英语人>词典>英汉 : trolleying的中文,翻译,解释,例句
trolleying的中文,翻译,解释,例句

trolleying

trolleying的基本解释
-

[变形] trolley的现在分词

n.

手推车, 电车, 台车

vt.

用手推车运

vi.

乘电车

更多网络例句与trolleying相关的网络例句 [注:此内容来源于网络,仅供参考]

Length of the compages hoist jib is shown as fig.4-9, and set up them together by pins, after connected the first section and the second section, then install trolley and nacelle, and fixup them on the root of the hoist, and lay up the hoist on the support which has 1m height, so that the trolley and nacelle depart from the ground (shown as fig.4-11), then install the trolleying mechanism.

4.2.12.2 按照图 4-9 组合吊臂长度,用相应销轴把它们装配在一起,把第一节臂和第二节臂连接后,安上小车和吊篮,并把小车和吊篮固定在吊臂根部,把吊臂搁置在 1 米高左右的支架上,使小车和吊篮离开地面(见图 4-11),装上小车牵引机构。

Hook empty-load, outward travel at low speed and extreme position limiting at max radius is 5m jib(outward R=50m,inward R=7.5m), enable one switch of the radius limiter(outward and inward travel is controlled by its parting limiter switch), when the trolleying to and extreme position limiting at max radius, enable another limiter switch(ourward and inward limiter switch), then trolley stop travel, when travel it again, the trolley just travel in the center of the jib frame.

4.4.3 幅度限位器调整(结构调整方法见外购件说明书) adjusting method for radiuslimiter(the procedures is shown as the outsourcing instructions)(1)吊钩空载,以低速档运行,向外行至距最大幅度处5 米时(向外时 R=50 米,向内时 R=7.5 米),幅度限位器中的一个开关恰好动作(向外,向内分别由一个限位开关控制),当小车行至最大幅度时,另外一个限位开关动作,小车停止运行,再启动时,小车只能往臂架中央运行。

Automatic reeving changing device and doubled trolleying wire rope tension device etc.

自动变换倍率、变幅钢丝绳双重张紧等装置,都在为它的人性化和安全性加分。

In the power supply of the windlass mechanism, carriage trolleying mechanism and slewing mechanism,and install master ZK pneumatic switch,and current is 120A,if the current load more 120A,the power will be automatism cut off.

3.5.2.2 自动空气开关 automatism pneumatic switch 在卷扬机构,小车牵引机构和回转机构的供电线路中,装有总空气开关 ZK,脱扣电流为 120A,若线路负载超过 120A,可自动切断电源。

Adjust bolt 3, trolleying to the range of 52.3m-55.5m(48m-50.9m,44m- 46.6m), then touch the switch 4 ,the mschanisms power off and give over-load warning sound at the same time.

4.4.1.1.3 调整螺杆 3,把小车往外开,使幅度为 52.3-55.5 米(48 米-50.9 米, 44 米-46.6 米)范围内碰动开关 4,电路断电,小车不能向外变幅,吊钩不能上升。