查询词典 temperature difference

Create Jinfeng 62 (1.2MW) temperature model of mathematics and physics about permanent magnent synchronous generator in wind power, present basic hypothesis and boundary condition. select area that one slot opposite to calculate, utilize FEM calculate roter and stator temperature field. bring forward actual method, carefully analyse the result to generator temperature field, for example reduce coil insulation thickness, decrease conduction coefficient because insulation aging between circle, increase iron-core anisotropism conduction coefficient.

建立了金风62型(1.2MW)永磁同步风力发电机的二维温度场的数学和物理模型，给出了计算边界条件和分析假设条件，以一个槽所对应的电机计算区域，利用有限元方法计算发电机的定、转子温度场，详细分析了绕组线棒绝缘厚度减小、匝间绝缘老化致使导热系数减小、铁心各向异性导热系数提高等参数改进对于发电机温度场的影响。

The method adopts the following steps: after mixed, phosphorus source, silicon source, aluminum source, an organic template agent, water and a precursor of the SAPO molecular sieve are hydrothermally crystallized for at least 0.1 hour at the temperature ranging from 110 to 260 DEG C to obtain the SAPO molecular sieve; wherein, the preparation method for the precursor of the SAPO molecular sieve has the following steps:, the molar ratio is 0.03 to 0.6 R:(Si0.01 to 0.98: Al 0.01 to 0.6: P0.01 to 0.6): 2 to 500 H2O; wherein, R stands for mixture solution of raw materials which is blended by the phosphorus source, the silicon source, the aluminum source, the an organic template agent and water of the template agent;, the mixture solution of raw materials prepared in step reacts at the temperature which is at least 50 DEG C lower than the crystallization temperature for at least 0.1 hour.

本发明通过采用包括以下步骤：将磷源、硅源、铝源、有机模板剂、水和SAPO分子筛前驱体混合后在110～260℃的温度下水热晶化至少0.1小时获得SAPO分子筛；其中SAPO分子筛的前驱体的制备包括以下步骤：将摩尔配比为0.03～0.6R∶(Si0.01～0.98∶Al0.01～0.6∶P0.01～0.6)∶2～500H 2 O，式中R代表模板剂的磷源、硅源、铝源、有机模板剂和水混合成原料混合液；将步骤制备的原料混合液在低于晶化温度至少50℃的温度下反应至少0.1小时的技术方案较好地解决了该问题，可应用于含氧化合物制烯烃催化剂的制备过程。

The results show that in the case of {1 0 0}, the morphology of crystal changes from lowtemperature sheet to hightemperature tower with increasing the synthesized temperature, whereas in the case of {1 1 1} the change trend is contrary to {1 0 0}. When {1 1 1} facet or {1 1 1} was used as the growth facet, the sheetlike crystal is more difficult to incorporated for the metal inclusion regardless of synthesized temperature. With NiMnCo metal as solvent, large highquality gemgrade diamonds can also grow on {1 1 1} facet with proper temperature gradient.

结果表明：随着合成温度的升高，用{1 0 0}面生长出的晶体形貌由低温片状逐渐过渡到高温塔状，而用{1 1 1}面生长出的晶体形貌变化趋势则相反；采用籽晶{1 0 0}面或{1 1 1}面生长晶体，无论合成温度高低，包裹体都不容易进入片状晶体内部；只要存在合适的温度梯度，NiMnCo触媒同样适合利用籽晶{1 1 1}面生长优质大尺寸宝石级金刚石（≥4 mm）。

The temperature affects the development time of female gametophyte. The time from sporogenous cell observed to formating of female gametophyte needs 14 days at high temperature, but it needs about 20 days at low temperature.

温度影响雌配子体的发育时间，从观察到造胞细胞到雌配子体形成在高温条件下需14d左右，在低温条件下需20d左右。

Pollen germination rate on stigmas, pollen germination rate on culture medium and stainable pollen grain rate by I-KI of the four cultivars on average under high temperature were 16.00, 25.85, and 11.74 percentage points lower than those under nonnal temperature at that time, and 8.49, 6.63, and 6.02 percentage points lower than those under normal temperature at 4 days after treatment.

相同的趋势也表现在同期开花颖花的结实特征上，高温处理的当天和其后4d开花颖花的结实率分别平均下降了14.04和5.95个百分点；而高温处理当天的空粒率和秕粒率平均分别提高了10.06和3.98个百分点，处理后4d分别提高了3.98和1.97个百分点。

Imported by the owner, weft machine 140 sets; high temperature and high pressure, temperature and pressure dyeing equipment; cylinder and automatic control temperature stenter setting machine.

拥有进口经、纬编机140余台套；高温高压、常温常压染色设备；圆筒及自动化控制油温拉幅定型机。

Microcomputer automatic temperature control procedures counters 8 storge of the high-precision temperature control,temperature control accuracy

真空罐采用进口耐1200℃特高温合金不锈钢板，经自动自动成卷机制成圆柱形罐体。

Three results are obtained by an orthogonal experiment. The main components of essential oil in separating containerⅠare terpenoid, terpeneless compound is in separating container Ⅱ. Through second-level separation the technological conditions of de-terpene are: pressure 7MPa, temperature 32℃ in separating containerⅠ;pressure 4～5MPa, temperature 32℃ in separating containerⅡ. The optimum technological parameters of obtaining two essential oils are: particle size 0.60mm, pressure 10MPa, temperature 36℃, operating time 90 minutes. There are 1.46% and 1.88% essential oil in separating containerⅠand Ⅱ respectively.

通过正交试验表明：分离器Ⅰ中精油的主要成分是萜烯烃类化合物，分离器Ⅱ中精油的主要成分是由高级醇类、醛类、酮类、酯类等组成的含氧化合物；二级分离脱萜的适宜参数是：分离器Ⅰ的压力为7MPa，分离器Ⅱ的压力与循环压力相同，温度都为32℃；同时得到萜烯烃类精油和低萜精油的最优工艺组合是粒度0.60mm，萃取压力10MPa，萃取温度36℃，萃取时间90min，精油得率分别为1.46％和1.88％。

A constant ultra-low density slurry system is developed to fit for three different thermometric well conditions,which means the low temperature well (BHCT:49℃),medium temperature well (BHCT:89℃)and high temperature well (BHCT:170℃).

研究出分别适用于低温（此处指井底静止温度为49℃的井况）、中温（此处指井底静止温度为89℃的井况）以及高温（此处指井底静止温度为170℃的井况）条件下的恒密度超低密度水泥浆体系。

Based on the fundamental principle of data fusion and some shortages of existing temperature measuring method, the paper makes digital camera measure temperature and proposes a new temperature measuring method depending on tinctorial variety.

基于数据融合的基本思想，结合现有温度测量方法的一些不足，将数码相机用作温度测量，提出了一种图像颜色测温法。

Objective:To compare the response control and attention of Schizophrenic patients with that of the healthy controls by Integrated Visual and Auditorycontinuous performance test. To quantitate the impairment of cognitive function in patients, and to explore the relationship between cognitive function and the severity of the disorder.

目的：探讨精神分裂症病人在IVA持续操作测试中的反应控制能力、注意力等，并与健康人进行比较，从而量化精神分裂症病人的认知功能损害，并进一步探讨其认知功能与疾病严重程度的关系。

Main effective factors including subcooling degree, mechanical vibration, gas hydrate reformation, environment temperature, noncondensing gas and surfactant are analyzed.

指出过冷度、机械振动、重复生成水合物、环境温度、不凝性气体、添加剂是影响气体水合物生成的主要因素，还对R152a水合物的放冷进行了实验研究。