tow post

与tow post相关的网络例句 [注：此内容来源于网络，仅供参考]

A device and method for preparing compound nano fiber endless tow, which contains feeding material liquid to pair of electric spinning nozzle on frame, each nozzle respectively applied with high dc voltage with opposite polarity, each pair of nozzle jetting out nano fiber with opposite electric charge, said nano fiber attracting and colliding each other to form compound nano fiber, then forming nano fiber endless tow after drawing and stretching, the first opposite set pair of electric spinning nozzle jetted compound nano fiber endless tow is stretched down and used as acceptor which covered by the nano fiber jetted by second pair of nozzle an d forming two layers of compound nano fiber endless tow after drawing and stretching, in turn to get multilayer compound nano fiber endless tow after drawing and stretching by godet roller.

复合纳米纤维长丝束制备装置及其制备方法是一种简单、高效电纺制备纳米纤维长丝束的方法，其步骤为将料液输送给支架(3)上的电纺喷头对(1)；喷口相向的电纺喷头对(1)的每个喷头分别施加相反极性的直流高电压；每对相向喷口喷出分别带相反电荷的纳米纤维，并在空中相互吸引、碰撞形成复合纳米纤维，经牵引、拉伸后形成复合纳米纤维长丝束；第一对相向放置的电纺喷头纺丝形成的复合纳米纤维长丝束向下拉伸，并作为接受体与第二对电纺喷头喷出的分别带相反电荷并相互吸引的纳米纤维在空中相遇，被第二对电纺喷头喷出的纳米纤维包裹，经牵引、拉伸后形成两层复合纳米纤维长丝束；依次类推，最后经导丝辊对(2)牵引、拉伸后得到多层复合纳米纤维长丝束。

The opened magnetic circuit is composed as tow NdFeB permanent magnets and a top plate without U-yoke. After take analyzed deeply for the opened magnet circuit with FEMM (Finite Element Method Magnetics) we find out the field distributing that is separated into three sections . One is the main area what we called as positive field section. Beside the main field there are tow areas that are called the inverted field sections. Loudspeaker arise a very serious distortion when the voice coil moving into inverted field areas. The direction of induced current in the coil part of entered inverted field area is same with the current driving into loudspeaker so that total currents increas largely and heat increase rapidly. With more coils moving into inverted area the voice coil will take on negative inductance properties. It is the main reason that voice coil is burned by heating with increasing current due to arise negative inductance. So opened magnetic circuit is not suitable for the woofers in which the voice coil have wider displacement range. When using this kind magnetic circuit design, the voice coil moving range should be less than the range of positive field to avoid loudspeaker arise serious distortion and heating. Even though voice coil moving range is in the positive area, loudspeaker will still arise more distortion because the field distribution is very cliffy at tow sides of the positive area and full range of magnetic field distribution is not parallel that will arise distortion. Base on above reasons, opened magnetic circuit is not an ideal magnetic circuit for low-frequency loudspeakers. But it can be used in mid-range or high-frequency productions.

开式磁路是由2片钕铁硼磁铁和主导磁板和导磁垫片组成，我们在实践过程中发现这种磁路结构不适合于低频扬声器的使用，我们通过使用FEMM（Finite Element Method Magnetics）软件包对该磁路进行了分析，该磁路的磁场范围被分成3个区域，其中在主导磁板附近形成一个正向磁场，在正向磁场的两边存在反向的磁场，音圈在工作时有很大一部分进入了反向磁场中，在反向磁场内线圈的感应电流方向与驱动电流方向相同，使得音圈呈现出负感抗特性，由于音圈的负感抗特性引起电流的增加导致音圈发热甚至烧毁，因此在扬声器中使用开式磁路时，音圈的运动范围应控制在正向磁场范围之内，否则音圈运动到反向磁场区域时将会产生很大的失真和发热，即使在设计时已经将音圈的运动范围控制在正向磁场范围之内，由于正向磁场的2个边缘磁场强度衰减太快，同时开式磁路中磁场的分布不是平行的，而是自由发散的分布，这样肯定会导致扬声器的非线性失真，因此我们得到的结论是：开式磁路并不是一个理想的磁路，它不适合于低频扬声器的使用，但它还可以应用于中高频扬声器。

Via the sample of erecting a steel girder bridge of 62.8 m span by float tow , the article summarizes the main technique point of the method of assembling tow boat, the process of float dragging beam, the setting up scaffold, disposal of tow and stepping equipment , calculation of float dragging stability, the fastening of hang up pole E3A3 etc, also make suggestion on the dragging equipment selection, the selection of float dragging support point and so on.

通过对跨度为62 8m钢桁梁浮拖架设的尝试，对浮拖架设中的浮拖船结构和组装、浮拖法施工步骤、膺架搭设、牵引和走行设备布置、浮拖稳定性检算、挂杆E3A3加固等主要技术环节进行了总结，并对牵引设备的选用、浮拖支承点位置选择等有关方面提出建议。

与tow post相关的网络解释 [注：此内容来源于网络，仅供参考]

tow point post：牵引点柱

tow point pin;牵引点销 | tow point post;牵引点柱 | tow point selector switch;牵引点选择器开关