查询词典 moment of force

The results were as follows.(1) In the backward handspring, the trajectory of CM and horizontal velocity of CM in junior-high and college gymnasts were lower and higher than those of senior-high gymnast, so the vertical velocity is better when they perform tucked backward somersault. College gymnast has higher vertical velocity than junior-high and senior-high gymnasts in take-off moment of backward handspring phase.(2) Senior-high and college gymnasts have more elbow and shoulder angle in take-off moment of backward handspring and tucked backward somersault phase. Therefore, angle of both arm is bigger for performing in hand push away phase in the backward handspring, and increased the reaction force with body in the tucked backward handspring.(3) College gymnast has large knee flexions in hand support and push away moment in the backward handspring, it would increase rotation radius and better moments of inertia in the backward handspring.

结果显示：在后手翻阶段中，较低的重心轨迹和较高的水平速，有於后续空翻的垂直速；大专选手在后手翻阶段起跳瞬间有较高的垂直速；高中及大专选手在后手翻起跳脚地瞬间和团身后空翻起跳脚地瞬间时，肘、肩关节角皆大於国中选手，使其在后手翻起跳地瞬间时，双臂的伸展於后手翻的手推地面的动作，而团身后空翻起跳脚地时，双臂向上摆於身体向上伸展方向的掌握，并使重心有一定的腾空高；大专选手在后手翻阶段的手著地瞬间和手地瞬间的膝关节角较大於高中和国中选手，使其可增加身体的旋转半径，并能获得较佳的下摆动能，而膝关节角小则形成屈膝的动作，导致重心水平速低，减少下摆动能和影响整体动作的节奏和韵。

Close the valve, the need to open and close with the Coma Berenices two pieces of the sealing surface of the seal formed between certain specific pressure, while also overcoming the stem and the packing between the stem and the nut thread between the stem end bearing at and other friction parts of the friction, and therefore must apply the closing force and closing a certain moment, the valve in the open and close the process, the required hoisting hoisting force and moment of change, and its maximum is close to the final instant or open the initial transient.

关闭阀门时，需要使启闭件与发座两密封面间形成一定的密封比压，同时还要克服阀杆与填料之间、阀杆与螺母的螺纹之间、阀杆端部支承处及其他磨擦部位的摩擦力，因而必须施加一定的关闭力和关闭力矩，阀门在启闭过程中，所需要的启闭力和启闭力矩是变化的，其最大值是在关闭的最终瞬时或开启的最初瞬时。

Close the valve, the need to open and close with the Coma Berenices two pieces of the sealing surface of the seal formed between certain specific pressure, while also overcoming the stem and the packing between the stem and the nut thread Automatic Control Valves between the stem end bearing at and other friction parts of the friction, and therefore must apply the closing force and closing a certain moment, the valve in the open and close the process, the required hoisting hoisting force and moment of change, and its maximum is close to the final instant or open the initial transient.

关闭阀门时，需要使启闭件与发座两密封面间形成一定的密封比压，同时还要克服阀杆与填料之间、阀杆与螺母的螺纹之间、阀杆端部支承处及其他磨擦部位的摩擦力，因而必须施加一定的关闭力和关闭力矩，阀门在启闭过程中，所需要的启闭力和启闭力矩是变化的，其最大值是在关闭的最终瞬时或开启的最初瞬时。

This artical has studied the application of definit integral in physics from aspects of work, force,moment of inertia, shape center of ichnography, and the calculate of the inertia moment; mainly used the research method of from spcial to normal.

本文从功、力、转动惯量、平面图形的形心和惯性矩的计算这几个方面研究了定积分在物理学中的应用，主要运用了从特殊推广到一般的研究方法。

The results of lattice beam internal force calculated method based on double parameter groundsill model are more approach the experiment measured values because of consideration of the pass of shearing force in soil, and its calculated workloads are similar with the method of winkler elastic foundation. Besides, the thesis also discusses the moment of torque affected results on node stress situation and the correction of stress value at the bottom of cross node of lattice beam. Due to the repeat calculation of node area during internal force calculation, the stress value of the bottom of beam is lower, this may lead the calculated value unsafe, but the corrected stress value will more approach to practical situation.

