查询词典 reverse bend

The results show that: There exists the Kuroshio deformation in the form of the Kuroshio bend at Luzon Strait. The degree of this bend varies with time and is accompanied by the anticyclonic eddy shedding from the Kuroshio bend.

研究表明：吕宋海峡处黑潮形变以黑潮弯曲的形式存在，黑潮弯曲程度随时间变化，并伴随反气旋涡从黑潮弯曲中脱落。

Based on the former studies, this paper promotes an innovation about this topic using new satellite altimetry data and hydrographic data along with numerical experiments: Firstly, the temporal variation of the deformation of Kuroshio accompanied by the periodically shed anticyclonic eddies from the Kuroshio bend is discovered; Secondly, the major mechanism of the anticyclonic eddy separating from the Kuroshio bend, which is the frontal instability, is brought forward and then proved; Thirdly, the factors with important impact on the periodical variation of the Kuroshio bend and the eddy shedding, which are the strength of the Kuroshio transport and the circulation in the winter SCS, are determined.

本文在前人工作的基础上，利用了最新的卫星遥感资料和海洋调查资料，通过数值模式的数值实验，得到了以下前人没有得到的创新成果：发现在吕宋海峡处黑潮的形变随时间变化，并伴有反气旋涡周期性地从黑潮主体中脱落；提出并证明了吕宋海峡黑潮锋附近的锋面不稳定是反气旋涡从黑潮弯曲中脱落的主要机制；确定了对黑潮弯曲周期性变化以及反气旋涡脱落有重要影响的物理因素是黑潮流量的大小及冬季南海局地环流。

The mechanism of instability wrinkling in the process based on minimum energy principle is revealed, uniform mathematic description of the wrinkling wave on the strip of in-plane bending is established, the internal and external energy is deduced by energy method, and a uniform criteria of internal and external wrinkling is established; then how to combine the criteria with the FEM simulation system to make the numerical prediction of wrinkling into reality is also resolved in the paper. The effects of the forming parameters on the deforming result are analyzed by the uniform predict criteria. The results show as follows: as the compress width increase, external wrinkling first come into being, then internal winkling do, and finally in-plane bend occur; the loading wedge angle increase, internal winkling first come into being, thenin-plane bend do, and finally external wrinkling occur; in-plane bend is possible to occur with a increase of the strain-hardening exponent and the strength coefficient; and the effect of the friction factor may be ignored.

2揭示了板带不均匀压下面内弯曲成形过程基于能量原理的失稳起皱机理，提出了统一的描述内外缘起皱波形的函数，采用变分法推导了服从该波形函数的内外缘起皱能，建立了统一的起皱预测准则；将新建立的统一的起皱预测准则引入到数值模拟系统IBS中，数值预测结果与实验结果的吻合较好；分析了成形过程各参数对起皱的影响规律：随着接触变形区宽度的逐渐增大，先是发生外缘起皱，然后发生内缘起皱，进而才出现稳定成形；随着实际加载楔角的增大，先是发生内缘起皱，然后发生稳定成形，进而出现外缘起皱；硬化指数和强化系数增大，易于稳定成形；摩擦因子对起皱的影响不明显；而且接触变形区宽度对起皱的影响最大。

In accordance with the requirement of technical parameter of super high pressure bend and cold bend specification, the stress at cold bending on the three-roll bend machine was analyzed.

根据超高压弯管技术参数和冷弯工艺的要求，结合超高压管在立式三辊滚弯机上冷弯时的受力状态，运用弹塑性理论分析计算出弯管所用弯矩及弯管的最大压紧力，并据此选用弯管设备，解决了超高压弯管的制造问题。

The main products for the vehicle side bars, exhaust manifold, into the trachea, bumpers, and other cold-bend processing, the company has world-class computer numerical control machine automatically bend, bend forming the entire pipeline, and the corresponding Supporting the processing equipment; difficult for the stainless steel tube bending have a certain capacity and product quality, management and treatment of high demand.

