查询词典 temperature difference

The temperature rise shall not exceed Class B minus 10C (stator temperature 70K rise by resistance) when tested at nominal voltage, frequency and rating in accordance with SABS IEC 60034-2 and SABS IEC 60034-2A at an ambient temperature of 40C and corrected for 1650 masl.

温升不得超过B级零下10 C （定子温度上升，由70k电阻）测试时，以象征式的电压，频率和评级在按照sabs的IEC 60034-2和sabs的IEC 60034 - 2A火箭在环境温度40C条和更正为1650 masl 。

It is found that modified asphalt added 4 percent SBS is able to improve high-temperature stability, low-temperature anti-cracking performance and high-temperature susceptility of petroleum asphalt,which is enough to satisfy the performance stand.

结果表明，石油沥青中添加 4 %SBS可以明显改善石油沥青的高温稳定性、低温抗裂性和感温性，使其基本满足铺路沥青的要

In this dissertation, at first, the history and present situation of the research related to overheating is reviewed, and then the research works are carried out in following aspects the calculation of radiative properties of coal combustion, the solution of radiative transfer equation in absorbing-scattering media, the analyses of combined heat transfer processes in flue side, the computation method of steam temperature deviation of superheaters and reheaters and the inversion method of their wall metallic temperature in furnace, the numerical simulation of gas-solid two-phase flow, combustion and heat transfer in furnace, the measurement of outlet steam temperature of superheaters and reheaters, engineering reformation of overheating and optimum design of superheaters and reheaters, etc.

本文在综述了与过热器和再热器超温问题有关的研究历史与现状的基础上，在煤粉燃烧产物辐射特性的计算、含散射问题的辐射传递方程的求解、过热器和再热器烟气侧对流与辐射复合换热及汽温偏差的计算和炉内金属壁温的反演、炉内气固两相流动、燃烧、传热过程的数值模拟、过热器再热器炉外出口汽温的测量、过热器再热器超温问题的工程改造及设备的优化设计等方面进行了研究。

The variation of Pteropods abundance shows a clear linear correlation with surface water temperature and 10 m water temperature but no significant correlation with bottom water temperature or salinity.

根据1997～2000年东海海域23°30′～33°00′N，118°30′～128°00′E的4个季节海洋调查资料，运用定量、定性方法，探讨了东海浮游翼足类总丰度的平面分布、季节变化及变化的动力学机制。

Since temperature stress in plate wall box girder is largely produced for changes of temperature at the period of construction, therefore, it is needed to research temperature stresses in plate wall box girder.

由于在施工过程中厚壁混凝土箱梁产生的温度应力比较大，因此有必要对厚壁混凝土箱梁的温度应力进行分析研究。

In respect that various requirements of load and temperature on different parts of the baker, firebrick lining was chose reasonably, and the dosage of light heat preservation brick is in enlargement. As a result of that, the weight of the furnace was decreased, and increased its performance of heat preservation and cumulation was increased consumedly. With the use of ""W"" type fire tunnel and straight-through dilatation joint, and two enlargement of the perpends on the wall appropriately, all the problems of heat preservation in the anode baker, uniform temperature in the tunnel, and its life span were solved effectively. In the research of anode blocks in and out of the furnace, and of tidying it up, the multi-function crane clamps was alented and the assembling unit was reconstructed, which made it easy to automatic ally assemble the carbon blocks of various specifications with only one set of assembling unit.In the aspects of automation, a new type pulse combustor and solid thermocouple, as a result of that, not only the control accuracy of the fire tunnel's temperature was increased, but also the system function was improned to be more dependable, safe and practicable.

在焙烧炉炉体研究方面，针对焙烧炉不同部位的负荷及温度要求的不同，合理选用耐火材料，加大轻质保温砖的用量，既减轻炉体的重量，又大大提高炉体的保温蓄热性能；火道墙采用&W&型火道结构，直通性膨胀缝，并适当加大火道墙竖缝，有效地解决了阳极焙烧炉的保温、火道温度均一及火道墙的使用寿命等问题；在阳极炭块装出炉及清理等研究方面，通过对编解机组及多功能天车夹具进行改造，实现一套机组对多规格炭块的自动编组、解组及装出炉问题；焙烧炉自动化控制研发中，采用先进的分散式控制系统，研制开发新型脉冲燃烧器及实体型热电偶，不仅提高了火道温度的控制精度，而且提高了系统的可靠性、安全性、实用性。

C or less of saturated compressed air into the dryer of the pre-cooling device, in the pre-cooling device in heat exchange with the ambient air, high temperature air pre-cooling fan part of the heat is taken away, after pre-cooling the compressed air into the to the pre-evaporator refrigeration system with secondary refrigerant vapor heat exchange, allowing the temperature dropped close to the refrigerant evaporation temperature, and flows through the pre-filter to remove large amount of liquid water, oil mist and dust.

小于等于80°C的饱和压缩空气进入干燥机的预冷器，在预冷器中与环境空气进行热交换，高温压缩空气的一部分热量被预冷风机带走，预冷后的压缩空气进入到制冷系统的前置蒸发器，与冷媒蒸气进行二次热交换，使本身温度降到接近于冷媒的蒸发温度，并流经前置过滤器除去大量的液态水，油雾和尘埃。

Agent my company's main products are: the United States Magnetrol the liquid level switch, level gauge, pressure switch Barksdale United States, Germany JUMO temperature switch and temperature instrumentation, Singapore TIS automatic calibrator temperature stress, the United States CRYSTAL precision pressure gauge and portable pressure calibrator, USA PIE site instrument calibration.

我公司代理的主要产品有：美国Magnetrol的液位开关、液位计，美国Barksdale的压力开关，德国JUMO的温度开关和温度仪表，新加坡TIS的全自动压力温度校验仪，美国CRYSTAL精密压力表和便携式压力校验仪，美国PIE的现场校验仪表等。

And then the Ar flow rate is lowered to 90-110sccm, the temperature is increased quickly to 780-830deg.C, keeping the temperature for 40-60min, naturally cooling to room temperature under the Ar protective atmosphere, taking out of said ceramic ship, obtained is the four needle nanometer zinc sulfide in yellow and white colour on the substrate.

而后将Ar流量降至90～110sccm，并将炉子快速升温至780～830℃，保温40～60分钟后，在Ar保护下随炉自然冷却至室温，取出瓷舟，在硅基片上得到黄白色四针状纳米硫化锌。

It is found by solving the self-consistency equa tion that, at zero chemical potential and finite temperature the chiral phase transition is of second order, while both at finite temperature and density and at zero temperature finite density this transition is of first order.

通过求解序参量所满足的自洽方程，其结果表明：在零化学势有限温度情况下，有二级手征相变发生；对于有限温度和密度以及零温有限密度两种情况，手征相变为一级，并且其转变温度或密度与费米子所处的初始相有关，即从破缺相到正常相的转变温度或密度不同于从正常相到破缺相的转变温度或密度。

"Second Life is remarkably easy to work with, and is very popular,"

"第二次生命是显着容易的工作，并且很受欢迎，"

For example, we usually assume that materials are homogeneous and isotropic and free of internal defects or flaws.

为了得到适合有限元分析的模型，我们必须经过如图2所示的简化步骤。