position of strength

position of strength的基本解释

-

实力地位

与position of strength相关的网络例句 [注：此内容来源于网络，仅供参考]

The relationship between the ratio of Ca to Si with shrinkage value was needed to be studied further.The strength of M-AAS was comparatively high, but the flexural strength was regressed in the long term. The compressive and flexural strengthes of 3 days were able to surpass 8MPa and 78MPa, respectively, and compressive strength of 90 days were all around 100MPa, but compared to flexural strength of 28 days, the flexural strength of 90 days was regressed by 19.0%. The high strength property of M-AAS associated with its hydration products and Interfacial Transition Zoo. The main hydration products of M-AAS were microcline and CSH, no calcium hydroxide was found. The coexistence of microcline and CSH worked as micro-aggregate by each other, and no weak ITZ, both resulted in its high strength. The regression of its strength was related to its high shrinkage property, because the crazing caused by shrinkage would decrease the strength, especially the flexural strength.

M-AAS强度较高，但长期抗折强度倒缩。3天抗折和抗压强度分别可超过8MPa和78MPa，90天抗压强度在100MPa左右，但90天抗折强度比28天抗折强度相比低19.0％。M-AAS的高强特性与其水化产物和界面过渡区有关，M-AAS的水化产物主要为微斜长石和CSH凝胶，没有氢氧化钙，微斜长石与CSH凝胶相互填充和配合共同起到强度的作用，M-AAS砂浆中几乎没有发现界面过渡薄弱区。M-AAS的强度倒缩现象与其收缩值较大有关，收缩会引起M-AAS硬化体内部出现微裂缝，使强度下降。

Uses the biggest strength training method (80%～100% biggest strength) adding 30% biggest strength load training method; the load combination method to make the acclivity to lie pushes the barbell training, good in uses; the biggest strength training method to the upper limb shot fast strength training effect (80%～100% biggest strength) adding the unarmed quickest speed training method and the biggest strength training method (80%～100% biggest strength) adding 60% biggest strength shoulders the training method the load combination method.

用"最大力量训练(80％～100％最大力量)+30％最大力量负荷最快速度训练法"负荷组合方法做上斜卧推杠铃训练，对推铅球上肢快速力量的训练效果好于用"最大力量(训练80％～100％最大力量)+徒手最快速度训练法"与"最大力量训练(80％～1 00％最大力量)+60％最大力量负荷最快速度训练法"负荷组合方法。

In the presently mobile position technology, GPS's position method is one of the best. This method owns high accuracy less than 15 meters, and can be used with GPS chip in the mobile station. But GPS chip with the high price makes this technology difficult to popular. Therefore, the position technology of GSM communication network is attention to the people gradually. TOA or AOA is more often used among position technology, these methods need only the help of the position measuring instrument to attain time and angle for position calculation. They have good position accuracy, but they are also too expensive to popular. Every positioning technology has its bottleneck such as external environment influence, cost and positing efficiency. Therefore, the purpose of this research lies in finding out the mobile station location and does not emphasize the raise of the accuracy and it only uses existing information to finish position action.

在目前的行动定位技术中，以GPS定位技术为最佳，不仅拥有少於15公尺的高定位精确度，更只需在行动端加装GPS晶片即可使用，可惜高价格的GPS晶片使得此技术难以普及化，因此，以GSM通讯网路为主的定位技术逐渐受人们所重视，其中，又以TOA或AOA等定位技术较常被使用，仅透过位置测量仪器的帮助，便可取得定位所需的时间和角度，并且拥有不错的定位精确度，可惜也受到高价格因素的关系难以普及化，而每种定位技术都有其瓶颈存在，不论是外在环境的影响、成本和定位效能上；所以，本研究的目的在於找出行动端位置，即利用现有的资讯（细胞识别码、讯号强度等）来完成定位动作，而非强调其定位精确度的提高。

与position of strength相关的网络解释 [注：此内容来源于网络，仅供参考]

fatigue strength：疲劳强度

变应力时的疲劳强度(fatigue strength)计算三、单向不稳定变应力时的疲劳强度(fatigue strength)计算四、双向稳定变应力时的疲劳强度(fatigue strength)计算五、提高机械零件疲劳强度(fatigue strength)的措施尽可能降低零件上的应力集中(stress concentration)的影响,

position specializing in transmission：专用于传递的座席

position specializing in reception 专用于收受的座席 | position specializing in transmission 专用于传递的座席 | position strength formula 位置强度公式

position desired：希望职位 position wanted 希望职位

position sought 谋求职位 | position desired 希望职位 position wanted 希望职位 | for more specialized work 为更专门的工作