主要产品有汽车侧面护杠，排气歧管，进气管，保险杠，中冷器及其他弯管加工等，公司拥有国际一流的电脑数控自动弯管机，整套弯管成形流水线，及相应配套的加工设备；对高难度的不锈钢薄壁管弯曲具有一定的能力，并对产品的质量，管理及处理有很高的要求。

The Reverse Construction Method has not been well developed in our country. The paper discussed the designing method of the Reverse Construction Method and made a comparison with the regular construction method and studied some key technique of the Reverse construction procedure combining construction practice, such as diaphragm and mid-maintain columniation designing and constructing, dewatering, earthwork excavating, diaphragm wall structure constructing, surrounding buildings protection, construction inspecting and so on.

本论文探讨了逆作法的设计方法，同时与顺作法进行了对比，并结合工程实践研究了逆作法施工中的多项关键性技术，如地下连续墙与中间支撑柱设计与施工、基坑内降水、土方开挖、地下结构逆作施工、周围建筑物保护、施工监测等。

The method includes establishing one reverse mapping list comprising list items; reading the mapping data recorded in the data block state list item area to the list items during system initialization; checking reverse mapping list and finding the data block in Flash memory during reading some logic block; and writing the updated data into the empty data area of one new data block, writing the mapping data between the new logic block and the new data block into the state list item area and updating the mapping data of the corresponding list item in the reverse mapping list during writing some logic blcok.

包括：建立一个由表项组成的反向映射表，一个表项对应一个逻辑块；在系统初始化过程中，将数据块状态表项区中记录的映射信息，按逻辑块号与表项间的对应关系读取到各表项中；读取某逻辑块时，以其逻辑块号作为表项索引查找反向映射表，定位到表项，根据表项中记录的映射信息，在Flash存储器件中查找到数据块；写入某逻辑块时，将更新数据写入一新数据块的空白数据区中和将该逻辑块与新数据块间的映射信息写入状态表项区中，同时更新反向映射表相应表项的映射信息。

This paper describes an approach to reverse engineering based on the formal semantics of the strongest postcondition predicate transformer,and the partial correctness model of program semantics introduced by Hoare. The main point of our investigation is how to use informal and formal methods for reverse engineering. The approach provided by this thesis is mainly to process the C program system for reverse engineering.

本文描述的逆向工程中的形式化方法采用最强后置条件谓词转换技术和Hoare理论中有关程序语义的部分正确性模型，研究的重点是利用形式化技术和非形式化技术对程序代码进行逆向工程，以支持软件理解和维护。

During the period from the reverse trendelenburg position to the starting point for the closure of the valve, the reverse flow of blood occurred in the experimental group with the velocity of (1.4 ± 0.3) cm/s; while in the control group, there was no reverse flow of blood, but the peak flow rate was decreased from (21.3 ± 2.1) cm/s to (18.2 ± 3.3) cm/s.

动物于头高脚低位至瓣膜开始关闭时，实验组均出现血液返流现象，返流流速（1.4 ± 0.3）cm/s；对照组未出现血液返流现象，但血液流速下降，由高峰流速（21.3 ± 2.1）cm/s 减至（18.2 ± 3.3）cm/s。

Use reverse Our sidecar have two style reverse gear box:the 52 style and 331 style,now I show you hao to use the 52 style reverse gear box.

使用侧扭转我们有两个风格扭转齿轮箱： 52式和331式的，现在我告诉你浩使用的52式反向齿轮箱。

Objective:To compare the response control and attention of Schizophrenic patients with that of the healthy controls by Integrated Visual and Auditorycontinuous performance test. To quantitate the impairment of cognitive function in patients, and to explore the relationship between cognitive function and the severity of the disorder.

目的：探讨精神分裂症病人在IVA持续操作测试中的反应控制能力、注意力等，并与健康人进行比较，从而量化精神分裂症病人的认知功能损害，并进一步探讨其认知功能与疾病严重程度的关系。

Main effective factors including subcooling degree, mechanical vibration, gas hydrate reformation, environment temperature, noncondensing gas and surfactant are analyzed.

指出过冷度、机械振动、重复生成水合物、环境温度、不凝性气体、添加剂是影响气体水合物生成的主要因素，还对R152a水合物的放冷进行了实验研究。