brightness control

brightness control的基本解释

-

亮度调节, 亮度控制

与brightness control相关的网络例句 [注：此内容来源于网络，仅供参考]

Multiple linear regression equation between LST and brightness temperatures of AVHRR channels 4 and 5 was almost at the significant level (p＜0.05), and the level was not improved by adding brightness temperature of AVHRR channel 3 as a regressor. Path analysis is a statistical technique that partitions correlations into direct and indirect effects, and differentiates between correlation and causation. The results of path analysis showed that the direct effects and indirect effects of brightness temperatures of AVHRR channels 4 and 5 to LST were strong, respectively, the direct effect and indirect effects of brightness temperature of AVHRR channels 3 to LST were weak. These implied the brightness temperatures AVHRR channels 4 and 5 should be involved in retrieving LST.

多元线性回归分析结果表明，土地表面温度与AVHRR第4、5波段亮度温度间的回归方程接近5％的显著水平；通径分析的结果表明，AVHRR第4、5波段的亮度温度对土地表面温度的直接作用和间接作用均较强，而AVHRR第3波段的亮度温度对土地表面温度的直接作用和间接作用均较弱，因此，在反演土地表面温度时必须同时考虑AVHRR第4、5波段的亮度温度。

PART 1 UNIT 1 B Electrical and Electronic Engineering Basics A Electrical Networks ———————————— 3 Three-phase Circuits A The Operational Amplifier ——————————— 5 UNIT 2 B Transistors A Logical Variables and Flip-flop —————————— 8 UNIT 3 B Binary Number System A Power Semiconductor Devices —————————— 11 UNIT 4 B Power Electronic Converters A Types of DC Motors —————————————15 UNIT 5 B Closed-loop Control of DC Drivers A AC Machines ———————————————19 UNIT 6 B Induction Motor Drive A Electric Power System ————————————22 UNIT 7 B PART 2 UNIT 1 B Power System Automation Control Theory A The World of Control ————————————27 —————29 The Transfer Function and the Laplace Transformation UNIT 2 B A Stability and the Time Response ————————— 30 Steady State————————————————— 31 A The Root Locus ————————————— 32 ————— 33 UNIT 3 B The Frequency Response Methods: Nyquist Diagrams UNIT 4 A The Frequency Response Methods: Bode Piots ————— 34 B Nonlinear Control System 37 UNIT 5 A Introduction to Modern Control Theory B State Equations 40 38 UNIT 6 A Controllability, Observability, and Stability B Optimum Control Systems UNIT 7 A Conventional and Intelligent Control B Artificial Neural Network Computer Control Technology A Computer Structure and Function 42 B Fundamentals of Computer and Networks 43 44 PART 3 UNIT 1 UNIT 2 A Interfaces to External Signals and Devices B The Applications of Computers 46 UNIT 3 A PLC Overview B PACs for Industrial Control, the Future of Control UNIT 4 A Fundamentals of Single-chip Microcomputer 49 B Understanding DSP and Its Uses 1 UNIT 5 A A First Look at Embedded Systems B Embedded Systems Design Process Control A A Process Control System B 50 PART 4 UNIT 1 Fundamentals of Process Control 52 53 UNIT 2 A Sensors and Transmitters B Final Control Elements and Controllers UNIT 3 A P Controllers and PI Controllers B PID Controllers and Other Controllers UNIT 4 A Indicating Instruments B Control Panels Control Based on Network and Information A Automation Networking Application Areas B Evolution of Control System Architecture PART 5 UNIT 1 UNIT 2 A Fundamental Issues in Networked Control Systems B Stability of NCSs with Network-induced Delay UNIT 3 A Fundamentals of the Database System B Virtual Manufacturing—A Growing Trend in Automation UNIT 4 A Concepts of Computer Integrated Manufacturing B Enterprise Resources Planning and Beyond Synthetic Applications of Automatic Technology A Recent Advances and Future Trends in Electrical Machine Drivers B System Evolution in Intelligent Buildings PART 6 UNIT 1 UNIT 2 A Industrial Robot B A General Introduction to Pattern Recognition UNIT 3 A Renewable Energy B Electric Vehicles UNIT 1 A

电路 2 电路或电网络由以某种方式连接的电阻器，电感器和电容器等元件组成。如果网络不包含能源，如电池或发电机，那么就被称作无源网络。换句话说，如果存在一个或多个能源，那么组合的结果为有源网络。在研究电网络的特性时，我们感兴趣的是确定电路中的电压和电流。因为网络由无源电路元件组成，所以必须首先定义这些元件的电特性。就电阻来说，电压-电流的关系由欧姆定律给出，欧姆定律指出：电阻两端的电压等于电阻上流过的电流乘以电阻值。在数学上表达为： u=iR (1-1A-1)式中 u=电压，伏特；i =电流，安培；R =电阻，欧姆。纯电感电压由法拉第定律定义，法拉第定律指出：电感两端的电压正比于流过电感的电流随时间的变化率。因此可得到：U=Ldi/dt 式中 di/dt =电流变化率，安培/秒； L =感应系数，享利。电容两端建立的电压正比于电容两极板上积累的电荷 q 。因为电荷的积累可表示为电荷增量 dq 的和或积分，因此得到的等式为 u=，式中电容量 C 是与电压和电荷相关的比例常数。由定义可知，电流等于电荷随时间的变化率，可表示为 i = dq/dt。因此电荷增量 dq 等于电流乘以相应的时间增量，或 dq = i dt，那么等式(1-1A-3)可写为式中 C =电容量，法拉。