对格构梁的内力计算提出基于双参数地基模型的格构梁内力计算方法，其计算结果表明，双参数地基模型上的格构梁内力由于考虑土中剪力的传递更加接近于试验实测值，其计算工作量与winkler弹性地基梁法相当，此外，文中还探讨了扭矩作用对格构梁节点受力情况的影响结果以及格构梁交叉节点底部的应力值的修正，由于内力计算过程中节点处的面积被重复计算，使得梁底应力偏小，可能导致计算结果的偏于不安全，修正后的应力值更接近于实际情况。

The year of 1948 was the moment of Kuomintang and the Communist Party's decisive battle, it was the deciding moment of military force, and it was the moment for different political forces of China.

1948年是国共决战的时刻，是武力决定胜负的时刻，也是中国社会各种政治势力抉择的时刻。

The moment of a force; the measure of a force's tendency to produce torsion and rotation about an axis, equal to the vector product of the radius vector from the axis of rotation to the point of application of the force.

转矩，力矩一种测量产生扭转和绕轴旋转趋势的力的单位，等于从旋转轴到力作用点的旋转矢量

We tested the knees at flexion angles of 0, 15, 30, 60, and 90with the following applied loads: 10 Nm varus moment, and 5 Nm external and internal rotational torques.21,22 To calculate the force applied in varus rotation testing, we took the desired moment (10 N.m) and divided this by the distance from the joint line to the point of force application in meters.

我们检测了施加力量10N.m的内翻运动和5N.m的外旋和内旋运动，各种运动的膝关节屈曲角度分别为0°、15°、30°、60°和90°。为了在内翻旋转试验时计算施加力，我们采用期望力矩(10M.m)，并将这种力矩分为从关节线到施加力点数米远的距离。

The results show that the air crossing pressure pulse magnitude of the container generated in the tunnel is 3.46 times that generated in open air when container flat wagon at the speed of 160 km/h passed by EMU moving at the same speed. Both the lateral force and overturning moment of the container train during the crossing induced in open air and tunnel are approximately proportional to the square of running speed of the passing train. The pressure of crossing side and uncrossing side for the container flat wagon is almost equal since the one-dimensional characteristic of pressure distributing induced in the tunnel is not faintish. Consequently, the value of the lateral force and overturning moment of the container train generated in open air is greater than that generated in the tunnel, about 1.1 times.

研究结果表明：集装箱平车以160 km/h的速度与动车组等速交会时，在隧道内会车时车载集装箱中部压力变化幅值是在明线会车时的3.46倍；在明线和隧道内会车时，集装箱列车受到的侧向力和侧滚力矩均与交会列车运行速度近似成平方关系；因隧道内压力分布一维特性较强，集装箱平车交会侧与非交会侧压力相差并不大，因此，在明线会车时集装箱平车受到的侧向力和侧滚力矩均比隧道会车时的大，大约是其1.1倍。

The kinematics speed was detected under different state of simulating the driving moment of hip joint and the damping moment of knee joint. The testing results indirectly built the dynamics relationship among the inertial force, damping force and the swing speed of the knee joint.

在模拟不同人体髋关节摆动驱动力和膝关节阻尼力的状态下，测量膝关节阻尼缸的运动速度，从而间接获得了假腿阻尼力、惯性力与膝关节摆动速度之间的动力学关系。

I put some current in side the surface and use two planes to cut the surface, then made two Amperian loops, then do integral on Theta.

里面是电流分布，然后我是用两个面把那一堆电流切开，做两个安培环，然后在THETA角上做积分。

Toucans|for this musical revue in Brazil.

知道吗 我以前去找能唱歌的鸟|为巴西的音乐剧找巨嘴鸟