板上。

Results: When the slide segment was retained 1 mm width,the fifth cheek tooth and anterior edge midpoint of condyle process anterior slope and coracoid process showed negative displacement and the angle of mandible and the posterior edge midpoint of condyle process posterior slope showed positive displacement on x axes.

结果：在牵张过程中牵张侧下颌骨标志点位移趋势为在内外方向上第五臼齿、喙突、髁状突前斜面前缘中点的运动趋势是向外的，而下颌角、髁状突后斜面后缘中点的运动趋势是向内的；在前后方向上第五臼齿、喙突的运动趋势是向后的，而下颌角的运动趋势是向前的；在上下方向上第五臼齿的运动趋势是向上的。

2At drive than will certainly,driven gear, while having the more same sizes, hyperboloid have diameter not larger of gear wheel not initiative than corresponding spiral awl gear wheel, intensity and bigger initiative gear wheel axle and bearing rigidity of higher teeth of a cogwheel.

螺旋角是指在锥齿轮节锥表面展开图上的齿线任意一点A的切线TT与该点和节锥顶点连线之间的夹角。在齿面宽中点处的螺旋角称为中点螺旋角(图5—4)。通常不特殊说明，则螺旋角系指中点螺旋角。双曲面齿轮传动比为

Methods From Jun. 2001 to Sep. 2003, 11 cases(2 with complication of erysipelas ) of upper limb lymphedema being treated with radical mastectomy for more than 2 years were used as model.

2001年6月～2003年9月选择乳腺癌术后上肢淋巴水肿2年以上的患者11例，患侧上肢明显水肿，外观增粗，前臂中点周径与健侧平均相差4.4cm，上臂中点周径与健侧平均相差6.6cm，活动受限，其中2例有丹毒反复发作。

Based on the analysis of the affected extent of the neutral-point potential by every space vector on all kinds of voltage and current conditions the concept named neutral point control grade was proposed for the first time in this paper. The calculation formulas of NPCG were presented as well. Based on NPCG, a novel modulation scheme called optimized 3D space vector modulation (O3DSVM) scheme was proposed in a-b-0 coordinates based on the translation principle of axes, by which the space vectors with higher NPCG values are selected to synthesize the object vector to suppress the unbalance of the neutral-point potential.

该文通过对各种电流电压状态下每个三维空间矢量对直流中点电位的影响进行分析，提出了"中点控制度"(neutral-point control grades，NPCG)的概念，并给出了NPCG的计算公式；基于NPCG，在a-b-0坐标系下提出一种基于坐标平移原理的新型"三维矢量优化选择调制策略"(optimized 3D space vector modulation，O3DSVM)，该调制策略能优化选择NPCG值较高的矢量以合成目标矢量，从而达到最大程度控制直流中点电位偏移的目的。

Results: For normal living body. extensor hallucis longus was about (44±4.26)mm lateral to tibialis anterior muscle at the transverse striation of ankle,(2.00±2.22)mm lateral to the middle point of tarsometatarsal joint,(1.32±1.46)mm lateral to the middle point of metatarsophalangeal joint, and it inserted into the center of the base of distal phalanx with the range of (2.22±2.42) mm.

结果：正常长伸肌腱的位置在踝横纹处位于胫骨前肌外侧(9.44±4.26)mm，在跖附关节中点外侧(2.00±2.22)mm，跖趾关节中点外侧(1.32±1.46)mm，止点位于末节趾骨基底中点(2.22±2.42)mm范围内，长屈肌腱在跖趾关节中点外侧(0.44±2.42)mm。

Flexor pollicis longus muscle tendon was about (0.44±2.42)mm lateral to the center of metatarsophalangeal joint. For cases of HV, extensor hallucis longus was about (9.32±3.46)mm lateral to tibialis anterior muscle at ankle transverse striation,(3.00±2.22)mm lateral to the center of tarsometatarsal joint.

