cyclinder

cyclinder的基本解释

n.

圆柱

与cyclinder相关的网络例句 [注：此内容来源于网络，仅供参考]

So preventing cold cyclinder from piercement should start from preventing cold cyclinder from cavitation erosion.

刺漏是由气蚀引起的，因此预防冷缸刺漏应从预防冷缸气蚀入手。

In this paper, a performance index, which is used to evaluate the operating uniformity of multi-cyclinder engine, is presented based on the fact that the fluctuation of gas pressure in the expansion stroke cyclinder leads to the fluctuation of instantaneous angular velocity. The value IP is propotional to the fluctuation of instantaneous angular acceleration. Fuzzy diagnostic index for misfire fault is introduced and investigated also in this paper.

根据多缸发动机曲轴瞬时转速波动不均匀性主要由缸内循环气体压力波动不均匀性引起这一基本事实，以曲轴瞬时转速的实时检测为基础，在一个工作循环内按着火顺序将作功冲程中瞬时角加速度的波动作为评定各缸工作不均匀性的指标，将所得IP模糊化用于多缸机的故障诊断也作了初步的探讨。

Plastic should lower 3 steps, because plastic is a step to add melt resin material to cyclinder , Higher stick of resin material ,higher screw back pressure. Screw speed differs depending on decomposing temperature of resin material ,Higher screw speed ,Higher trim force of resin, higher cyclinder temperature. Some resin material may decomposes so it set screw speed in mid-speed such as 45-75%, In plastic step setting screw back pressure is very important, Higher screw back pressure ,higher quality of product screw back pressure make resin structure order, Molding product is beautiful and volume stable.

再复杂的熔胶旋转过程最多不会超过三段，因为熔胶本身就是存在于把胶熔进料筒的过程，如果原料粘度大，熔胶压力则大，但速度则应取决于原料的分解温度，熔胶速度越快，原料中的剪切力则会越大，料管温度则越高，局部原料产生分解的可能性则会越大，故一般熔胶会采用中速为宜，如45%-75%，熔胶同时会碰到一个比较重要的环节，那就是背压的使用，产品精度要求越大，背压的使用则更大，背压可使原料分子间结构更紧密，成型出的产品则尺寸更稳定，外观越好。

与cyclinder相关的网络解释 [注：此内容来源于网络，仅供参考]

cyclinder：柱面

cycle 循环 | cyclinder 柱面 | cyrill 西里尔

cyclinder：圆柱体

"clincher","夹子,紧钳" | "cyclinder","圆柱体" | "pressure gauge","压力计"

cyclinder：柱

cycle 循环 | cyclinder 柱 | cyrill 西里尔

damper cyclinder：减震缸

cylinder head 气缸盖 | damper cyclinder 减震缸 | drive shaft转动轴

cycloidal cyclinder：摆彘筒柱

cycloid 摆线 | cycloidal cyclinder 摆彘筒柱 | cycloidal cylinder 摆线筒柱