PART 1 Electrical and Electronic Engineering Basics UNIT 1 A Electrical Networks B Three-phase Circuits UNIT 2 A The Operational Amplifier ——————————— 5 B Transistors UNIT 3 A Logical Variables and Flip-flop —————————— 8 ———————————— 3 B Binary Number System UNIT 4 A Power Semiconductor Devices —————————— 11 B Power Electronic Converters UNIT 5 A Types of DC Motors —————————————15 B Closed-loop Control of DC Drivers UNIT 6 A AC Machines ———————————————19 B Induction Motor Drive UNIT 7 A Electric Power System ————————————22 B Power System Automation PART 2 Control Theory UNIT 1 A The World of Control ————————————27 B The Transfer Function and the Laplace Transformation UNIT 2 A B —————29 Stability and the Time Response ————————— 30 ————————————— 32 Steady State————————————————— 31 UNIT 3 A The Root Locus B The Frequency Response Methods: Nyquist Diagrams ————— 33 UNIT 4 A The Frequency Response Methods: Bode Piots ————— 34 B Nonlinear Control System 37 UNIT 5 A Introduction to Modern Control Theory B UNIT 6 State Equations 40 38 A Controllability, Observability, and Stability B Optimum Control Systems UNIT 7 A Conventional and Intelligent Control B Artificial Neural Network PART 3 UNIT 1 Computer Control Technology A Computer Structure and Function B 42 43 44 Fundamentals of Computer and Networks UNIT 2 A Interfaces to External Signals and Devices B The Applications of Computers 46 UNIT 3 A PLC Overview B PACs for Industrial Control, the Future of Control 1 UNIT 4 A Fundamentals of Single-chip Microcomputer B Understanding DSP and Its Uses 49 UNIT 5 A A First Look at Embedded Systems B Embedded Systems Design PART 4 UNIT 1 Process Control A A Process Control System 50 B Fundamentals of Process Control 53 52 UNIT 2 A Sensors and Transmitters B Final Control Elements and Controllers UNIT 3 A P Controllers and PI Controllers B PID Controllers and Other Controllers UNIT 4 A Indicating Instruments B Control Panels PART 5 UNIT 1 Control Based on Network and Information A Automation Networking Application Areas B Evolution of Control System Architecture UNIT 2 A Fundamental Issues in Networked Control Systems B Stability of NCSs with Network-induced Delay UNIT 3 A Fundamentals of the Database System B Virtual Manufacturing—A Growing Trend in Automation UNIT 4 A Concepts of Computer Integrated Manufacturing B Enterprise Resources Planning and Beyond PART 6 UNIT 1 Synthetic Applications of Automatic Technology A Recent Advances and Future Trends in Electrical Machine Drivers B System Evolution in Intelligent Buildings UNIT 2 A Industrial Robot B A General Introduction to Pattern Recognition UNIT 3 A Renewable Energy B Electric Vehicles 2 UNIT 1 A

电路 电路或电网络由以某种方式连接的电阻器，电感器和电容器等元件组成。如果网络不包含能源，如电池或发电机，那么就被称作无源网络。换句话说，如果存在一个或多个能源，那么组合的结果为有源网络。在研究电网络的特性时，我们感兴趣的是确定电路中的电压和电流。因为网络由无源电路元件组成，所以必须首先定义这些元件的电特性。就电阻来说，电压-电流的关系由欧姆定律给出，欧姆定律指出：电阻两端的电压等于电阻上流过的电流乘以电阻值。在数学上表达为： u=iR (1-1A-1)式中 u=电压，伏特；i =电流，安培；R =电阻，欧姆。纯电感电压由法拉第定律定义，法拉第定律指出：电感两端的电压正比于流过电感的电流随时间的变化率。因此可得到：U=Ldi/dt 式中 di/dt =电流变化率，安培/秒； L =感应系数，享利。电容两端建立的电压正比于电容两极板上积累的电荷 q 。因为电荷的积累可表示为电荷增量 dq 的和或积分，因此得到的等式为 u=，式中电容量 C 是与电压和电荷相关的比例常数。由定义可知，电流等于电荷随时间的变化率，可表示为 i = dq/dt。因此电荷增量 dq 等于电流乘以相应的时间增量，或 dq = i dt，那么等式(1-1A-3)可写为式中 C =电容量，法拉。

与brightness control相关的网络解释 [注：此内容来源于网络，仅供参考]

brightness enhancing：亮度增强

brightness control 亮度控制 | brightness enhancing 亮度增强 | brightness gain 亮度增益

brightness contrast：明度对比

brightness constancy 明度常性 | brightness contrast 明度对比 | brightness discrimination 明度辨别

brightness,rationalized：合理化亮度

正常亮度,正射亮度 brightness,normal | 合理化亮度 brightness,rationalized | 亮度转移特性 brightness-transfer characteristic