在外翻的患者中，长伸肌腱在踝横纹处位于胫骨前肌外侧(9.32±3.46)mm，在跗跖关节中点外侧(3.00±2.22)mm，跖趾关节中点外侧(4.22±2.26)mm，止点位于末节趾骨基底中点(2.02±2.32)mm范围内，长屈肌腱在跖趾关节中点外侧(3.24±2.32)mm。

A formula was derived and given to calculate the Shupe effect in the quadrupolar winding including the effects of the midpoint deviation and the fiber diameter. This formula, compared with that considering only the ideal situation, can not only be used to account the thermally induced nonreciprocal phase shift under different midpoint deviations and fiber diameters, but also indicate the effects of the fiber coil's structure when there exist nonideal factors.

本文分析了中点偏差、光纤直径尺寸对四极性绕法中相向传输光对称性的破坏，推导给出了包括中点偏差和光纤直径尺寸影响的四极性绕法热致非互易相移的计算公式，该公式相对于只考虑理想情况的计算公式，不仅能计算不同中点偏差和光纤直径情况下的热致非互易相移，而且揭示了存在非理想因素时，光纤环结构对热致非互易性的影响。

The mean height from the inferiormidpoint to the edge of inferior joint line was 4.47±0.77mm , 8 percents of thespeciments had a height of less than 3.5mm , and 33 percents of these had aheight of less than 4.0mm .

侧块后中点至中线的距离18.19±1.38mm，侧块后中点至下关节面的距离 4.47±0.77mm，其中小于3.5mm 的占 8.00%，小于 4.0mm 的占 33.00%，侧块后中点在侧块垂线和侧块轴线方向上至侧块前表面的距离分别为 15.91±1.37mm 和18.72±1.59mm。

Then, to find the middle point, obvious inflexions and points which have an equal distance from any end point of the drawing symbol section, are first detected as candidate for middle points in our program, and then those other possible points are calculated after merging and deleting these former middle points.

在计算符号段中点时，首先分别计算境界线的明显拐弯点和距离两端半个符号段长度的点作为跳绘符号段中点，将这些中点进行一定的合并与删除后，再计算两两中点间可能存在的其余符号段中点。

与中点相关的网络解释 [注：此内容来源于网络，仅供参考]

Mid point of Curve：曲线中点

Micrometers 微米 | Mid point of Curve 曲线中点 | Mid Point 中点

midpoint, middle point：中点

中垂线|perpendicular bisector | 中点|midpoint, middle point | 中点法则|midpoint rule

midpoint：捕捉中点

不过得把面(PLAN)转成POLY的,然后选择这样就拷贝出厚度了举例:如果你同时开启了捕捉顶点(vertex)和中点(midpoint),那么当按下alt+s后会只捕捉顶点(vertex),中点(midpoint)将被关闭再按下alt+s后会只捕捉中点(midpoint),顶点(verte

midpoint：中点 中点

Middle Center 正中点 正中 | Midpoint 中点 中点 | minsert 多重插入 插入图块阵列

class midpoint：组中点

x 轴为各组的组中点(class midpoint)或各组的组界(上下限),y 轴为次如:针对某班级学生修 统计学课程学期成绩(ratio scale)分 级距的直方图分布. x 轴为各组的组中点(class midpoint)或各组的组界(上下限),

midpoint weighting：中点权

midpoint of pay zone 油层中部深度 | midpoint weighting 中点权 | midpoint 中点

Mean dedendum：中点齿根高

Mean cone distance 中点锥距 | Mean dedendum 中点齿根高 | Mean diametral pitch 中点径节

class mark：组中点;区中点

class limit 组限;区限 | class mark 组中点;区中点 | classification 分类

mid-point formula：中点公式

mid-point 中点 | mid-point formula 中点公式 | mid-point theorem 中点定理

mid-point formula：中点公式Btu中国学习动力网

mid-point 中点Btu中国学习动力网 | mid-point formula 中点公式Btu中国学习动力网 | mid-point theorem 中点定理Btu中国学习动力网